Fikret Tumen | PubMed Health

PubMed2006

The use of sulphuric acid-carbonization products of sugar beet pulp in Cr(VI) removal.

A carbon rich adsorbent prepared from the reaction of sugar beet pulp with sulphuric acid and gas formed during carbonization process have been studied for Cr(VI) removal from aqueous solutions. The SO(2) rich gas was shown to be an excellent Cr(VI) reductant. The equilibrium and kinetic studies were conducted by using the carbonaceous adsorbent derived from sugar beet pulp. The lower pH favoured Cr(VI) adsorption but substantial Cr(VI) reduction was observed. The Langmuir and Freundlich isotherm models were applied and the Langmuir model best fit the equilibrium isotherm data. The maximum adsorption capacity of chromium calculated from Langmuir isotherm is about 24 mgg(-1) for 25 degrees C. The adsorption of Cr(VI) is an endothermic process and follows the pseudo-second-order rate kinetics. The sulphuric acid-carbonization is an economical method for particularly chromium removal because the gas generated during carbonization exhibits good Cr(VI) reduction properties and carbonaceous material obtained is an efficient Cr(VI) adsorbent.

Adsorption↗

PubMed2004

Chromium removal from aqueous solution by the ferrite process.

This research summarises the results of the study on the removal of chromium by applying the ferrite process to the solutions obtained from two different Cr(VI) reduction processes utilising sodium sulphite and ferrous sulphate as reducing agents. For both solutions containing trivalent chromium ions, the optimum treatment conditions were determined. The generated sludges were characterised by XRD analysis and physical tests. In addition, to explore the dissolution properties of the sludges obtained, they were contacted with the solutions of sulphuric, citric, tartaric, oxalic and ascorbic acids and EDTA. Also, the sludge samples were subjected to standard toxicity characterisation leaching procedure (TCLP) test of USEPA in order to determine the pollution potential. An efficient Cr(III) removal (about 100%) in the solution from the Cr(VI) reduction process utilising sodium sulphite as reducing agent was achieved when the solution was treated at pH 9 and 50 degrees C for 60 min in the presence of Fe2+/Cr3+ weight ratio of 16. For the other Cr(III) solution prepared from Cr(VI) reduction by ferrous sulphate, a Fe2+/Cr3+ weight ratio of 17.9 at the same conditions was found to produce complete removal of Cr(III). It was determined that the spynel chromium-iron compounds obtained in the process were in the form of chromite (Cr2FeO4). Dissolution experiments and TCLP tests show that the concentrations of the chromium dissolved from both sludges were below the limit given as 5 mg l(-1) by USEPA. The results showed that Cr(III) removal through ferrite process provides the advantages that the sludges generated are non-voluminous, easily separable and environmentally stable.

Chromium↗