PubMed Health⌕ Search

Biomedical subjects

E Monroe

Publications and source records attributed to E Monroe.

5 recordsLinked to original sources

Tacrolimus ointment for the treatment of atopic dermatitis in adult patients: part II, safety.

In two randomized, double-blind, multicenter studies, a total of 631 adult patients with moderate to severe atopic dermatitis applied tacrolimus ointment (0.03% or 0.1%) or vehicle twice daily for up to 12 weeks. The mean percent body surface area (%BSA) affected at baseline was 45%, and 56% of patients had severe atopic dermatitis. As previously reported, these studies showed that tacrolimus ointment was superior to vehicle for all efficacy parameters measured. This report focuses on the safety of tacrolimus ointment in these studies. The most common adverse events were the sensation of skin burning, pruritus, flu-like symptoms, skin erythema, and headache. Skin burning and pruritus were more common among patients with severe or extensive disease; these events were usually brief and were resolved during the first few days of treatment. Common adverse events with a significantly higher incidence in one or both of the tacrolimus ointment groups than in the vehicle group included skin burning, flu-like symptoms, and headache. More patients in the vehicle group discontinued the study because of an adverse event than in either of the tacrolimus ointment groups. There were no notable or consistent changes in any laboratory variables. Tacrolimus was not detected in 80% of blood samples collected. Measurable concentrations of tacrolimus were transitory and were not associated with adverse events. Tacrolimus ointment is a safe therapy for the treatment of adult patients with atopic dermatitis on the face, neck, or other body regions.

Adolescent↗

Treatment of common warts with high-potency (26%) salicylic acid.

Treatment of common warts with topical keratolytic solutions is generally estimated to result in cure rates of 60% to 80% in 12 weeks. Problems with keratolytic solutions include irritation of surrounding normal skin and poor patient compliance. A product containing 26% salicylic acid in a novel polyacrylic vehicle was evaluated in 27 patients and found to cure or provide much improvement in 22 (81%) after only two weeks of treatment. This rapid response was accompanied by a low incidence of irritation. The results of this study suggest that high-potency salicylic acid promotes prompt resolution of warts, which may enhance patient compliance.

Administration, Topical↗

Alumina as a filler for bone cement: a feasibility study.

A composite bone cement of Alcoa A-10 Alumina and very finely ground poly(methyl methacrylate) beads (PMMA) was fabricated. It was tested in an attempt to improve on the conventionally used pure PMMA bone cement. By knowing the densities of the powders and their volumes, the mass of each was calculated for the most efficient packing of PMMA and Al2O3 powders and a 65% PMMA: 35% Al2O3 ratio by weight composition was determined. This was tested, as well as the pure cement so comparisons could be made. Cylinders for the strength tests were also made of silane treated Al2O3. The compositions were tested for compressive and tensile strengths. The pure PMMA, composite and silane treated composite had compressive strengths of 79.64 +/- 13.0, 83.17 +/- 4.8, and 71.52 +/- 8.6 MPa and the tensile strengths were 6.69 +/- 0.6, 5.12 +/- 0.3, and 7.12 +/- 0.5 MPa respectively. Also the 65%-35% PMMA-Al2O3 composite required 64% less monomer for mixing than did the pure cement which is thought to be better for tissue healing. The maximum temperature attained from room temperature was 110 degrees-115 degrees C for both cements. The composite took 6.5 min longer to reach its peak temperature than did the pure cement. The bone cements were implanted for one week in a rabbit and both compositions seemed acceptable by the tissue.

Aluminum↗