Biomedical subjects

GX Chen

Publications and source records attributed to GX Chen.

3 recordsLinked to original sources

PubMed2000

Pattern selection induced by electroconvection in the electrodeposition of iron

The morphology of iron electrodeposit is shown to relate closely to the pH of the electrolyte solution. Macroscopically, depending on the strength of the interbranch convection, which is associated with the concentration of H3O+ in the electrolyte, the deposit morphology varies from treelike pattern to meshlike pattern and dense-branching morphology. Microscopically the deposit is ramified and dense-branching at lower concentration of H3O+, while it becomes relatively smooth and stringy at higher H3O+ concentration. The symmetry of the convective vortices on the two sides of the growing tip is observed to decide the growth behavior of the tip. We suggest that H3O+ influences the pattern formation and pattern selection in the electrodeposition of iron from FeSO4 solution by either initiating interbranch convection or changing the effective interfacial energy of the deposit and the electrolyte.

Journal Article↗

PubMed1998

Replacing Solvent Drying Technique for Nanometer Particle Preparation.

A prepration technique for nanometer particles, namely the replacing solvent drying technique, was developed. The main process of the technique including replacement of water in gel with special organic solvent and the removal of the solvent by distillation. No collapse of gel structure took place because of low interface tension between water and the solvent as well as low surface tension of the solvent. Where special apparatus and strictly limited preparation conditions were not necessary. The technique is noted for its low preparation cost and high universality. Titanium oxide and copper borate were prepared using the technique and were characterized using XRD, nitrogen physical adsorption, TEM, and small angle X-ray scattering. Results indicated that the titanium oxide and copper borate possessed particle sizes of 7-10 and 7-20 nm as well as a specific surface area of 235 m2/g and 360 m2/g, respectively. The specific surface area were even much higher than that of the samples prepared using supercritical drying technique. Copyright 1998 Academic Press.

Journal Article↗

PubMed1997

Tuberculosis Mortality and Silica Exposure: A Case-Control Study Based on a National Mortality Database for the Years 1983-1992.

A case-control study (8,740 cases; 83,338 controls) was done to evaluate the association between potential occupational exposure to silica and risk of tuberculosis (TB) mortality, using the National Occupational Mortality Surveillance database for 1983-1992. Potential silica exposure was based on the decedent's usual industry and occupation. Assignment of potential exposure to silica was based on the entire range of industries and occupations. Odds ratios (ORs) for mortality from respiratory TB associated with potential high and intermediate exposures to silica were 1.30 (95% CI 1.14-1.48) and 1.07 (95% CI 0.77-1.47), respectively, adjusting for silicosis, other pneumoconioses, age, gender, race, socioeconomic status, and potential exposure to active TB. The elevated OR was seen in all subgroups: male, female, white, and black. The average age at death among respiratory TB cases with potential silica exposure was significantly younger by four years than that among cases without potential silica exposure. The findings suggest that potential occupational exposure to silica alone, in the absence of silicosis, is associated with respiratory TB mortality, with a dose-response relationship.

Journal Article↗