Biomedical subjects

F Castells

Publications and source records attributed to F Castells.

6 recordsLinked to original sources

PubMed2007

Human intake fractions of pesticides via greenhouse tomato consumption: comparing model estimates with measurements for Captan.

Human intake due to pesticide residues in food commodities can be much higher than those related to water consumption and air inhalation, stressing the importance to correctly estimate pesticide uptake into plants and predict subsequent intake by humans. We calculated the human intake fraction of captan via tomato consumption taking into account the time between pesticide application and harvest, the time between harvest and consumption, the absorption of spray deposit on plant surfaces, transfer properties through the cuticle, degradation inside the plant and loss due to food processing. Human population intake fractions due to ingestion were calculated for complete, washed and peeled tomatoes. The calculated intake fractions were compared with measurements derived from an experimental setup in a Mediterranean greenhouse. The fraction of captan applied in the greenhouse as plant treatment that eventually is ingested by the human population is on average 10(-2)-10(-5), depending on the time between pesticide application and ingestion of tomatoes and the processing step considered. Model and experimentally derived intake fractions deviated less than a factor of 2 for complete and washed tomatoes and a factor of 3 for peeled tomatoes. Intake fractions due to air inhalation and consumption of drinking water are expected to be significantly lower (5-9 orders of magnitude) than those induced by the intake of tomatoes in this case study.

Captan↗

PubMed2005

Estimation of atrial fibrillatory wave from single-lead atrial fibrillation electrocardiograms using principal component analysis concepts.

A new method for the assessment of the atrial fibrillatory wave (AFW) from the ECG is presented. This methodology is suitable for signals registered from Holter systems, where the reduced number of leads is insufficient to exploit the spatial information of the ECG. The temporal dependence of the bio-electrical activity were exploited using principal component analysis. The main features of ventricular and atrial activity were extracted, and several basis signals for each subspace were determined. Hence, the estimated (AFW) are reconstructed exclusively from the basis signals that formed the atrial subspace. Its main advantage with respect to adaptive template subtraction techniques was its robustness to variations in the QRST morphology, which thus minimised QRST residua. The proposed approach was first validated using a database of simulated recordings with known atrial activity content. The estimated AFW was compared with the original AFW, obtaining correlation indices of 0.774 +/- 0.106. The suitability of this methodology for real recordings was also proven, though its application to a set of paroxysmal AF ECGs. In all cases, it was possible to detect the main frequency peak, which was between 4.6 Hz and 6.9 Hz for the patients under study.

Algorithms↗

PubMed2005

Spatiotemporal blind source separation approach to atrial activity estimation in atrial tachyarrhythmias.

The analysis and characterization of atrial tachyarrhythmias requires, in a previous step, the extraction of the atrial activity (AA) free from ventricular activity and other artefacts. This contribution adopts the blind source separation (BSS) approach to AA estimation from multilead electrocardiograms (ECGs). Previously proposed BSS methods for AA extraction--e.g., independent component analysis (ICA)--exploit only the spatial diversity introduced by the multiple spatially-separated electrodes. However, AA typically shows certain degree of temporal correlation, with a narrowband spectrum featuring a main frequency peak around 3.5-9 Hz. Taking advantage of this observation, we put forward a novel two-step BSS-based technique which exploits both spatial and temporal information contained in the recorded ECG signals. The spatiotemporal BSS algorithm is validated on simulated and real ECGs from a significant number of atrial fibrillation (AF) and atrial flutter (AFL) episodes, and proves consistently superior to a spatial-only ICA method. In simulated ECGs, a new methodology for the synthetic generation of realistic AF episodes is proposed, which includes a judicious comparison between the known AA content and the estimated AA sources. Using this methodology, the ICA technique obtains correlation indexes of 0.751, whereas the proposed approach obtains a correlation of 0.830 and an error in the estimated signal reduced by a factor of 40%. In real ECG recordings, we propose to measure performance by the spectral concentration (SC) around the main frequency peak. The spatiotemporal algorithm outperforms the ICA method, obtaining a SC of 58.8% and 44.7%, respectively.

Algorithms↗

PubMed2004

Comparison of toxicological impacts of integrated and chemical pest management in Mediterranean greenhouses.

The goal of this paper is to assess the relative impacts of pest-control methods in greenhouses, based on current LCA tools. As a case study, the relative impacts of two tomato production methods, chemical pest management (CPM) and integrated pest management (IPM), are assessed. The amount of the active ingredients applied, the fate of the ingredients in the various greenhouse and environmental compartments, the human exposure routes via the various compartments and the inherent toxicity of the ingredients were taken into account in the relative impact calculations. To assess the importance of model selection in the assessment, pesticide-specific fate and exposure factors for humans and aquatic and terrestrial ecosystems, used to aggregate pesticide emissions, were calculated with two different models: (1) the USES-LCA model, adapted in order to calculate the pesticide transfer from greenhouse air and soil to fruits, and (2) the empirical model critical surface time (CST). Impact scores have in general shown a higher level of potential contamination in greenhouses treated with CPM compared to IPM (a factor of 1.4 to 2.3). Relative impacts have been shown highly dependent on the selection of specific pesticides and crop stage development at the moment of pesticide application. This means that both CPM and IPM could be improved by a careful selection of pesticides. In order to improve the relative impact calculations, future research in pesticide transfer to food will be necessary.

Agriculture↗

PubMed2004

Environmental engineering education in Spain.

There is a growing demand for engineers and technologists who show multidisciplinary expertise to deal with environmental issues. As a result of this demand, most countries are adapting their old university programs on environmental engineering education. In Spain an official environmental engineering degree does not yet exist, but the Council of Universities is working to present a proposal, based on Bologna agreement concepts. The paper summarizes not only the future perspectives of environmental engineering education in Spain, but also the evolution of the approach during the last decades, which includes the role of the private initiative, the environmental sciences degree, and the intensification in different traditional engineering degrees. Finally, the paper briefly details and compares the syllabus developed in the only four Spanish universities where environmental engineering is offered as a non-official post-graduate course lasting two years.

Curriculum↗

PubMed2000

Framework for the environmental damage assessment of an industrial process chain.

On the basis of the life cycle approach, a framework for the assessment of the environmental damages generated by an industrial process chain is established. In order to consider all the processes of the life cycle, a methodology is developed based on an eco-matrix formed by chemical process eco-vectors containing all their environmental loads. To perform the impact assessment, environmental damage indicators are estimated in the most accurate way possible for each process. For this, site-specific evaluation is carried out applying damage functions and, hence, for each damage indicator, a damage matrix is obtained. In order to make the methodology more practical, options like dominance analysis are presented. Because of the large number of environmental loads, the focus is on the priority pollutants and then the final estimations are done with one indicator per safeguard subject. The damage indicators selected in this paper are damage costs, ecological damage parameter (both site-specific) and global damage estimates. As for the verification of the methodology, a study has been carried out based on the life cycle of the electricity produced by a municipal waste incinerator.

Animals↗