Biomedical subjects

Ghinwa Naja

Publications and source records attributed to Ghinwa Naja.

5 recordsLinked to original sources

PubMed2006

Comparative testing of tangential microfiltration for microbial cultures.

In an attempt to extend and intensify the productive periods of bioprocesses, a self-cleaning tangential filtration device was examined. Built into a special-design bioreactor, its cell retention was evaluated for continuous-flow operation with selected examples of bacteria (Escherichia coli), yeasts (Sacharomyces cerevisiae), and filamentous fungi (Aspergillus niger). Performance characteristics such as filtration rates and cell accumulation were assessed as a function of filter rotational speed, operating pressure, cultivation time, and microfilter type (i.e., membrane or porous metallic). The highest flux of cell-free filtrate for each culture type was achieved using a 0.45-micron membrane-covered microfilter. While the respective yeast (S. cerevisiae) and bacterial (E. coli) cell concentrations were enhanced by as much as 16- and 8-fold over the batch growth levels, the representative A. niger fungal cultivation was less satisfactory because of progressively declining filtration rates limited by hydraulically resistant layers of microbial surface growth quite resistant to in situ filter backflushing with gas. Maximum steady-state flux was independent of operating pressure, yet was enhanced at rotational speeds up to about 800 rpm. Higher speeds offered no further improvements. The overall fermentation process was limited by the moderate levels of attainable flux which restricted the feed and dilution rates. The maximum attainable stabilized fluxes were 26-40 L/m(2) x h.

Aspergillus niger↗

PubMed2006

Behavior of the mass transfer zone in a biosorption column.

Modeling of the mass transfer zone behavior under variable conditions in a flow-through fixed-bed sorption column enabled the prediction of breakthrough curves for Cu2+ and Ca-preloaded Sargassum fluitans biomass. The mass transfer resistance, particle diffusion, and the axial dispersion were incorporated in the model. The dynamics of the mass transfer zone was described under variable sorption column operating conditions including different column lengths and fluid flow rates. Accurate estimation of the behavior of the mass transfer zone as it progressed through the column, reflected eventually in the breakthrough curve, assisted in its relevant interpretations. Furthermore, the proposed mathematical model of the biosorption process was capable of demonstrating the expanding and broadening of the mass transfer zone linked to the equilibrium sorption isotherm. The fundamental understanding of the mass transfer zone dynamics is particularly important for process scale-up where maintaining the process efficiency is critical.

Adsorption↗

PubMed2006

Stabilization of the initial electrochemical potential for a metal-based potentiometric titration study of a biosorption process.

An interactive metal-based potentiometric titration method has been developed using an ion selective electrode for studying the sorption of metal cations. The accuracy of this technique was verified by analyzing the metal sorption mechanism for the biomass of Rhizopus arrhizus fungus and diatomite, two dissimilar materials (organic and mineral, strong sorbent and weak sorbent) of a different order of cation exchange capacity. The problem of the initial electrochemical potential was addressed identifying the usefulness of a Na-sulfonic resin as a strong chelating agent applied before the beginning of sorption titration experiments so that the titration curves and the sorption uptake could be quantitatively compared. The resin stabilized the initial electrochemical potential to -405+/-5 mV corresponding to 2 micro gl(-1) of lead concentration in solution. The amounts of lead sorbed by R. arrhizus biomass and diatomite were 0.9 mmol g(-1) (C(e)=5.16 x 10(-2)mM) and 0.052 mmol g(-1) (C(e)=5.97 x 10(-2) mM), respectively. Lead sorption by the fungal biomass was pinpointed to at least two types of chemical active sites. The first type was distinguished by high reactivity and a low number of sites whereas the other was characterized by their higher number and lower reactivity.

Adsorption↗

PubMed2005

Lead biosorption study with Rhizopus arrhizus using a metal-based titration technique.

Acid-base and metal-based potentiometric titration methods were used to analyze sorption mechanisms of lead by Rhizopus arrhizus fungal biomass. Biosorption was not considered globally but as the result of successive sorption reactions on various binding sites with different selectivities. Precipitation occurred rapidly when lead concentration increased. Lead was sorbed essentially by carboxylic groups and by phosphates and sulfonates (less abundant) of the organic matter. The lead affinity to carboxylic, sulfonate and phosphate binding sites depended on the association coefficient with proton or counter-ion and on the spatial distribution of the surface sites promoting the formation of mono- or bi-dentate complexes. Chemical bonds and binding sites were confirmed using microscopic and spectroscopic techniques (IR, MET-EDAX). It appeared that although the total organic acidity was reached, number of ionized and free carboxylic groups were not involved in lead sorption reactions. In spite of lead speciation in the solution, surface micro-precipitation was observed and the two processes, surface adsorption and micro-precipitation, are sequential and possibly overlapping. At low concentrations (<10(-6) M) adsorption is the dominant phenomenon and beyond (>10(-5) M) surface clusters appeared before the predicted solution precipitation phenomenon.

Adsorption↗

PubMed2004

A high-resolution titrator: a new approach to studying binding sites of microbial biosorbents.

The high-resolution potentiometric titration was used as a physico-chemical method to study the acid properties of selected biosorbent materials in order to quantify the functional acidic groups for sorption and to determine their affinities by considering their partial or total ionization equilibrium reactions. The Gran's method and the Henderson-Hasselbach's equation were employed in establishing the partition of the total acidity as associated with strong, weak and very weak acidic chemical active groups. The differences in the total organic acidity (A(TO)) for the two selected types of bacteria and two mycelia revealed by this method were explained by the chemical composition of their cell walls. The total organic acidities obtained were 3.87 me g(-1) for Thiobacillus ferrooxidans, 1.31 me g(-1) for Corynebacterium glutamicum, 0.81 me g(-1) for Aspergillus niger and 2.54 me g(-1) for Rhizopus arrhizus. The links between the activity of protons and the sorption capacities of the selected bioorganic matters were established. Sorption of lead by C. glutamicum and R. arrhizus biomass indicated an optimum pH of 6. It appeared that 64% (Pb(uptake)=0.48 me g(-1)) and 38% (Pb(uptake)=0.28 me g(-1)) of A(TO) were involved during lead sorption onto R. arrhizus and C. glutamicum, respectively. The applications of titration techniques become a powerful tool for the characterization of heterogeneous materials involved in biosorption and bioremediation processes.

Aspergillus niger↗