PubMed Health⌕ Search

Biomedical subjects

H Küchenhoff

Publications and source records attributed to H Küchenhoff.

10 recordsLinked to original sources

[Significance of multiple organ failure for the prognosis of surgical intensive care patients].

BACKGROUND: The association of multiple organ failure and acute prognosis is an established fact in intensive care medicine. However, it is unclear whether the number of failing organs is an independent determinant of acute mortality, and whether there are additional effects on long-term outcome. METHODS: We performed a retrospective, observational cohort study using prospectively collected data from March 1993, through February 2005. Three different cohorts were analysed: patients with a short-term intensive care unit (ICU) stay (group I, ICU length of stay > 4 days), with a long-term ICU stay (group II, ICU length of stay > 28 days), and all patients requiring renal replacement therapy during ICU stay (group III). Organ failure was defined according to a modified Goris score. An independent effect of the number of failing organs on patient prognosis was evaluated after adjusting for more than 15 covariables. Acute prognosis was analysed in group I, whereas long-term prognosis was studied in groups II and III. RESULTS: The maximum number of failing organs was an independent determinant of acute prognosis in patients of group I, and of long-term prognosis in groups II and III. CONCLUSION: The effect of multiple organ failure on long-term prognosis emphasizes the importance of this variable for patient outcome. Therefore, multiple organ failure must be part of all therapeutic concepts in critical care. Within those, preventive measures are definitively preferable to keep the number of failing organs as small as possible.

APACHE↗

[Trends in surgical intensive care. Experience in one centre over 12 years].

BACKGROUND: For critically ill medical patients until the year 2000, increases in patient age and severity of disease but also acute prognosis have been described. Since then, further improvement appears possible. Several controlled studies have recently demonstrated that acute mortality may be further lowered by new adjuvant therapies such as aggressive glycemic control. However, it is still unknown whether demographic changes and progress in intensive care can be reproduced in surgical critically ill patients outside of a controlled trial setting. METHODS: We performed a retrospective, observational cohort study using data prospectively collected from the surgical intensive care unit (ICU) of the LMU Department of Surgery in Munich, Germany, Grosshadern Campus, from March 1 1993 through February 28 2005. Since 1999 we have successively introduced a variety of new therapies to daily routine. A cohort of 5,495 patients was analysed. RESULTS: We identified reduced ICU mortality during the observation period, although age rose simultaneously and disease severity remained constant. Results from multivariate analysis suggest that improvements in prognosis essentially result from the implementation of new therapies after 2001. After adjusting for more than 20 covariables, treatment received after 2001 was identified as an independent factor linked with reduced risk of death. CONCLUSIONS: General demographic trends and progress in intensive care can be demonstrated also in unselected surgical cohorts. Furthermore, the results here confirm the efficacy of new therapeutic modifications in routine therapy.

APACHE↗

[How about the uncertainty in the haplotypes in the population-based KORA studies?].

In the KORA surveys, numerous candidate genes in the context of type 2 diabetes, myocardial infarction, atherosclerosis or obesity are under investigation. Current focus is on genotyping single nucleotide polymorphism (SNPs). Haplotypes are also of increasing interest: haplotypes are combinations of alleles within a certain section of one chromosome. Analysing haplotypes in genetic association studies is often more efficient than studying the SNPs separately. A statistical problem in this context is the reconstruction of the phase: genotyping the SNPs determines the alleles of an individual at one particular locus of the DNA, but does not reveal which allele is located on which one of the two chromosomes. This information is required when talking about haplotypes. There are statistical approaches to identify the most likely two haplotypes of an individual given the genotypes. However, a certain error in prognosis is unavoidable. There are also errors in the genotypes. These errors are assumed to be small for one SNP but can accumulate over the SNPs involved in one haplotype and thus can induce further uncertainty in the haplotype. It is therefore the aim of our project to quantify the uncertainties in the haplotypes particularly for genes investigated in the KORA surveys. We conduct computer simulations based on the haplotypes and their frequencies observed in the KORA individuals and compare the results with simulations based on mathematical modelling of the evolutionary process ("coalescent models"). The uncertainties in the haplotypes have an impact on the search for association between genes and disease: an association may not be detected as the haplotype uncertainty obscures the haplotype frequency differences between cases and controls. It is a further aim of our project to elucidate the extent of this problem and to develop strategies for reducing it.

Adult↗

Two dimensions of measurement error: classical and Berkson error in residential radon exposure assessment.

Measurement error in exposure assessment is unavoidable. Statistical methods to correct for such errors rely upon a valid error model, particularly regarding the classification of classical and Berkson error, the structure and the size of the error. We provide a detailed list of sources of error in residential radon exposure assessment, stressing the importance of (a) the differentiation between classical and Berkson error and (b) the clear definitions of predictors and operationally defined predictors using the example of two German case-control studies on lung cancer and residential radon exposure. We give intuitive measures of error size and present evidence on both the error size and the multiplicative structure of the error from three data sets with repeated measurements of radon concentration. We conclude that modern exposure assessment should not only aim to be as accurate and precise as possible, but should also provide a model of the remaining measurement errors with clear differentiation of classical and Berkson components.

Bias↗

On the potential of measurement error to induce differential bias on odds ratio estimates: an example from radon epidemiology.

It is well established that odds ratios estimated by logistic regression are subject to bias if exposure is measured with error. The dependence of this bias on exposure parameter values, particularly for multiplicative measurement error, and its implications in epidemiology are not, however, as fully acknowledged. We have been motivated by a German West case-control study on lung cancer and residential radon, where restriction to a subgroup exhibiting larger mean and variance of exposure than the entire group has shown higher odds ratio estimates as compared to the full analysis. By means of correction formulae and simulations, we show that bias from additive classical type error depends on the exposure variance, not on the exposure mean, and that bias from multiplicative classical type error depends on the geometric standard deviation (in other words on the coefficient of variation of exposure), but not on the geometric mean of exposure. Bias from additive or multiplicative Berkson type error is independent of exposure distribution parameters. This indicates that there is a potential of differential bias between groups where these parameters vary. Such groups are commonly compared in epidemiology: for example when the results of subgroup analyses are contrasted or meta-analyses are performed. For the German West radon study, we show that the difference of measurement error bias between the subgroup and the entire group exhibits the same direction but not the same dimension as the observed results. Regarding meta-analysis of five European radon studies, we find that a study such as this German study will necessarily result in smaller odds ratio estimates than other studies due to the smaller exposure variance and coefficient of variation of exposure. Therefore, disregard of measurement error can not only lead to biased estimates, but also to inconsistent results and wrongly concluded effect differences between groups.

Air Pollutants, Radioactive↗

Bayesian analysis of logistic regression with an unknown change point and covariate measurement error.

We discuss Bayesian estimation of a logistic regression model with an unknown threshold limiting value (TLV). In these models it is assumed that there is no effect of a covariate on the response under a certain unknown TLV. The estimation of these models in a Bayesian context by Markov chain Monte Carlo (MCMC) methods is considered with focus on the TLV. We extend the model by accounting for measurement error in the covariate. The Bayesian solution is compared with the likelihood solution proposed by Küchenhoff and Carroll using a data set concerning the relationship between dust concentration in the working place and the occurrence of chronic bronchitis.

Bayes Theorem↗

Perinatal mortality in Germany following the Chernobyl accident.

Perinatal mortality in Germany was investigated with respect to a possible relationship to the nuclear accident in Chernobyl on April 26, 1986. Using annual data of perinatal mortality, a trend analysis based on an appropriately chosen statistical model was performed which showed a significant increase in 1987. In addition, we calculated the cesium concentration in women's bodies using data of the cesium concentration in milk. We found two peaks of cesium concentration that were associated with the observed two peaks of monthly perinatal mortality data with a delay of 7 months.

Cesium Radioisotopes↗

Segmented regression with errors in predictors: semi-parametric and parametric methods.

We consider the estimation of parameters in a particular segmented generalized linear model with additive measurement error in predictors, with a focus on linear and logistic regression. In epidemiologic studies segmented regression models often occur as threshold models, where it is assumed that the exposure has no influence on the response up to a possibly unknown threshold. Furthermore, in occupational and environmental studies the exposure typically cannot be measured exactly. Ignoring this measurement error leads to asymptotically biased estimators of the threshold. It is shown that this asymptotic bias is different from that observed for estimating standard generalized linear model parameters in the presence of measurement error, being both larger and in different directions than expected. In most cases considered the threshold is asymptotically underestimated. Two standard general methods for correcting for this bias are considered; regression calibration and simulation extrapolation (simex). In ordinary logistic and linear regression these procedures behave similarly, but in the threshold segmented regression model they operate quite differently. The regression calibration estimator usually has more bias but less variance than the simex estimator. Regression calibration and simex are typically thought of as functional methods, also known as semi-parametric methods, because they make no assumptions about the distribution of the unobservable covariate X. The contrasting structural, parametric maximum likelihood estimate assumes a parametric distributional form for X. In ordinary linear regression there is typically little difference between structural and functional methods. One of the major, surprising findings of our study is that in threshold regression, the functional and structural methods differ substantially in their performance. In one of our simulations, approximately consistent functional estimates can be as much as 25 times more variable than the maximum likelihood estimate for a properly specified parametric model. Structural (parametric) modelling ought not be a neglected tool in measurement error models. An example involving dust concentration and bronchitis in a mechanical engineering plant in Munich is used to illustrate the results.

Bias↗