Biomedical subjects

Esther Turiel

Publications and source records attributed to Esther Turiel.

6 recordsLinked to original sources

PubMed2005

Study of the evolution and degradation products of ciprofloxacin and oxolinic acid in river water samples by HPLC-UV/MS/MS-MS.

The results of a degradation study of the (fluoro)quinolone antibiotics ciprofloxacin and oxolinic acid in river water samples are presented in this paper. The decomposition of these compounds at ambient temperature was monitored during five months by HPLC-UV, and two consecutive degradation processes (photo- and bio/chemical-degradation) were observed in both cases although with different degradation rates. Ciprofloxacin was completely degraded after 3 months whereas 80% of oxolinic acid remained unaltered after five months of storage. The analysis of the degradation compounds formed was carried out using MS and tandem MS-MS, allowing the identification of four new ciprofloxacin transformation products not previously described in the literature. Possible degradation pathways for this antibiotic in river water are proposed.

Anti-Infective Agents↗

PubMed2005

Determination of quinolones and fluoroquinolones in hospital sewage water by off-line and on-line solid-phase extraction procedures coupled to HPLC-UV.

In this work, the development of two solid-phase extraction procedures (off-line and on-line formats) for the identification and quantification of several (fluoro)quinolones in hospital sewage water by HPLC-UV is described. Both procedures are based on the use of C18 and anion exchange (SAX) sorbents for the preconcentration and clean-up steps, respectively, and all variables influencing both steps were optimised. In the off-line format, after its pH was adjusted to 2.5, sample was preconcentrated on a C18 cartridge and eluted with 4 mL of methanol/ammonia (94/6). The methanolic extract must be diluted up to 10 mL with water to allow quantitative retention of the analytes on the SAX cartridge. In the on-line format, the addition of 2.5% of NH4Cl to the sewage water sample (pH = 2.5) was necessary to increase the breakthrough volumes of the analytes in the C18 precolumn. Quantitative transfer of the (fluoro)quinolones from the C18 precolumn to the SAX precolumn was accomplished by pumping 2 mL of a mixture methanol/water (40/60, pH = 9.2) at 2 mL min(-1). Elution of the analytes from the SAX precolumn by means of the chromatographic mobile phase required the inclusion of an additional isocratic step at the beginning of the gradient program. Both off-line and on-line solid phase extraction procedures coupled to HPLC-UV were applied to the analysis of a sewage water sample collected in the sewer system at the output of the St Dimphna Hospital (Geel, Belgium). The fluoroquinolone ciprofloxacin was found in this sample and quantified at 5.8 +/- 0.4 microg L(-1) (off-line method) and 5.6 +/- 0.5 microg L(-1) (on-line method). The analysis of spiked samples containing the seven (fluoro)quinolones studied provided quantitative recoveries in all cases with low RSD values (from 6 to 12%), and all the analytes could be identified by means of their UV spectra with match factors varying from 950 to 985 depending on the (fluoro)quinolone.

Chromatography, High Pressure Liquid↗

PubMed2005

Molecular imprinting technology in capillary electrochromatography.

Molecularly imprinted polymers (MIPs) are tailor-made synthetic polymers with a predetermined selectivity for a given analyte, or group of structurally related compounds, that make them ideal materials for use as stationary phases in affinity chromatography. However, extensive peak broadening and tailing, especially of the more retained compound (normally the template) are often observed. Thus, huge efforts have been made during recent years to use MIPs in capillary electrochromatography, which is inherently a more efficient chromatographic technique than conventional HPLC. Accordingly, this paper gives an overview of the attempts carried out in the recent past to improve the chromatographic performance of MIPs in capillary electrochromatography as well as more recent applications. It is concluded that MIPs are very promising materials for use as selective stationary phases in CEC.

Journal Article↗

PubMed2004

Stability of fluoroquinolone antibiotics in river water samples and in octadecyl silica solid-phase extraction cartridges.

Intensive use of antibiotics in human and veterinarian medicine and in industrial farming (food additives) has resulted in the transport of important quantities of the active ingredients to environmental waters. Environmental analysis usually requires sample storage for certain periods of time and, consequently, it is of great importance to know the stability of antibiotics in these kinds of sample. Thus, in this work the stability in river water of oxolinic acid (Oxo) and ciprofloxacin (Cip), taken as representatives of fluoroquinolone and quinolone antibiotics respectively, has been evaluated. The stability of these compounds in river water has been studied both in containers and on C(18) solid-phase extraction cartridges (SPE) under different storage conditions (time, light, and temperature). Data analysis revealed that Cip and Oxo have different degradation profiles with different degradation kinetics in river water. It was also concluded that these antibiotics are stable both in the containers and on SPE cartridges for at least 2 weeks at ambient temperature, and stability can be increased substantially if samples are stored at low temperatures (4 and -18 degrees C).

Anti-Bacterial Agents↗

PubMed2003

Trace enrichment of (fluoro)quinolone antibiotics in surface waters by solid-phase extraction and their determination by liquid chromatography-ultraviolet detection.

A new and simple analytical methodology for the simultaneous analysis of acidic and zwitterionic (fluoro)quinolones in surface waters at trace concentration level is presented. The method is based on the preconcentration of these analytes by a solid-phase extraction procedure and their subsequent quantification by liquid chromatography using ultraviolet detection. The breakthrough volumes of the selected (fluoro)quinolones in four different sorbents--C18, styrenedivinylbenzene (SDB), C18-cation-exchange and SDB-cation-exchange--have been evaluated and varied between 25 and 150 ml depending on the antibiotic and the sorbent used. An exhaustive study of the influence of sample pH on the preconcentration step has been carried out in order to find a suitable procedure for extraction of acidic and zwitterionic FQs in one single step. Under optimum conditions, it was possible to percolate up to 250 ml of water solution onto both C18 and SDB-cation-exchange cartridges with quantitative recoveries for all the analytes tested. However, matrix components of the surface water samples analysed negatively affected the recoveries of the analytes in the SDB-cation-exchange cartridge and thus, C18 cartridges were finally selected for the analysis of the (fluoro)quinolones in lake and river water. The limits of detection achieved with this procedure varied between 8 and 20 ng l(-1) proving its suitability for the determination of the (fluoro)quinolones in water samples at a realistic environmental concentration level.

Anti-Bacterial Agents↗

PubMed2003

Assessment of the cross-reactivity and binding sites characterisation of a propazine-imprinted polymer using the Langmuir-Freundlich isotherm.

In this paper, the Langmuir-Freundlich isotherm is used to model the interaction of several triazines (desethylatrazine, desisopropylatrazine, simazine, atrazine, propazine and prometryn) with a propazine-imprinted polymer and to explain the observed cross-reactivity. Different rebinding experiments (each herbicide alone or all together in a mixture) were carried out and the experimental binding isotherms were fitted to the Langmuir-Freundlich isotherm. The fitting coefficients obtained (total number of binding sites, mean binding affinity and heterogeneity index) allowed the description of the kind of binding sites present in the imprinted polymer under study. It was concluded that the recognition mechanism was mainly governed by the molecular size although slight differences in the molecular structure may also play an important role. The obtained results suggest that the use of this new methodology can open new pathways for understanding how molecular recognition in imprinted polymers takes place.

Journal Article↗