Biomedical subjects

Guanying Yang

Publications and source records attributed to Guanying Yang.

9 recordsLinked to original sources

PubMed2006

Ti-Si mixed oxides prepared by polymer in situ sol-gel chemistry with the aid of CO2.

A method to prepare titania-silica binary oxides is proposed in this work. In this route, inorganic precursors tetraethyl orthosilicate (TEOS) and titanium isopropoxide (TIP) were simultaneously or sequentially impregnated into a polypropylene (PP) matrix using supercritical carbon dioxide as a swelling agent and carrier. Hydrolysis and condensation reaction of the precursors confined in a polymer network were induced by treating the composites in 1 mol.dm(-3) (1 M) HCl. Then the PP matrix was decomposed at higher temperature, and titania-silica binary oxides were obtained. The mixed oxides were characterized by X-ray diffraction and Raman, FTIR, and X-ray photoelectron spectroscopy. It was demonstrated that the structure of the oxides depended strongly on the procedure to impregnate the precursors. The simultaneous method, in which the TEOS and TIP were simultaneously impregnated into a PP matrix, resulted in mixed oxides with highly dispersed titanium oxide species in the SiO2 matrix, while the sequential method produced the mixed oxide with separate SiO2 and TiO2 phases which were connected by Ti-O-Si bands at the interface. The method described in this work provides a new route to control the texture of TiO2-SiO2 mixed oxide simply by the impregnation sequence.

Journal Article↗

PubMed2006

Micropatterned polymer surfaces induced by nonsolvent.

In this work, we present a facile method for fabricating polymer thin films with micropatterned surfaces by evaporating polymer solution containing a small amount of nonsolvent of polymer in air. Poly(methyl methacrylate) (PMMA) and polystyrene (PS) films with densely packed micropores on the surfaces were fabricated. This method was also used to prepare three-dimensional PMMA films with micropatterned surfaces. The effects of nonsolvent content; evaporation temperature; and interactions between the polymer, solvent, and nonsolvent on the specific patterns were investigated, and the formation mechanism of the pores is discussed. This simple route can potentially be used, for example, in the large-scale production of patterned surfaces, three-dimensional painting, and hydrophobicity-enhancing coatings.

Journal Article↗

PubMed2005

Carbon microspheres with supported silver nanoparticles prepared from pollen grains.

In this paper, we present a new method to fabricate carbon microspheres with supported silver nanoparticles on the surfaces. In this method, pollen grains were first treated with AgNO(3) aqueous solution, then preoxidized in air at 300 degrees C and carbonized in nitrogen at 600 degrees C, resulting in the silver/carbon nanocomposites. The silver/carbon nanocomposites were characterized by means of SEM, TEM, TG, and XRD. The size and distribution of the silver nanoparticles on the carbon microsphere surface could be controlled by tuning the AgNO(3) treatment conditions.

Journal Article↗

PubMed2005

Facile synthesis of polyaniline nanofibers using chloroaurate acid as the oxidant.

This work demonstrated a facile route to the synthesis of polyaniline (PANI) nanofibers by polymerization of aniline using chloroaurate acid (HAuCl(4)) as the oxidant. The reduction of AuCl(4)(-) is accompanied by oxidative polymerization of aniline, leading to uniform PANI nanofibers with a diameter of 35 +/- 5 nm and aggregated gold nanoparticles which can precipitate from the liquid phase during the reaction. The resultant PANI nanofibers and gold particles were characterized by means of different techniques, such as UV-vis, FTIR spectroscopy, and scanning and transmission electron microscopy methods. It is found that the gold aggregates are capped with polyaniline, and the conductivity of the fibers is around 0.16 S/cm.

Journal Article↗

PubMed2005

Ultrasound-induced capping of polystyrene on TiO2 nanoparticles by precipitation with compressed CO2 as antisolvent.

In this work, a route for the synthesis of inorganic/polymer core/shell composite nanoparticles was proposed, which can be called the antisolvent-ultrasound method. Compressed CO2 was used as antisolvent to precipitate the polymer from its solution dispersed with inorganic nanoparticles, during which ultrasonic irradiation was used to induce the coating of precipitated polymers on the surfaces of the inorganic nanoparticles. TiO2/polystyrene (PS) core/shell nanocomposites have been successfully prepared using this method. The transmission electronic micrographs (TEM) of the obtained nanocomposites show that the TiO2 nanoparticles are coated by the PS shells, of which the thickness can be tuned by the pressure of CO2. The phase structure, absorption properties, and thermal stability of the composite were characterized by X-ray diffraction (XRD), UV-vis spectra, and thermogravimetry, respectively. The results of X-ray photoelectron spectra (XPS) indicate the formation of a strong interaction between PS and TiO2 nanoparticles in the resultant products. This method has some potential advantages for applications and may be easily applied to the preparation of a range of inorganic/polymer core/shell composite nanoparticles.

Carbon Dioxide↗

PubMed2004

Preparation of ZnS/CdS composite nanoparticles by coprecipitation from reverse micelles using CO2 as antisolvent.

The possibility of simultaneously recovering ZnS and CdS particles from reverse micelles by dissolving antisolvent CO2 into the micellar solution was investigated by high-pressure UV-Vis spectra. It was found that all the ZnS and CdS particles in the reverse micelles could be precipitated by compressed CO2 at suitable pressures. The phase structures and morphologies of the obtained composites were characterized by X-ray diffraction and transmission electronic micrographs. The results illustrate that the smaller molar ratio of water to surfactant of the reverse micelles and higher pressure of CO2 are favorable for producing smaller particles. This method has many potential advantages for the production of composite nanoparticles.

Journal Article↗

PubMed2004

Enthalpy of solution of 1,4-naphthoquinone in CO2 + n-pentane in the critical region of the binary mixture: mechanism of solubility enhancement.

The enthalpy of solution (Delta(solv)H(m)) and solubility of 1,4-naphthoquinone in CO(2) + n-pentane were measured at 308.15 K in the critical region of the binary fluid. In order to study the effect of phase behavior of the mixed solvent on Delta(solv)H(m), the experiments were carried out in the supercritical (SC) and subcritical region of the binary solvent. The density of the mixed solvent in different conditions was determined. The isothermal compressibility (K(T)) of the mixed solvent, and the partial molar volume (V(n-pentane)) of n-pentane in the solution were calculated. It was demonstrated that the Delta(solv)H(m) was negative in all conditions. Delta(solv)H(m) is nearly independent of pressure or density in all the solvents in a high-density region, in which compressibility of the solvent is very small; this indicates that the intermolecular interaction between the solvent and the solute is similar to that for liquid solutions. It is very interesting that Delta(solv)H(m) in the mixed SC fluid differs from the Delta(solv)H(m) in mixed subcritical fluids. The absolute value of Delta(solv)H(m) in the mixed SC fluid is close to that in pure SC CO(2) in the high-density region, and is much lower than that in pure SC CO(2) in the low-density region. In the mixed subcritical fluids, the Delta(solv)H(m) is also close to that in the pure CO(2) in the high-density region. However, at the same density, the absolute value of Delta(solv)H(m) in the binary subcritical fluid is larger than that in pure CO(2) in the high-compressible region of the mixed solvent. The main reason for this is that the degree of clustering in the SC solutions is small at the density in which the degree of clustering is large in the subcritical solutions. It can be concluded that solubility enhancement by n-pentane in the mixed SC fluid is entropy driven. In contrast, the solubility enhancement by n-pentane in subcritical fluids is enthalpy driven. The intermolecular interaction in the SC solutions and subcritical solutions can be significantly different even if their densities are the same.

Carbon Dioxide↗

PubMed2003

Study on the phase behaviors, viscosities, and thermodynamic properties of CO2/[C(4)mim][PF(6)]/methanol system at elevated pressures.

An apparatus to determine the vapor-liquid equilibria of CO(2)/ionic liquid (IL)/organic solvent multisystems and the viscosity of the liquid phase at elevated pressures has been constructed. The solubility of CO(2) in 3-butyl-1-methyl-imidazolium hexafluorophosphate ([C(4)mim][PF(6)]) and the viscosity of CO(2)-saturated [C(4)mim][PF(6)] have been studied at 313.15, 323.15, and 333.15 K and at pressures up to 12.5 MPa. The phase behavior of CO(2)/[C(4)mim][PF(6)]/methanol ternary mixture and the viscosity of the liquid phases at equilibrium condition have also been determined at 313.15 K and at 7.15 and 10.00 MPa. The partition coefficients of the components in the ternary system are calculated. Peng-Robinson equation of state and some thermodynamic functions are combined to calculate the fugacity coefficients of the components in the system. It demonstrates that the viscosity of the IL-rich phase decreases significantly with increasing pressure of CO(2), and the effect of temperature on the viscosity of CO(2)/IL mixture is not noticeable at high pressure, although the viscosity of the CO(2)-free IL decreases dramatically with increasing temperature. Compressed CO(2) may become an attractive reagent for reducing the viscosity of ILs in many applications. The mole fraction of methanol in the CO(2)-rich phase is much lower than that in the IL-rich phase; this indicates that the interaction between the IL and methanol is stronger than that between CO(2) and methanol. The fugacity coefficient of CO(2) in IL-rich phase is larger than unity, while that of methanol is much small than unity, which further suggests that methanol-IL interaction is much stronger than CO(2)-IL interaction. However, the CO(2)-IL interaction is stronger than the CO(2)-methanol interaction.

Journal Article↗

PubMed2002

Recovery of silver nanoparticles synthesized on AOT/C(12)E(4) mixed reverse micelles by antisolvent CO(2).

Silver nanoparticles were synthesized in sodium bis(2-ethylhexyl)sulfosuccinate (AOT) reverse micelles in isooctane with tetraethylene glycol dodecyl ether (C(12)E(4)) as a cosurfactant. Recovery of the Ag particles from the reverse micelles by dissolving antisolvent CO(2) in the micellar solution was investigated. All the Ag particles in the reverse micelles could be precipitated by compressed CO(2) at suitable pressures, while the surfactants remained in the isooctane continuous phase, and well-dispersed Ag nanoparticles were obtained. The effects of operating conditions on the size and size distribution of the Ag particles were investigated. The particle size decreased with decreasing molar ratio (w) of water to surfactant. A higher CO(2) pressure in the recovery process favored production of smaller particles. A decrease in the molar ratio of reductant KBH(4) to AgNO(3) resulted in larger Ag particles with higher polydispersity.

Journal Article↗