Biomedical subjects

F Vegliò

Publications and source records attributed to F Vegliò.

7 recordsLinked to original sources

PubMed2006

Micellar enhanced ultrafiltration for arsenic(V) removal: effect of main operating conditions and dynamic modelling.

In this work arsenic removal by micellar enhanced ultrafiltration (MEUF) was investigated using cetylpyridinium chloride (CPC) in ceramic membrane apparatus. Permeability tests and discontinuous diafiltration tests were performed in different operating conditions to evaluate the effect of membrane pore size (20 and 50 nm), transmembrane pressure, pH, surfactant concentration (1-3 mM), and arsenic concentration (10-40 mg/L) on permeate flux decline, arsenic, and CPC rejections. These preliminary experimental results showed that a ceramic membrane with large pore size allows treament of high fluxes of concentrated arsenic-bearing solutions even by using low surfactant concentrations. Arsenic concentration in the permeate was at the 1 ppm level, with feed As concentrations (10 ppm) that are larger than those generally used in MEUF studies and with CPC amounts that are lower than the usual ones. In addition, operating conditions adopted in these tests obtained CPC concentrations in the permeate always lower than its critical micellar concentration (0.9 mM). Dynamic simulations of discontinuous two-step diafiltration tests allowed a simple and adequate representation of the performance of the process especially for 1 mM CPC, while discrepancies for 2.5 mM CPC level denoted complex interactions between CPC and As.

Arsenic↗

PubMed2005

Ionic strength effect on copper biosorption by Sphaerotilus natans: equilibrium study and dynamic modelling in membrane reactor.

Biosorption of copper by Sphaerotilus natans in different conditions of ionic strength and pH was studied by performing sorption tests in batch and membrane reactors. Equilibrium batch tests evidenced the negative effect of ionic strength and the positive effect of pH on biosorption performances: the highest determined value for copper specific uptake, q, was about 60 mg/g at pH 6 and about 15 mg/g at pH 4. A competitive equilibrium model was successfully fitted to experimental data at different ionic strength levels to account for copper-sodium competition. In membrane reactor tests, experimental profiles of copper concentration in the permeate vs. time did not evidence a significant effect of ionic strength at low pH values (4 and 5). On the other hand a more remarkable effect of ionic strength on copper concentration in the permeate was observed at pH 6. Experimental profiles of continuous biosorption in the membrane reactors were successfully simulated by developing a dynamic model accounting for Cu-Na competition and for binding ability of cells fragments.

Adsorption↗

PubMed2005

Development of a reliable alkaline wastewater treatment process: optimization of the pre-treatment step.

Alkaline waters produced by caprolactam plants polymerizing the fibres of nylon-6 are characterized by a very high alkalinity, salinity and COD values, in addition to the presence of recalcitrant organic molecules. These characteristics make alkaline wastewaters very difficult to treat; so the development of the suitable sequence to carry out in a depuration process appears of great interest. The proposed general process consists of three main steps: first, pre-treatment for the acidification of the polluted stream, second, a successive extraction of the bio-recalcitrant compound (noted as cycloexanecarboxysulphonic acid (CECS)) and a final biological treatment. In particular, this paper deals with the pre-treatment step: it consists of an acidification process by means of sulphuric acid with the concomitant precipitation of black slurries in the presence of different substances, such as solvents, CaCl2, bentonite, several flocculants and coagulants. The aim of this study is to set an experimental procedure, which could minimize fouling problems during sludge filtration. The use of additives like bentonite seems to give the best results, because it allows good COD reductions and a filterable precipitate, which avoids excessive fouling problems of the experimental apparatus.

Acetates↗

PubMed2003

Metal speciation and pH effect on Pb, Cu, Zn and Cd biosorption onto Sphaerotilus natans: Langmuir-type empirical model.

Biosorption data of lead, copper, zinc and cadmium onto Sphaerotilus natans at different equilibrium pH (3-5 units) were here reported and analysed. Experimental results outlined the positive effect of pH increase on pollutant uptake and also the biomass affinity series (Pb > Cu > Zn > Cd) reflecting the hydrolytic properties of metals. An original empirical model was proposed to represent the effect of pH on heavy metal biosorption inserting q(max) vs. pH empirical functions into the classical Langmuir isotherm.

Adsorption↗

PubMed2003

Sorption of copper by olive mill residues.

A study on olive mill residues (OMR) as copper adsorbing material is reported in this work. A rough characterization of this waste material has been performed, by microanalysis and SEM pictures. Sorption tests with suspended OMR evidenced copper removal from solution, of about 60% in the investigated experimental conditions. The COD release in solution was also monitored during biosorption. Considering that it was significant, OMR washings with water were performed before biosorption. In this case the COD release in solution was reduced to less than 600 mg/L after two washings, while the OMR metal sorption properties did not change. Regenerated residues by acid solutions gave a copper removal of about 40%, in the same experimental conditions of the first adsorption test: regeneration with EDTA at different concentrations suggested that it presents a damage of adsorption active sites. On the other hand, the use of HCl and CaCl(2) led to completely regenerate the biosorbent material. Tests were also performed with a column filled with 80 g of OMR and the breakpoint was demonstrated to take place after that about 1L solution was treated in the investigated experimental conditions. Regeneration tests permitted to demonstrate that a concentration factor of about 2 can be obtained in no-optimized conditions, highlighting the possibility of using OMR for the treatment of metal bearing effluents. The main advantage of the process would be the "low cost" biosorbing material, considering that it represents a waste in the olive oil production.

Adsorption↗

PubMed2003

Recovery of valuable metals from electronic and galvanic industrial wastes by leaching and electrowinning.

In the present paper, a study on laboratory scale to perform a treatment for valuable metals recovery from electronic and galvanic industrial wastes, is reported. The characterisation of the waste, performed by XRD, SEM, EDX and chemical analysis, showed a high metals content in the sludge, such as Cu, Ni, Mn, Pb, Sn, W. A leaching process, coupled by electrowinning, is then proposed in order to reduce the volume of the waste material and to recover selectively valuable metals, such as Cu and Ni. During the leaching step, carried out by using H(2)SO(4), several factors were investigated (acid concentration, temperature and time of treatment). The leached liquor has been successfully treated with an electrowinning process, to recover copper and nickel. The copper and nickel depositions, were performed in acid and alkaline conditions, respectively. The Faraday yield was of about 95%. The energy consumption was 2.13 and 4.43 kWh per kg of copper and nickel recovered, respectively. At the end of the process, about 94-99% of the initial content of Cu and Ni was recovered at the cathode. The experimental results obtained, showed the technical feasibility of the process.

Conservation of Natural Resources↗

PubMed2002

Investigation of naphtalene sulfonate compounds sorption in a soil artificially contaminated using batch and column assays.

In the present work desorption tests of an artificially contaminated soil by naphatelene sulphonated compounds have been carried out by soil washing realised by water at different pH: Naphtalene-1,5-disulfonic acid (1-5 NDS), 2-naphthol-6,8 disulphonic acid (G-acid) and sodium beta-naphtalene-sulphonate (beta-salt) have been selected as more representative organic compounds present in the ex industrial site of ACNA (Cengio, SV, Italy) in which very serious contamination levels of several pollutants are present both in the soils and surface waters. Equilibrium batch tests have been carried out in order to find the best operative condition in column washing tests. The obtained results can be considered very preliminary but useful to arrange a next experimental work that will be realised on real contaminated soils.

Adsorption↗