Biomedical subjects

Gerrit Moritz

Publications and source records attributed to Gerrit Moritz.

3 recordsLinked to original sources

PubMed2006

Construction of environment states in quantum-chemical density-matrix renormalization group calculations.

The application of the quantum-chemical density-matrix renormalization group (DMRG) algorithm is cumbersome for complex electronic structures with many active orbitals. The high computational cost is mainly due to the poor convergence of standard DMRG calculations. A factor which affects the convergence behavior of the calculations is the choice of the start-up procedure. In this start-up step matrix representations of operators have to be calculated in a guessed many-electron basis of the DMRG environment block. Different possibilities for the construction of these basis states exist, and we first compare four procedures to approximate the environment states using Slater determinants explicitly. These start-up procedures are applied to DMRG calculations on a sophisticated test system: the chromium dimer. It is found that the converged energies and the rate of convergence depend significantly on the choice of the start-up procedure. However, since already the most simple start-up procedure, which uses only the Hartree-Fock determinant, is comparatively good, Slater determinants, in general, appear not to be a good choice as approximate environment basis states for convergence acceleration. Based on extensive test calculations it is demonstrated that the computational cost can be significantly reduced if the number of total states m is successively increased. This is done in such a way that the environment states are built up stepwise from system states of previous truncated DMRG sweeps for slowly increasing m values.

Journal Article↗

PubMed2005

Relativistic DMRG calculations on the curve crossing of cesium hydride.

Over the past few years, it has been shown in various studies on small molecules with only a few electrons that the density-matrix renormalization group (DMRG) method converges to results close to the full configuration-interaction limit for the total electronic energy. In order to test the capabilities of the method for molecules with complex electronic structures, we performed a study on the potential-energy curves of the ground state and the first excited state of 1sigma+ symmetry of the cesium hydride molecule. For cesium relativistic effects cannot be neglected, therefore we have used the generalized arbitrary-order Douglas-Kroll-Hess protocol up to tenth order, which allows for a complete decoupling of the Dirac Hamiltonian. Scalar-relativistic effects are thus fully incorporated in the calculations. The potential curves of the cesium hydride molecule feature an avoided crossing between the ground state and the first excited state, which is shown to be very well described by the DMRG method. Compared to multireference configuration-interaction results, the potential curves hardly differ in shape, for both the ground state and the excited state, but the total energies from the DMRG calculations are in general consistently lower. However, the DMRG energies are as accurate as corresponding coupled cluster energies at the equilibrium distance, but convergence to the full configuration-interaction limit is not achieved.

Journal Article↗

PubMed2005

Convergence behavior of the density-matrix renormalization group algorithm for optimized orbital orderings.

The density-matrix renormalization group algorithm has emerged as a promising new method in ab initio quantum chemistry. However, many problems still need to be solved before this method can be applied routinely. At the start of such a calculation, the orbitals originating from a preceding quantum chemical calculation must be placed in a specific order on a one-dimensional lattice. This ordering affects the convergence of the density-matrix renormalization group iterations significantly. In this paper, we present two approaches to obtain optimized orderings of the orbitals. First, we use a genetic algorithm to optimize the ordering with respect to a low total electronic energy obtained at a predefined stage of the density-matrix renormalization group algorithm with a given number of total states kept. In addition to that, we derive orderings from the one- and two-electron integrals of our test system. This test molecule is the chromium dimer, which is known to possess a complicated electronic structure. For this molecule, we have carried out calculations for the various orbital orderings obtained. The convergence behavior of the density-matrix renormalization group iterations is discussed in detail.

Journal Article↗