PubMed Health⌕ Search

Biomedical subjects

Guido Raos

Publications and source records attributed to Guido Raos.

8 recordsLinked to original sources
PubMed2006

Organic-organic epitaxy of incommensurate systems: quaterthiophene on potassium hydrogen phthalate single crystals.

Hot-wall epitaxy and molecular-beam epitaxy have been employed for growing quaterthiophene thin films on the (010) cleavage face of potassium hydrogen phthalate, and the results are compared in terms of film properties and growth mode. Even if there is no geometrical match between substrate and overlayer lattices, these films are epitaxially oriented. To investigate the physical rationale for this strong orientation effect, optical microscopy, atomic force microscopy, and X-ray diffraction are employed. A clear correlation between the morphology of the thin films and the crystallographic orientation is found. The results are also validated by surface potential calculations, which demonstrate the primary role played by the corrugation of the substrate surface.

Journal Article↗
PubMed2006

Sliding friction between polymer surfaces: a molecular interpretation.

For two contacting rigid bodies, the friction force F is proportional to the normal load and independent of the macroscopic contact area and relative velocity V (Amonton's law). With two mutually sliding polymer samples, the surface irregularities transmit deformation to the underlying material. Energy loss along the deformation cycles is responsible for the friction force, which now appears to depend strongly on V [see, e.g., N. Maeda et al., Science 297, 379 (2002)]. We base our theoretical interpretation on the assumption that polymer chains are mainly subjected to oscillatory "reptation" along their "tubes." At high deformation frequencies-i.e., with a large sliding velocity V-the internal viscosity due to the rotational energy barriers around chain bonds hinders intramolecular mobility. As a result, energy dissipation and the correlated friction force strongly diminish at large V. Derived from a linear differential equation for chain dynamics, our results are basically consistent with the experimental data by Maeda et al. [Science 297, 379 (2002)] on modified polystyrene. Although the bulk polymer is below T(g), we regard the first few chain layers below the surface to be in the liquid state. In particular, the observed maximum of F vs V is consistent with physically reasonable values of the molecular parameters. As a general result, the ratio FV is a steadily decreasing function of V, tending to V(-2) for large velocities. We evaluate a much smaller friction for a cross-linked polymer under the assumption that the junctions are effectively immobile, also in agreement with the experimental results of Maeda et al. [Science 297, 379 (2002)].

Journal Article↗
PubMed2006

Modeling of molecular packing and conformation in oligofluorenes.

We describe the application of molecular modeling to study problems related to the packing and conformation of oligofluorene molecules in the solid state. First of all, we describe an improved force field for oligofluorenes. The model is based on the MM3 force field for the intramolecular degrees of freedom, but it relies on ab initio calculations for the torsion potential between two monomers and the electrostatic interactions. We also report ab initio calculations of the interaction potentials between fluorene and fluorenone units. The force field has been tested on the crystal structures of a fluorene monomer, a dimer, and a pentamer containing a fluorenone at the center. It has then been employed to study conformational defects of the chains, both in vacuo and in the bulk. We find that certain modes of inversion from right-handed to left-handed helices are also possible within the constraining environment of the crystals. The effect of the presence of two different types of side chains has been also addressed. Finally, the possibility of having two fluorene units parallel and close to each other has been investigated as a model of a ground-state precursor of an excimer. Our simulations show that this configuration is sterically and energetically unfavorable so that formation of an excimer following optical excitation appears to be unlikely.

Journal Article↗
PubMed2006

Free energies of molecular crystal surfaces by computer simulation: application to tetrathiophene.

We describe a general simulation protocol for the evaluation of the surface free energies of molecular crystals, which are of broad interest for phenomena such as polymorphism and crystal growth. The method has been applied to selected surfaces of two polymorphs of tetrathiophene. The simulations highlight an important temperature-dependent entropic contribution to the surface free energies, which is not included in widely used static simulations of surface structure and energetics.

Journal Article↗
PubMed2005

Conformational analysis of 2,2'-bithiophene: a (1)H liquid crystal NMR study using the (13)C satellite spectra.

We have obtained a very large data set of spectral parameters from the analysis of (1)H NMR and (13)C satellite spectra of 2,2'-bithiophene dissolved in anisotropic, partially orienting mesophases. In particular, this parameter set includes 33 dipolar couplings, which are directly related to the interatomic distances, the dihedral angle phi between the two thiophenic rings, and the anisotropic solute-solvent interaction potential. This allows an exhaustive investigation of the conformational equilibrium of 2,2'-bithiophene in a liquidlike phase. Comparison with the predictions of high-level theoretical calculations for the isolated molecule provides evidence of a strong flattening as well as the sharpening effect of the medium on the conformer population. The approximations needed to apply vibrational corrections to flexible molecules are discussed in detail and some general conclusions concerning their effect on structure and conformational equilibria are proposed.

Carbon Isotopes↗
PubMed2005

Structure of an associating polymer melt in a narrow slit by molecular dynamics simulation.

Molecular dynamics simulation has been used to study the equilibrium properties of a generic coarse-grained polymer melt with associating terminal groups, confined in a narrow slit by two atomically smooth walls. Simulations were carried out as a function of wall separation and attracting strength as well as polymer end-end interaction strength. We find that confinement has an important effect on the melt properties. In particular, strongly attracting walls can produce radical changes in chain conformation, the nature of the transient network, and the structure of the aggregates formed by the associating terminals.

Journal Article↗
PubMed2005

Role of desorption in the growth process of molecular organic thin films.

Growth studies of ultrahigh vacuum deposited thin films are often carried out ex situ, assuming the total film mass reached at the end of the deposition is preserved in the subsequent stages of film preparation. Many kinetic models commonly adopted to analyze quantitatively the mechanism of growth take into account the role of the deposition rate of molecules on the substrate surface, their diffusion, and their possible desorption. Within this framework, a strong simplification (and approximation) of the model is achieved when considering a regime of complete condensation (i.e., neglecting the possibility of re-evaporation of the deposited molecules, both during the deposition and the postdeposition stages of growth). Here, we demonstrate that, for molecular materials of relatively small organic molecules physisorbed on inert surfaces, this phenomenon may strongly affect not only the surface dynamics during deposition but also the postdeposition stage of thin film preparation. Some examples showing clearly its effects on the surface of single crystals and the thin film phase are reported and discussed. Finally, a quantitative description of desorption is provided by comparing the prediction of thermodynamics for the quaterthiophene/silica system with the experimental observation of the growth dynamics of the film and the results of approximate kinetic models. The thermodynamic model employs the surface free energies of a quaterthiophene crystal, which are evaluated by molecular simulation using a newly developed force field.

Journal Article↗