Biomedical subjects

G Y Millet

Publications and source records attributed to G Y Millet.

23 records · Page 2Linked to original sources

PubMed1998

Stretch-shortening cycle in roller ski skating: effects of technique.

The purposes of this study were 1) to examine the occurrence of the stretch-shortening cycle (SSC) in the three principal techniques of ski skating and 2) to test the hypothesis that differences in SSC behaviour may explain the choice of a technique when the grade is altered. Ten highly skilled male cross-country skiers roller skied at 5.3+/-0.1 m x s(-1) using the V1 skate (V1), V2-alternate (V2A), and V2 skate (V2) techniques. Knee and ankle joint kinematics, EMG of the vastus lateralis (VL) and gastrocnemius lateralis (GL) muscles, and roller ski velocity were recorded during the last 40 s of each bout of roller skiing. The existence of an EMG signal during the eccentric phase prior to the thrust, as well as the lack of significant delay between the two phases, showed that SSC occurs in the three techniques of roller ski skating with the exception of 50% of the subjects at the weak side knee with V1. The VL stretching velocity over the eccentric phase was higher (p < 0.005) with V2 and V2A than V1, indicating that less elastic energy was stored in the lower limbs extensor muscles with V1. This could partly explain why this technique is not used on flat terrains during races. However, no differences of average EMG activity or IEMG existed between techniques for either GL or VL during the concentric phase, suggesting that the theoretical advantage due to the SSC behaviour is minor in roller ski skating.

Adult↗

PubMed1998

Cycle rate variations in roller ski skating: effects on oxygen uptake and poling forces.

The purpose of this study was to examine the effect of cycle rate (CR) variations on the metabolic cost and upper body forces during roller skiing with the V2-alternate technique on flat terrain. Nine highly skilled cross-country skiers roller skied at a paced speed of 18.0+/-0.1 km x h(-1) using their chosen CR, and CRs that were 10% slower and 20% faster. Oxygen uptake (VO2) was determined through collection of expired gases into a meterological balloon and poling forces were measured with piezoelectric transducers during the last 30 s of each four minute trial of roller skiing. One-way repeated measures ANOVA revealed that VO2 varied significantly with CR (p=0.02) with the chosen CR being significantly lower than the higher CR (p < 0.05). Poling forces and poling time were not significantly different among the CR conditions. The present results demonstrate that 1) an alteration in cycle rate affects metabolic cost of roller ski skating, 2) skiers tend to naturally select the most economical cycle rate, and 3) moderate variations in cycle rate do not appear to affect propulsive force generation through the poles in roller skiing.

Adult↗

PubMed1998

Effect of rolling resistance on poling forces and metabolic demands of roller skiing.

OBJECTIVE: To examine the effect of an increase in roller ski rolling resistance on the physiological and upper body demands of roller skiing with the V2-alternate technique. METHODS: Nine highly skilled cross-country skiers roller skied at three paced speeds on a flat oval loop using roller skis with high (HiR) and low (LowR) rolling resistance. Oxygen uptake (VO2), heart rate, and poling forces were measured during the last 30 s and rating of perceived exertion (RPE) was requested immediately after each 4-min bout of roller skiing. RESULTS: VO2 and all force-related variables increased significantly with speed and were higher (P < 0.01) for HiR at given speeds. Poling time was similar between HiR and LowR, whereas poling recovery time was shorter (P = 0.0002) and cycle rate was higher (P = 0.002) for HiR. For given VO2 levels, peak and average forces, heart rates, and RPE values were similar between HiR and LowR, whereas average poling force across the cycle was greater (P = 0.006) and duty cycle (i.e., percentage of cycle when poling forces were applied) was higher (P = 0.0001) with HiR. CONCLUSIONS: 1) The decrease in poling recovery time and increase in cycle rate associated with an increase in roller ski rolling resistance is comparable to the effect previously observed from increasing grade and probably occurs as a means of limiting deceleration. 2) Since changes in rolling resistance do not alter the relationships of RPE and heart rate with VO2, the central cardiovascular adaptations from roller ski training should not be affected by the rolling resistance of the roller skis. 3) Higher resistance roller skis are likely to induce greater upper body aerobic adaptations than lower resistance roller skis.

Adult↗

PubMed1998

Poling forces during roller skiing: effects of grade.

PURPOSE: A substantial proportion of the propulsive forces required for uphill skiing are generated from the upper body, but no study has systematically examined poling forces at different slopes. In the present experiment, poling forces and timing were examined during roller skiing on 2.1% and 5.1% uphills. METHODS: Nine highly skilled cross-country skiers roller skied at paced submaximal and at maximal speeds using the V1 skate (V1) and double pole (DP) techniques. Poling forces and timing were measured with piezoelectric transducers. RESULTS: Peak force (PF), average force (AF) and average force over the entire cycle (ACF) were significantly greater (P < 0.01) at the steeper grade with both techniques. Values for the ratio of V1 to DP did not differ between the two grades for PF, AF, and ACF but tended to increase with velocity for both techniques. With both V1 and DP, upper body recovery time was shorter (P < 0.01) at the steeper grade, and cycle rate was greater (P < 0.01) at the steeper grade. CONCLUSIONS: We conclude that 1) the relative demands on the upper body with V1 compared with DP were similar between the two grades, and 2) the responses to an elevation in grade of increased poling forces, shortened poling recovery times, and increased cycle rate are comparable to the responses to an increase in speed.

Acceleration↗

PubMed1998

Poling forces during roller skiing: effects of technique and speed.

PURPOSE: Although it has been reported that the majority of propulsive forces are generated through the poles with ski skating, no study has systematically examined poling forces among different skating techniques. The objective of the present study was to examine poling forces and timing during roller skiing on a 2.1% uphill. METHODS: Nine highly skilled cross-country skiers roller skied at three paced speeds and maximal speed using the V1 skate (V1), V2-alternate (V2A), V2 skate (V2), and double pole (DP) techniques while poling forces and timing were measured with piezoelectric transducers. RESULTS: Peak force (PF) values with the skating techniques were significantly lower than with DP and ranged from 18.9 +/- 3.1% of body weight (BW) to 31.5 +/- 5.6% BW across the speeds of the study. Average force over the entire cycle (ACF) increased with speed with DP, V2A and V1 (P < 0.01) but not with V2. PF and ACF were higher (P < 0.01) with V2 than V1 and V2A. Poling time was longer (P < 0.01) with V2A compared with V1 and V2. CONCLUSIONS: The results of this study suggest that 1) the use of the upper body is greater with V2 than with other skating techniques while there is a relatively greater reliance on the lower body for generation of the additional propulsive forces required to increase velocity, and (2) poling forces do not appear to be as effectively applied with V2 as with V2A.

Acceleration↗