PubMed Health⌕ Search

Biomedical subjects

G L Ball

Publications and source records attributed to G L Ball.

7 recordsLinked to original sources

Solvent vapor exposures in booth spray painting and spray glueing, and associated operations.

Time-weighted average exposures for all solvents present at detectable levels were obtained for eighty-nine solvent-using workers and thirty-six control-group (unexposed) workers in seven plants of three companies applying paints and glues, primarily by spraying. Over twenty solvents were quantified if detected. Concentrations of specific solvents and cumulative fractions of TLVs were measured for various job types. All spray painting and most spray glueing was conducted in operating spray booths. Only low to moderate exposures were observed, with one TWA exceeding the cumulative TLV and three additional TWAs exceeding 50 percent of the cumulative TLV. It may be concluded that solvent TWA exposures in spraying of paints and glues are often well-controlled by common spray booths, and further, that other solvent-use operations including light-duty solvent wiping and manual paint mixing do not frequently produce high exposures (relative to TLV levels) in the presence of ordinary general room ventilation.

Adhesives↗

Thermal degradation products from PVC film in food-wrapping operations.

Thermal degradation products of polyvinyl chloride (PVC) food-wrap films were studied under simulated supermarket conditons using a commercial wrapping machine with either a hot wire or a cool rod cutting device. A sampling hood was constructed around the wire/rod to confine and allow collection of thermal degradation products produced. Compounds analyzed and normal concentration ranges found included hydrogen chloride (1-10 micrograms per cut), plasticizer (1-50 micrograms per cut), benzene and toluene (each < 5-20 ng per cut), acrolein (25-150 ng per cut), and carbon monoxide (2-4 micrograms per cut) using the hot wire. Room air samples, collected during hot-wire cutting without the sampling hood, had < 0.25 ppm hydrogen chloride. Using the cool-rod cutting device hydrogen chloride, benzene, and toluene were not detected. Plasticizer was detected (25-86 micrograms per cut) using the cool rod.

Acrolein↗