PubMed Health⌕ Search

Biomedical subjects

Gordon G Wallace

Publications and source records attributed to Gordon G Wallace.

14 recordsLinked to original sources
PubMed2007

Free standing carbon nanotube composite bio-electrodes.

Carbon nanotubes present a new material for the construction of electrodes for electrochemical devices such as batteries, capacitors, and actuators. Such electrodes require high conductivity, strength, and surface area. The latter two requirements are often incompatible. Electrodes composed entirely of carbon nanotubes (bucky paper) have high surface areas but are typically weak, and have insufficient conductivity for practical macroscopic applications. Here we report a technique that uses naturally occurring biopolymers to produce electrodes (free standing films) that exhibit conductivities of 300 S/cm. These composites also have considerable mechanical strength (up to 145 MPa) and sufficient specific capacitance of 19-27 F/g to enable them to be used as freestanding electrodes. One potential application that deserves special attention is that of biocompatible electrodes, where the binder is a biopolymer already used in a range of implants. Preliminary studies reported here show that the new carbon nanotube biopolymer electrodes can foster prolific L929 cell growth.

Animals↗
PubMed2006

Swelling behavior of chitosan hydrogels in ionic liquid-water binary systems.

The swelling behavior of chitosan hydrogels in ionic liquid-water binary systems was studied using hydrophilic room-temperature ionic liquids (RTILs) to elucidate the swelling mechanism of chitosan hydrogels. No penetration of RTIL into a dry chitosan material was observed. Swelling was achieved by soaking in water-RTIL binary mixtures, with larger swelling observed at higher water contents. In one instance, the binary mixture was acidic and produced larger than expected swelling due to the dissociation of the amine groups in the chitosan. The equilibrium binary system content behavior of the chitosan hydrogels depended upon the amount of free water, which is a measure of the number of water molecules that do not interact with the ionic liquid. After evaporation of water, remnant RTIL remained in the chitosan network and hardness testing indicated a plasticization effect, suggesting that the RTIL molecularly mixed with the chitosan. Chitosan hydrogels containing only RTIL were prepared by dropping pure RTIL onto a fully preswollen hydrogel followed by water evaporation. This method may be a useful means for preparing air-stable swollen chitosan gels.

Calorimetry, Differential Scanning↗
PubMed2006

Optimising the incorporation and release of a neurotrophic factor using conducting polypyrrole.

In this study, a neurotrophin delivery system based on an inherently conducting polymer (ICP) has been developed. Direct incorporation of neurotrophin-3 (NT-3) was investigated and controlled release was tested under various electrochemical conditions. The loading capacity and amount of NT-3 released from the polymer was determined using (125)I-labelled NT-3. Electrochemical stimulation of polypyrrole by pulsed voltage, pulsed current or cyclic voltammetry promoted the release of NT-3 at a greater rate than natural diffusion of NT-3. NT-3 was released from polypyrrole as an initial burst in the first 24 h followed by prolonged release over a subsequent 6 days of sampling. The amount of NT-3 incorporated into the polymer could be controlled by varying the polymerisation time, with longer growth periods incorporating more NT-3. The NT-3 release results indicated that the polymers grown for longer released a lower percentage of the incorporated NT-3 compared to the polymers grown for shorter times. Polymer-based neurotrophin delivery systems have the potential to be incorporated into future treatments for nerve injuries to prevent nerve degradation and promote nerve protection.

Delayed-Action Preparations↗
PubMed2005

Surprising shrinkage of expanding gels under an external load.

Hydrogels are fascinating and useful in that they can show large volume changes in response to various stimuli, such as temperature or chemical environment. Here we report the peculiar observation that chemically crosslinked hydrogels that normally expand owing to a change in electrolyte pH can be made to shrink in certain circumstances. Specifically, these hydrogels contract when tested at a constant compressive force and subjected to a pH change that causes expansion in the absence of the applied load. When tested under tension, the gels always expand. Although the effects of external stress on the swelling of gels is known, the concomitant change in gel mechanical properties during pH switching was found to be a more dominant effect in our studies. However, existing mechanical models used to predict dimensional changes in actuator materials could not explain both the tensile and compression results. In addition, we show that the friction between metal plates of the apparatus and the gel is a key factor in explaining the contractile actuation under compressive loads. The observations reported in this paper are important for the successful design and use of hydrogel actuators in devices such as valves for microfluidics.

Cross-Linking Reagents↗
PubMed2005

Optically active polymer carbon nanotube composite.

A completely soluble optically active polyaniline-multiwalled carbon nanotube composite was investigated by spectroscopic and microscopic techniques. It was found that the polymer's optical activity was retained in the presence of carbon nanotubes. Solutions were found to be easily processable into thin films, which exhibited dendritic structures only in the presence of nanotubes.

Journal Article↗
PubMed2005

Investigation of Ig.G adsorption and the effect on electrochemical responses at titanium dioxide electrode.

The adsorption of Immunoglobulin G on a titanium dioxide (TiO(2)) electrode surface was investigated using (125)I radiolabeling and electrochemical impedance spectroscopy (EIS). (125)I radiolabeling was used to determine the extent of protein adsorption, while EIS was used to ascertain the effect of the adsorbed protein layer on the electrode double layer capacitance and electron transfer between the TiO(2) electrode and the electrolyte. The adsorbed amounts of Ig.G agreed well with previous results and showed approximately monolayer coverage. The amount of adsorbed protein increased when a positive potential was applied to the electrode, while the application of a negative potential resulted in a decrease. Exposure to solutions of Ig.G resulted in a decrease of the double layer capacitance (C) and an increase in the charge-transfer resistance (R(2)) at the electrode solution interface. As more Ig.G adsorbed onto the electrode surface, the extent of C and R(2) variation increased. These capacitance and charge-transfer resistance variations were attributed to the formation of a proteinaceous layer on the electrode surface during exposure.

Adsorption↗
PubMed2004

Electrochemical modulation of antigen-antibody binding.

The label-free amperometric detection of a rabbit IgG antigen by an anti-rabbit IgG antibody is achieved by observing the electrochemistry at a glassy carbon electrode modified with antibody entrapped in an electrodeposited polypyrrole membrane. In a flow injection apparatus the electrode is pulsed between -0.2 and +0.4 V versus Ag/AgCl. The pulsing of the electrode switches the polypyrrole membrane between the oxidised and reduced states. When antigen is injected into the flow stream a change in current is observed at the electrode despite the antigen or antibody being redox inactive at the potentials employed. It is proposed that this current is due to a change in the flux of ions into and out of the polypyrrole matrix during a pulse when the poly-anionic antigen is present. The immunoreaction was reversible because the 200 ms pulse at each potential was too short to allow secondary bonding forces (hydrogen bonding and hydrophobic forces) which are responsible for the strength of the antibody-antigen complex to be established. The consequence of the reversibility of the antigen-antibody binding is a low apparent affinity constant but an easily regenerated recognition interface.

Animals↗
PubMed2004

Use of inherently conducting polymers and pulsed amperometry in flow injection analysis to detect oligonucleotides.

Pulsed amperometry has been used to detect and discriminate between different base-pair oligonucleotides using flow injection analysis with polypyrrole modified electrodes. Oligonucleotides with 20-repeat units were immobilized as the sole counter anion during polymerisation of pyrrole onto a glassy carbon (GC) electrode. The modified electrode was then used in a flow injection analysis (FIA) set-up to selectively detect complementary oligonucleotides. Results showed that complementary oligo(dG)(20) and non-complementary oligonucleotides can be distinguished by using the oligo(dC)(20) modified electrode.

Animals↗
PubMed2004

Stabilization of single-wall carbon nanotubes in fully sulfonated polyaniline.

The interaction of single wall carbon nanotubes (SWNT) with an aqueous solution of the fully sulfonated polyaniline poly(2-methoxyaniline-5-sulfonic acid) (PMAS) and (+)-1-phenylethylamine (PhEA) has been investigated using spectroscopic methods. UV-vis spectral measurements show that the PMAS backbone undergoes conformational changes upon interaction with both SWNT and PhEA. Partial intercalation of PMAS into SWNTbundles was confirmed by Raman spectroscopy and electron microscopy.

Adsorption↗
PubMed2004

Wearable textile biofeedback systems: are they too intelligent for the wearer?

The Intelligent Knee Sleeve is a device capable of providing immediate audible feedback to the wearer pertaining to knee flexion angle during human movement. The Intelligent Knee Sleeve was used in a landing training program to determine whether providing subjects with this form of feedback was able to effect a change in knee flexion angle during dynamic landing tasks. Preliminary results suggest that the feedback modality is effective in correcting landing technique. However, advancements in the Intelligent Knee Sleeve design would produce a more robust system leading to more effective biofeedback for the athlete.

Adult↗
PubMed2002

Use of ionic liquids for pi-conjugated polymer electrochemical devices.

pi-Conjugated polymers that are electrochemically cycled in ionic liquids have enhanced lifetimes without failure (up to 1 million cycles) and fast cycle switching speeds (100 ms). We report results for electrochemical mechanical actuators, electrochromic windows, and numeric displays made from three types of pi-conjugated polymers: polyaniline, polypyrrole, and polythiophene. Experiments were performed under ambient conditions, yet the polymers showed negligible loss in electroactivity. These performance advantages were obtained by using environmentally stable, room-temperature ionic liquids composed of 1-butyl-3-methyl imidazolium cations together with anions such as tetrafluoroborate or hexafluorophosphate.

Journal Article↗
PubMed2002

Inherently conducting polymer nanostructures.

Inherently conducting polymers (ICPs) have been an area of intense interest over the past 30 years, culminating with the award of the 2000 Nobel Prize in Chemistry to MacDiarmid, Heeger and Shirakawa. More recently the unique properties of these materials (e.g., higher conductivity, more rapid discrete electrochemical switching processes) apparent at the nanodimension have become accessible. Significant breakthroughs in synthesis and fabrication of inherently conducting polymers with nanodimensional control have made this possible. This review aims to discuss some of the synthetic approaches researchers have made in an attempt to probe the nano domain as well as some of the property enhancements afforded to these structures.

Aniline Compounds↗