Biomedical subjects

F Dilek Sanin

Publications and source records attributed to F Dilek Sanin.

5 recordsLinked to original sources

PubMed2006

An investigation of heavy metal biosorption in relation to C/N ratio of activated sludge.

The effect of C/N ratio of activated sludge on heavy metal biosorption was investigated. Three sets of semi-continuous reactors with different feed C/N ratios (9, 21 and 43 mg COD/mg TKN) were set up. Sorption equilibrium tests have indicated that the biosorptive capacity of activated sludge was highly dependent on metal species and the C/N ratio. The increase in C/N ratio resulted in an increase in the Cd(II) sorption capacity of activated sludge whereas it decreased the Cu(II) sorption capacity. As for Zn(II), a different behavior was observed such that, the highest and lowest capacities have occurred at C/N ratio of 21 and 43, respectively. For Ni(II) biosorption, isotherm tests produced greatly scattered data; so, it was not possible to obtain any plausible result to indicate the relationship between maximum adsorptive capacity and C/N ratio. The accompanying release of Ca(II) and Mg(II) ions and also carbohydrates into the solution during biosorption have indicated that ion exchange mechanism was involved however, was not the only mechanism during the sorption process.

Adsorption↗

PubMed2006

Use of Fenton oxidation to improve the biodegradability of a pharmaceutical wastewater.

The applicability of Fenton's oxidation to improve the biodegradability of a pharmaceutical wastewater to be treated biologically was investigated. The wastewater was originated from a factory producing a variety of pharmaceutical chemicals. Treatability studies were conducted under laboratory conditions with all chemicals (having COD varying from 900 to 7000 mg/L) produced in the factory in order to determine the operational conditions to utilize in the full-scale treatment plant. Optimum pH was determined as 3.5 and 7.0 for the first (oxidation) and second stage (coagulation) of the Fenton process, respectively. For all chemicals, COD removal efficiency was highest when the molar ratio of H(2)O(2)/Fe(2+) was 150-250. At H(2)O(2)/Fe(2+) ratio of 155, 0.3M H(2)O(2) and 0.002 M Fe(2+), provided 45-65% COD removal. The wastewater treatment plant that employs Fenton oxidation followed by aerobic degradation in sequencing batch reactors (SBR), built after these treatability studies provided an overall COD removal efficiency of 98%, and compliance with the discharge limits. The efficiency of the Fenton's oxidation was around 45-50% and the efficiency in the SBR system which has two reactors each having a volume of 8m(3) and operated with a total cycle time of 1 day, was around 98%, regarding the COD removal.

Aerobiosis↗

PubMed2006

Enzymatic extraction of activated sludge extracellular polymers and implications on bioflocculation.

This study examines enzyme hydrolysis, a mild, effective, but a rarely used method of extracellular polymer extraction, in removing polymers from mixed culture activated sludge flocs. Two carbohydrate specific enzymes (alpha-amylase and cellulase) and a protein specific enzyme (proteinase) are used during the study. First, the kinetic aspect is investigated, then enzyme dose optimization is carried out on laboratory grown activated sludge samples cultured at solids retention times (SRT) of 4 and 20 days. A more commonly used cation exchange resin (CER) extraction technique is also employed for comparison purposes. Results indicate that the extraction of extracellular polymers by enzymes is a rather quick process reaching equilibrium within only a few hours. As the doses of enzymes are increased, the extracted polymer quantities increase up to a certain dose, beyond which not much extraction is observed. The method does not cause any significant cell lysis as measured by the viable cell counts. Carbohydrate-hydrolyzing enzymes extract small amount of proteins along with the carbohydrates and protein-hydrolyzing enzyme extracts some carbohydrates together with the proteins, indicating that proteins and carbohydrates exist bound to each other in the extracellular polymer network of sludge. Enzyme extraction generally gives a lower estimate of polymers compared to the CER method, but correctly detects the trends in the polymer quantity.

Cellulase↗

PubMed2006

Phosphorus defficiency and sludge bulking.

Separation by settling is one of the most troublesome stages of an activated sludge process. A decrease in the efficiency of separation of microbial biomass from the treated effluent causes a decrease in the overall efficiency of the treatment plant. One of the most common problems in activated sludge systems to negatively influence the settleability is sludge bulking which can be defined as non-settling situation of microbial mass. The main objective of this study is to find out the effect of phosphorus deficiency on bulking of activated sludge. In order to achieve this aim, the effects of a strictly phosphorus limited environment was investigated by running 6 semi-continuous activated sludge reactors. Since the specific aim of the study is to identify the effects of magnesium and calcium ions on sludge bulking in a phosphorus deficient medium, 3 different magnesium and calcium concentrations (5, 10, 20 meq l(-1)) were studied. Laboratory scale reactors were fed with synthetic wastewater and operated at a sludge age of 8 days. Results showed that, phosphorus deficiency caused sludge bulking. Sludge samples examined under microscope showed that the floc structures from reactors fed with different cations are significantly different. To identify the differences, a series of chemical analyses were conducted on the sludge samples. In addition to that, sludge volume index (SVI) values were monitored on a daily basis. Next, the concentration of phosphorus in the feed medium was increased in two separate steps and the possibility to cure the sludge bulking problem was investigated. It was found that bulking of activated sludges due to phosphorus deficiency could be cured by the addition of phosphorus. For phosphorus deficient bulking in relation to the cations present in the system some mechanisms are suggested.

Biomass↗

PubMed2004

A study of the dental solid waste produced in a school of dentistry in Turkey.

Dental wastes are regulated under medical waste control regulations in most countries. Even though the quantity of hazardous wastes in dental solid wastes is a small proportion, there is still cross infection risk and potential danger for environment associated with mismanaged wastes. For this reason, knowledge of waste composition and development of proper management alternatives are necessary. In this study, the composition of solid wastes coming from eight clinics of the dental school of a University hospital in Turkey is examined. Although the waste has some variations between the two samplings, the general picture is such that the major components remain pretty much the same (in terms of %) for a fixed clinic. The composition of waste changes from one clinic to the other as expected. However, one can deduce from the data obtained that at about 35%, rubber gloves constitute close to the half of the total solid waste in almost all the clinics. Other major component is paper forming approximately 30% of the solid waste. In general, total waste coming from the clinics is related with the number of procedures conducted on patients at the clinics. Only a small fraction of the waste is hazardous indicating that at Hacettepe University School of Dentistry, hazardous waste collection rules are obeyed in most of the times.

Dental Waste↗