PubMed Health⌕ Search

Biomedical subjects

E Sacher

Publications and source records attributed to E Sacher.

17 recordsLinked to original sources
PubMed2001

A tapping mode AFM study of collapse and denaturation in dentinal collagen.

OBJECTIVES: Tapping mode atomic force microscopy (AFM) was used to investigate the surface changes of collagen exposed to phosphoric acid treatment. We focus on denaturation and collapse following demineralization and exposure to air. METHODS: Unpolished dentin disks, obtained from freshly extracted human molars, were etched in 37% phosphoric acid for 15s, rinsed ultrasonically and gently blotted with soft paper; the specimens were then continuously observed using tapping mode AFM. RESULTS: Immediately after the removal of bulk water, the surface consisted of a porous network of banded collagen fibrils, having periodicities of 67nm. After approximately 8min of subsequent air-drying, the spacing between fibrils was lost, and the surface was observed to consist of a dense array of closely spaced fibrils. The banding periodicity was still observable. SIGNIFICANCE: The air drying of etched dentin results in the collapse of the collagen network, but not in the denaturation of the collagen fibrils. This study indicates that collapse and denaturation are separate phenomena. It further shows that water loss occurs rapidly, and disrupts the native conformation of the collagen network. This would have adverse effects on adhesion.

Acid Etching, Dental↗
PubMed2001

A photoacoustic FTIRS study of the chemical modifications of human dentin surfaces: II. Deproteination.

This work focuses on the chemical alterations occurring on the dentin surface on treatment with sodium hypochlorite (NaOCl), a known deproteinating agent. In addition, sequential treatment with both acid and NaOCl are characterized. Modifications are evaluated using photoacoustic FTIR (PA-FTIRS), a surface-sensitive spectroscopy. Spectra of NaOCl-treated dentin samples show a slow and heterogeneous removal of its organic phase, leaving calcium hydroxyapatite and carbonate apatite unchanged. Spectra of this deproteinated surface resemble those of apatites synthesized at low temperatures and having very high-surface areas. A combined sequential 2-min treatment of dentin with both maleic acid and NaOCl indicates that this treatment can produce a surface region which is neither significantly demineralized nor deproteinated. This sequential treatment can be used to remove the smear layer and restore the dentin surface to its natural composition.

Acid Etching, Dental↗
PubMed2001

A photoacoustic FTIRS study of the chemical modifications of human dentin surfaces: I. Demineralization.

Acids are used to modify the structure and composition of dentin surfaces to improve bonds formed with resins. The purpose of this work is to investigate such chemical modifications using the surface-sensitive technique photoacoustic Fourier transform infrared spectroscopy (PA-FTIRS). Spectra of acid-treated samples (citric, maleic, nitric, and phosphoric at pH = 1.0) were recorded at various time intervals. Analysis of these spectra indicates a gradual increase in sample surface area with treatment time. A decrease of the bands associated with calcium hydroxyapatite (HAP) and carbonate apatite inherent to the mineral phase of dentin are also observed. A comparison of spectra of samples treated for 2 min with each acid also reveals that maleic and phosphoric acids remove more HAP than citric acid. We conclude that citric acid may cause the formation of precipitates at the etching front which inhibit etching.

Acids↗
PubMed1999

Field emission in-lens SEM study of enamel and dentin.

This investigation used field emission in-lens scanning electron microscopy (FEISEM) for the study of tooth surfaces, with particular reference to adhesive bonding and acid conditioning. Dentin wafers with an intact enamel periphery were treated by either ethylenediaminetetraacetic acid (EDTA) (pH 7.4) or phosphoric acid (pH 0.7). The samples were then fixed, sequentially dehydrated in alcohol, and either air- or critical point-dried. After coating, surfaces were examined by FEISEM. For enamel, intraprismatic crystals were clearly recognizable, with the crystals showing both a longitudinal and parallel orientation to the long axis of the prisms. For dentin, the surface ultrastructure (mineral crystals and collagen banding) for the both untreated and treated samples was observed. Fine structures measuring on the order of 6 nm were also observed on samples treated by EDTA. We conclude that FEISEM can routinely provide high-resolution images of enamel and dentin, and that it has the capability of revealing the defined distribution of crystals and collagen fibers in dental tissues.

Acid Etching, Dental↗
PubMed1998

Moisture-dependent renaturation of collagen in phosphoric acid etched human dentin.

We used atomic force microscopy (AFM) to investigate the effects of acidic and aqueous treatments on human dentin. Two basic points were determined: the first is the ability of AFM to discriminate the effect of phosphoric acid (pH approximately equal to 1) on polished dentin, and the second is the demonstrable effect of moisture on fibrous collagen structure. AFM images confirmed that the polishing process led to the removal of both smear layer and smear plugs. Our AFM study of undried dentin, which was then acid treated and kept moist, revealed substantial morphological changes at the dentin surface. Collagen fibers, having a characteristic periodicity of 67 nm, were imaged in situ for the first time; these structures were absent in dentin treated by phosphoric acid and subsequently vacuum dried, even after prolonged reimmersion in water. The AFM technique permitted us to demonstrate the important roles that moisture and etching play in the determination of the structure of collagen fibrils. Such structure may also play an important role in the diffusibility of subsequently applied dental adhesion systems.

Collagen↗
PubMed1979

[Interactions between macromolecular adjuvants and drugs. Part 17: On the effect of macromolecular adjuvants on the dissolution rate of chlorpromazine from dosage forms (author's transl)].

The determination of the dissolution rate of chlorpromazine from tablets and triturations containing macromolecular adjuvants by means of a modification of the flow-through type cell according to Langenbucher evidenced a decrease in the dissolution rate produced by polyvinylpyrrolidone, methyl-cellulose and hydroxyethyl-cellulose. It was found that the decrease in the dissolution rate is not due to the confirmed, relatively marked tendency of chlorpromazine to form complexes, but to gel formation.

Adjuvants, Pharmaceutic↗