PubMed Health⌕ Search

Biomedical subjects

H F Sun

Publications and source records attributed to H F Sun.

17 recordsLinked to original sources
PubMed2003

Inhibition of nicotine-DNA adduct formation in mice by six dietary constituents.

Nicotine [3-(1-methyl-2-pyrrolidinyl)-pyridine] is a major alkaloid in tobacco products and has proven to be a potential genotoxic compound. Many natural dietary products can suppress the DNA adduction, and hence act as inhibitors of cancer. In this study, we investigated the inhibitory effects of curcumin, garlic squeeze, grapeseed extract, tea polyphenols, vitamin C, and vitamin E on nicotine-DNA adduction in vivo using an ultrasensitive method of accelerator mass spectrometry (AMS). The results demonstrated that all the dietary constituents induced marked dose-dependent decrease in nicotine-DNA adducts as compared with the control. The reduction rate reached about 50% for all agents, except garlic squeeze (40%), even at its highest dose level. Amongst the six agents, grapeseed extract exhibited the strongest inhibition to the DNA adduct formation. Therefore, we may arrive at a point that these dietary constituents are beneficial to prevent the harmful adduct formation, and thus to block the potential carcinogenesis induced by nicotine.

Animals↗
PubMed2003

Transportation and fate of cationic surfactant in river water.

The degradation, sorption, transportation and material balance of cationic surfactants discharged from domestic waste into river water was studied. Ion-pair solid-phase extraction behavior showed that the sorption of cationic surfactants as an ion-pair with anionic surfactant onto river sediment was so strong that little cationic surfactant was found in the bulk water. Cationic surfactant was found in river sediment at more than 500 times higher concentration than that in the bulk water. The degradation of the cationic surfactant was very slow in river water and much slower in the sediment. A material balance of cationic surfactant was estimated for a river running through Toyama City by measuring the flow rate and the concentration of cationic surfactant in the water at several points. It was found that more than 30% of cationic surfactant introduced to the river was lost during the river running through ca. 3 km in 3 h. This reduction probably comes from a quick transfer of the cationic surfactant from river water to sediment and water weed by means of adsorption or precipitation with suspending solids.

Adsorption↗
PubMed2003

Regeneration of bleaching clay waste by chemical activation with chloride salts.

Spent bleaching earth (SBE) was regenerated by chemical activation with low cost and low pollution chlorides as activating agents. Under the conditions of activation temperature of 600d egrees C and holding time of 1 h investigated, results show that fresh bleaching earth and regenerated bleaching earth are type IV with hysteresis loops corresponding to type H3 from nitrogen adsorption-desorption isotherms, indicating slit-shaped mesoporous structure. It is also found that the effect of the regeneration treatment studied in the present work on the pore structures and chemical properties of the resulting solids is negligible compared to the fresh bleaching earth. On the other hand, the pore properties of these chemically activated solids are higher than those of the sample regenerated from heat regeneration, but only approximate 45% of surface area are reclaimed. It implies that the carbon residues could be retained within pores and/or clogs the entrance of pores, resulting in a decrease in pore properties.

Adsorption↗
PubMed2001

Adsorption of acid dye onto activated carbons prepared from agricultural waste bagasse by ZnCl2 activation.

A series of activated carbons were prepared from agricultural waste sugarcane bagasse by chemical activation with zinc chloride (ZnCl2) as an activating agent at 500 degrees C and 0.5 h soaking time. The Langmuir surface area and total pore volume were used to estimate the average pore diameter of the carbon products. The values of the surface area and pore volume increased linearly with increase in the impregnation ratio (IR) up to 100 wt%. The adsorption capacities of the derived adsorbents for Acid Orange 10 were measured at 20 degrees C and 40 degrees C to gain further insights into the acidic surface oxides of the adsorbent from the results of Fourier transform infrared (FTIR) spectroscopy analysis and pH measurement. Adsorption isotherms of the acid dye on adsorbents prepared were determined and correlated with common isotherm equations. It was found that the Langmuir model appears to fit the isotherm data better than the Freundlich model. The physical properties of these adsorbents were consistent with the parameters obtained from the isotherm equations.

Adsorption↗
PubMed2001

Preparation of activated carbons from corn cob catalyzed by potassium salts and subsequent gasification with CO2.

In the present study, granular activated carbons were prepared from agricultural waste corn cob by chemical activation with potassium salts and/or physical activation with CO2. Under the experimental conditions investigated, potassium hydroxide (KOH) and potassium carbonate (K2CO3) were effective activating agents for chemical activation during a ramping period of 10 degrees C/min and subsequent gasification (i.e., physical activation) at a soaking period of 800 degrees C. Large BET surface areas (>1,600 m2/g) of activated carbons were thus obtained by the combined activation. In addition, this study clearly showed that the porosity created in the acid-unwashed carbon products is substantially lower than that of acid-washed carbon products due to potassium salts left in the pore structure.

Carbon↗
PubMed2001

Characterization of activated carbons prepared from sugarcane bagasse by ZnCl2 activation.

Activated carbons were prepared from the agricultural waste of sugarcane bagasse by the chemical activation with zinc chloride (ZnCl2) at the activation temperature of 500 degrees C with soaking time of 0.5 hour. The influence of activation parameters on the final carbon products was examined by varying the impregnation ratio (i.e., mass ratio of added ZnCl2 to bagasse) and bagasse size. The physical properties of carbon products were characterized by nitrogen adsorption/desorption isotherms (at 77 K) and helium displacement method. The surface area and pore volume of carbons were thus obtained by the BET equation and t-plot method. Also, the particle density and porosity of carbons were estimated by the total pore volume and true density. The increases of the values of surface area and pore volume are approximately proportional to the impregnation ratio. The microporous carbon product with the BET surface area of 905 m2/g and total pore volume of 0.44 cm3/g was obtained in the present study. Further, the adsorption isotherms of two acid dyes from aqueous solutions onto the carbon products were performed at 30 degrees C. The results show that the adsorption isotherms of acid dyes with high molecular weight or large molecular size on the microporous adsorbents of activated carbons are plateau forms, indicating multilayer adsorptions, which may be attributed to the steric hindrance of the adsorbate molecules.

Adsorption↗
PubMed2001

Utilization of agricultural waste corn cob for the preparation of carbon adsorbent.

In the present study, a series of activated carbons were prepared from agricultural waste corn cob by chemical and physical activations with potassium hydroxide (KOH)/potassium carbonate (K2CO3) and carbon dioxide (CO2). The effect of process variables such as impregnation ratio, impregnation time, activation temperature and soaking time of CO2 was studied in order to relate these preparation parameters with the physical properties of final carbon products. The resulting activated carbons were characterized by nitrogen adsorption-desorption isotherms at 77 K. The surface areas and pore volumes of carbons were estimated by the BET equation, the Langmuir equation and the t-plot method. Under the experimental conditions investigated, the main parameters in the activation of corn cob were found to be the impregnation ratio and activation temperature. The soaking time of CO2 is another important variable, which had a strong effect on the pore volume development. The BET surface area and total pore volume were as large as about 2000 m2/g and about 1.0 cm3/g, respectively. This study showed that the activation of agricultural waste corn cob with KOH/K2CO3 and CO2 was suitable for the preparation of large-surface-area activated carbons.

Adsorption↗
PubMed2001

Extraction and separation of cationic surfactants from river sediments: application to a spectrophotometric determination of cationic surfactant in an aquatic environment using membrane filters.

The quantitative extraction of cationic surfactant (CS+) in river sediments was studied. Further, the developed method was applied to the spectrophotometric determination of CS+ in urban river sediment samples by solid-phase extraction with membranes. A mixture of methanol and hydrochloric acid was proposed as an eluent. Dried sediment was digested in the eluent under ultrasonic irradiation. After elution, the eluent was evaporated to almost dryness. The residue was dissolved in a small volume of methanol and diluted to a certain volume with water. The pH of the solution was adjusted to 4-5 to separate iron and some other metals as precipitates of hydroxides. The solution was passed through two-piled membranes: first glass-fiber and then polytetrafluoroethylene (PTFE) membranes. A small volume of methanol was passed through the membranes to elute any CS+ retaining on the membranes. After passing the methanol solution through a cationic exchange resin column, the retained CS+ was eluted with methanol containing a high concentration of sodium chloride. Water, Bromophenol Blue (BPB) and hydrochloric acid were added to the solution. The solution was passed through a mixed cellulose ester membrane filter to retain an ion associate of CS+.BPB-. The retained ion associate was dissolved in a small volume of N,N-dimethylformamide together with the membrane filter, followed by the addition of triethanolamine to make the solution alkaline. The absorbance due to BPB2- was measured at 603 nm against a reagent blank. This method was applied to the determination of CS+ in river water and sediment. A cationic surfactant in sediments at 10(-5) mol kg-1 levels was detected with satisfactory precision. It was found that CS+ was about 500-fold enriched in the sediment from water at the place where domestic wastewater was discharged.

Benzalkonium Compounds↗
PubMed1999

Human chromosome 3 and pig chromosome 13 show complete synteny conservation but extensive gene-order differences.

A comparative map of human chromosome 3 (HSA 3) and pig chromosome 13 (SSC 13) was constructed using physically assigned pig sequence-tagged sites (STSs). Pig STSs representing 11 HSA 3 genes, including v-Raf-1 murine leukemia viral oncogene homolog 1 (RAF1), retinoic acid beta receptor (RARB), cholecystokinin (CCK), pituitary transcription factor 1 (POU1F1), ceruloplasmin (CP), guanine nucleotide binding protein, alpha-inhibiting polypeptide 2 (GNAI2), sucrase-isomaltase (SI), rhodopsin (RHO), dopamine receptor D3 (DRD3), growth-associated protein 43 (GAP43), and somatostatin (SST), were developed. Ten pig STSs were regionally mapped using a somatic cell hybrid panel (SCHP) to SSC 13 with 80-100% concordance. Large-insert probes were obtained by screening a pig yeast artificial chromosome (YAC) library with primers for each STS. Several YACs were identified for DRD3, GAP43, POU1F1, RHO, SI, and SST for fluorescence in situ hybridization (FISH) mapping. Single gene and bi-color FISH with each pairwise combination were used to further define the gene order on SSC 13. While these data confirm chromosome painting results showing that HSA 3 probes hybridize to a major portion of SSC 13, they also demonstrate extensive gene-order differences between man and pig within this large conserved synteny group. Interestingly, several conserved chromosomal regions have been detected between pig and mouse that are not conserved between man and mouse, suggesting that the SSC 13 gene arrangement may be the closest to that of the ancestral eutherian chromosome.

Animals↗
PubMed1997

Application of chromosome 4q35-qter marker (pFR-1) for DNA rearrangement of facioscapulohumeral muscular dystrophy patients in Taiwan.

Facioscapulohumeral muscular dystrophy (FSHD) has been found to be linked to chromosome 4qter. A chromosome 4q35-ter marker, pFR-1 (subclone of the cosmid c51), has been recently isolated and used as a probe for mapping near, or within, the FSHD gene. To examine FSHD-associated DNA rearrangements in the Taiwan population, we used the pFR-1 probe to perform Southern blot analysis on 142 individuals, including 32 FSHD patients within 9 autosomal dominant families, five sporadic FSHD patients from 4 families (include one pair of twins), three sporadic scapuloperoneal syndrome (SPS) patients and two sporadic polymyositis patients with their unaffected parents, and 29 healthy controls. In 29 healthy individuals, 3 SPS and 2 polymyositis patients with their families, probe pFR-1 analysis revealed that all had polymorphic restriction fragments that were larger than 28 kb in length. All but 1 FSHD-affected individual had specific smaller EcoRI fragments (ranging in size from 10.5 to 27 kb). Two point linkage analysis between pFR-1 and the FSHD locus provided significant evidence for FSHD linkage (Z(max)=6.84). A similar smaller fragment was also present in 5 sporadic patients, while this smaller fragment could not be found in one of their parents. Identical EcoRI restriction fragment length polymorphism (RFLP) patterns linked to FSHD were shown in the monozygotic twins, even though they showed extreme variability in the expression of FSHD. We conclude that the pFR-1 probe is a tightly linked marker of FSHD and can be used to detect most DNA rearrangements associated with this disease in the Taiwan population. However, the same RFLP patterns may represent extreme variability in the expression of the FSHD gene.

Adolescent↗
PubMed1991

A unique human IgE-binding epitope on the Bermuda grass pollen recognized by mouse lambda-type monoclonal antibodies.

A group of six mouse monoclonal antibodies (MoAbs) with the unusual lambda-type light chain were generated by fusion of NS-1 cells with splenic cells derived from BALB/c mice immunized with crude extracts of Bermuda grass pollen (BGP). Four of them were IgG1, one was IgG2b, and one was IgG3. Binding inhibition assay showed that they recognized the same (or very similar) epitope. Using sera from BGP-allergic patients, it was found that the specific binding between the IgE antibodies and the MoAb 26-11-fixed antigen could be blocked by MoAb 26-11 itself and another MoAb 9-13 in a dose-dependent manner. It appears that the epitope recognized by the lambda-type MoAbs is a human IgE-binding antigenic determinant. Further physico-chemical analyses showed that this epitope was stable under heat but sensitive to treatments of sodium periodate and proteinase K. Results from these studies indicate that this unique epitope which leads to the generation of lambda-type MoAbs is part of a glycoprotein.

Animals↗