PubMed Health⌕ Search

Biomedical subjects

F Nielloud

Publications and source records attributed to F Nielloud.

4 recordsLinked to original sources

Benzophenone-3: rapid prediction and evaluation using non-invasive methods of in vivo human penetration.

The study described in this paper constitutes a practical assay system to evaluate in vivo drug penetration using two complementary non-invasive methods. An electrical capacitance test was first applied to the skin on the forearm to evaluate the hydration of the skin, and check the integrity of the stratum corneum. In the first step, the percentage absorption was measured using an occlusive and difference method; following benzophenone-3 application any residual formulation was washed off and the amount removed analyzed. In the second step, the tape stripping method-a useful procedure for selectively removing the skin's outermost layer, the stratum corneum, and measuring the stratum corneum adsorption-was performed. Under these conditions the human skin permeation of this UV-filter over four hours was near to 35% of the applied dose with the occlusive method. The amount of topically applied benzophenone-3 found in the stratum corneum after 30 min exposure using the stripping procedure was evaluated at 4% to the applied dose.

Adult↗

Effect of the addition of oxybenzone or octyl-methoxycinnamate on particle size of submicron emulsions.

The formulation of sunscreen products requires understanding of the solubilization of these products in different vehicles to obtain aesthetic preparations and to evaluate long-term stability. For this study, two different ultraviolet (UV) filters were selected: oxybenzone (powder) and octyl-methoxycinnamate (liquid). First, the solubility of these UV filters was tested using a three-component simplex-centroid design strategy. The mixtures were prepared with three oily phases used in this field of cosmetics: liquid paraffin, isopropyl myristate, and coconut oil. A phase diagram method was used to carry out a systematic study of submicron oil-in-water emulsions. Phase diagrams were produced by diluting fixed binary mixtures with water. The surfactant consisted of polyoxyethylene-20-sorbitan monostearate/sorbitan monostearate (50/50, w/w). The oily phase contained equal quantities of each oil studied. From this water/surfactant/oil ternary system, we selected two reference emulsions with receptively 75/5/20 and 68/7/25 proportions. Photon correlation spectroscopy (PCS) was used to investigate the influence of these two UV filters at several concentrations on droplet size and distribution of the oil droplets in the material. All emulsions were stored and checked every month for 6 months.

Benzophenones↗

[Systemic emulsions. 2. Use of different methods of formulation: the effect of essential oils of thyme on stability].

As part of an ongoing investigation on emulsifying techniques, we studied the influence of different essential oils from Thymus vulgaris on emulsion stability. All four chimiotypes tested (geraniol, linalol, carvacrol, and thymol) caused a marked decrease in stability. This instability cannot be explained by a change in the hydrophilic lipophilic balance since the HLBc of the new oil phase (essential oil + paraffine oil) was not significantly different from that of paraffine alone.

Drug Compounding↗

[Emulsion systems. I. Comparison of different formulation methods].

This paper examines different technics of emulsifying systems formulation: those using the research of HLBc and those using the phase diagram. The comparison of these two methods of formulation permits us to describe one method looking for the HLBc of each proportions of the phase diagram. So a volume is determined allowing to choose more securely the surfactants proportions and also to end on surer formulation.

Drug Compounding↗