Biomedical subjects

F Martínez-López

Publications and source records attributed to F Martínez-López.

4 recordsLinked to original sources

PubMed2005

Short- and long-range topological correlations in two-dimensional aggregation of dense colloidal suspensions.

We have studied the average properties and the topological correlations of computer-simulated two-dimensional (2D) aggregating systems at different initial surface packing fractions. For this purpose, the centers of mass of the growing clusters have been used to build the Voronoi diagram, where each cell represents a single cluster. The number of sides (n) and the area (A) of the cells are related to the size of the clusters and the number of nearest neighbors, respectively. We have focused our paper in the study of the topological quantities derived from number of sides, n , and we leave for a future work the study of the dependence of these magnitudes on the area of the cells, A . In this work, we go beyond the adjacent cluster correlations and explore the organization of the whole system of clusters by dividing the space in concentric layers around each cluster: the shell structure. This method allows us to analyze the time behavior of the long-range intercluster correlations induced by the aggregation process. We observed that kinetic and topological properties are intimately connected. Particularly, we found a continuous ordering of the shell structure from the earlier stages of the aggregation process, where clusters positions approach a hexagonal distribution in the plane. For long aggregation times, when the dynamic scaling regime is achieved, the short- and long-range topological properties reached a final stationary state. This ordering is stronger for high particle densities. Comparison between simulation and theoretical data points out the fact that 2D colloidal aggregation in the absence of interactions (diffusion-limited cluster aggregation regimen) is only able to produce short-range cluster-cluster correlations. Moreover, we showed that the correlation between adjacent clusters verifies the Aboav-Weaire law, while all the topological properties for nonadjacent clusters are mainly determined by only two parameters: the second central moment of number-of-sides distribution mu(2) = sumP (n) (n-6)(2) and the screening factor a (defined through the Aboav-Weaire equation). We also found that the values of mu(2) and a calculated for two-dimensional aggregating system are related through a single universal common form a proportional to mu2(-0.89), which is independent of the particle concentration.

Journal Article↗

PubMed2004

Spontaneous formation of mesostructures in colloidal monolayers trapped at the air-water interface: a simple explanation.

The spontaneous formation of loosely bound ordered aggregates, foam, voids, chains, striations, and loops (see Figure 1a), called mesostructures hereafter, has been observed in colloidal monolayers trapped at the air-water interface. The distance between particles in these mesostructures is of the order of the particle radius (micrometers), implying that the colloidal interaction potential has a minimum at such distances, which could induce the phase separation of colloidal monolayers in dense and dilute regions. This is at odds with the accepted theory (Derjaguin-Landau-Verwey-Overbeek (DLVO)) of colloidal interactions, which predicts a secondary minimum at distances of nanometers between pairs of interacting particles. Moreover, the introduction of capillary, hydrophobic, and dipolar interactions between particles in an extended DLVO theory is not able to explain the spontaneous formation of mesostructures either. Recently, a great deal of effort has focused on understanding the mechanism behind the phenomenon of long-range attraction between colloidal particles confined in interfaces. In particular, this attraction has been employed to explain the spontaneous formation of mesostructures. Here, we show that the appearance of our mesostructures is due to the contamination of colloidal monolayers by silicone oil (poly(dimethylsiloxane)), which arises from the coating of the needles and syringes used to deposit and spread the particle solution at the air-water interface. The difference in the interfacial tension of water and silicone oil accounts for the formation of the experimentally observed mesostructures.

Journal Article↗

PubMed2002

The effect of the salt concentration and counterion valence on the aggregation of latex particles at the air/water interface.

An experimental study on colloidal aggregation in two dimensions is presented. This study shows that a high amount of electrolyte concentration is necessary to screen the particle interactions and to induce the aggregation process. Our results indicate that the stability of the colloidal particles, with a diameter of 735 nm, increases when they are trapped at the air-water interface. The reason for this stability is the existence of long-range repulsive interactions between the external parts of the particles that are propagated at the air phase. The subphase electrolyte concentration that separates the slow aggregation rate region from the fast aggregation rate region, the critical coagulation concentration (C.C.C.), has been determined for counterions with a different valence. Two regimes can be distinguished: at low salt concentration the aggregation process becomes slower and the aggregation is reaction limited. At high ionic strength the repulsive interactions between the immersed part of the particles are very weak and the aggregation rate tends to grow. However, because of the aerial repulsive interactions, pure diffusion-limited cluster aggregation is never found.

Journal Article↗

PubMed2000

Colloidal Interaction at the Air-Liquid Interface.

In this paper, we propose a model to analyze the stability of colloidal particles at the air-liquid interface. The proposed model for the colloidal particle interaction considers DLVO interactions and capillary, hydrophobic, and dipolar interactions between the particles. Typical values from the literature were assigned to most parameters included in the model. Numerical computation revealed the most important parameter in determining the total interaction is the density of dipoles at the external surface of the particles. We have found significant differences for the pair potential between hydrophobic and hydrophilic particles. Hydrophobic particles must aggregate in a principal minimum of the interaction potential curve while hydrophilic particles aggregate in a secondary minimum. Copyright 2000 Academic Press.

Journal Article↗