Biomedical subjects

Hélène Parrot-Lopez

Publications and source records attributed to Hélène Parrot-Lopez.

5 recordsLinked to original sources

PubMed2005

Synthesis and characterisation of novel nanospheres made from amphiphilic perfluoroalkylthio-beta-cyclodextrins.

This work describes the synthesis of new amphiphilic perfluorohexyl- and perfluorooctyl-propanethio-beta-cyclodextrins and the comparison of the ability of these molecules and alkyl analogue, nonanethio-beta-cyclodextrin to form nanospheres. Nanospheres were prepared using nanoprecipitation method (perfluoroalkylthio-beta-cyclodextrin in THF [0.11 x 10(-3)M], stirring rate 700rpm, addition of aqueous phase at 64 degrees C into organic phase at 50 degrees C). They were characterised by Photon Correlation Spectroscopy (PCS) and by electron microscopy (SEM and cryo-TEM). The nanospheres prepared from these new beta-cyclodextrin derivatives have an average size of 260nm, and appear to be spherical in cryo-TEM images. Whereas alkyl analogue forms polydisperse aggregates with sizes in the range 60-350nm.

Alkylation↗

PubMed2003

Synthesis and characterisation of sulfated amphiphilic alpha-, beta- and gamma-cyclodextrins: application to the complexation of acyclovir.

The synthesis of sulfated amphiphilic alpha-, beta- and gamma-cyclodextrins was achieved according to the standard protection-deprotection procedure. The formation of inclusion complexes between the amphiphilic alpha-, beta- and gamma-cyclodextrins and an antiviral molecule, acyclovir (ACV) was investigated by UV-visible spectroscopy (UV-Vis) and electrospray ionisation mass spectrometry (ESIMS). UV-Vis spectroscopy allowed determination of the stoichiometry and stability constants of complexes, whereas ESIMS, a soft ionisation technique, allowed the detection of the inclusion complexes. The results showed that the non-sulfated amphiphilic cyclodextrins exhibit a 1:2 stoichiometry with acyclovir, while sulfated amphiphilic cyclodextrins, except gamma-cyclodextrin, exhibit a 1:1 stoichiometry indicating the loss of one interaction site. Non-covalent interactions between acyclovir and non-sulfated amphiphilic cyclodextrins appear to take place both in the cavity of the cyclodextrin and inside the hydrophobic zone generated by alkanoyl chains. In contrast, in the case of sulfated amphiphilic cyclodextrins, the interactions appear to involve only the hydrophobic region of the alkanoyl chains.

Acyclovir↗

PubMed2003

Interfacial interactions between amphiphilic cyclodextrins and physiologically relevant cations.

The compression isotherms of a series of amphiphilic cyclodextrins, formed (a) by acylation at the secondary hydroxyl face and (b) by acylation accompanied by varying degrees of sulfatation (DS) at the primary hydroxyl face (DS=0, 4, and 7), have been studied on subphases of pure water and of water containing NaCl, KCl, MgCl(2), and CaCl(2) at inter- and extracellular concentrations. The formation of solid lipid nanoparticles (SLNs) by two of the molecules has been observed, while these do not aggregate at concentrations of monovalent salts up to 150 mM for the sulfated derivative. In the presence of divalent salts one of these with a DS=0 for sulfatation degree flocculates at divalent salt concentrations below 0.1 mM while the other with a DS=4 flocculates at Mg(2+) concentration above 5 mM and a Ca(2+) concentration above 3 mM. AFM noncontact mode imaging has been carried out, in air, for the SLNs deposited on mica.

Cations↗

PubMed2003

Scanning electron microscopy and atomic force microscopy imaging of solid lipid nanoparticles derived from amphiphilic cyclodextrins.

Scanning electron microscopy (SEM) and atomic force microscopy (AFM) have been applied to the imagery of solid lipid nanoparticles (SLNs) formulated from an amphiphilic cyclodextrin, 2,3-di-o-alkanoyl-beta-cyclodextrin, beta-CD21C6. Comparison of the results shows that the vacuum drying technique used in sample preparation for SEM causes shrinkage in the size of the SLNs, whereas the deposition method used for AFM causes the SLNs to form small clusters. The hydrodynamic diameter determined from photon correlation spectroscopy (PCS) is 359+/-15 nm and the zeta potential is -25 mV.

Cyclodextrins↗

PubMed2002

Molecular recognition by Kluyveromyces of amphotericin B-loaded, galactose-tagged, poly (lactic acid) microspheres.

In an effort to develop a new way of drug delivery, especially for polyenic antifungal molecules, we have incorporated amphotericin B (AmB) into biodegradable galactosylated poly (L-lactic acid) (L-PLA) and poly (L-lactic-co-glycolic acid) (PLGA) microspheres. These drug carriers were prepared by solvent evaporation using an oil/water (o/w) emulsion. The ratio of galactosyl spacers with different chain lengths was 1.74-2.78%. The maximal quantity of AmB encapsulated reported to 100 mg of the galactosylated microspheres was 7.14 mg for L-PLA (encapsulation rate 45% of mole) and 6.42 mg for PLGA derivatives (encapsulation rate 81% of mole). In our yeast model, drug release depended on three factors: (i) presence of galactosylated antennae, (ii) length of galactosyl antenna and (iii) nature of the polymer. More of the AmB trapped in PLGA microspheres was released than from PLA microspheres. These novel functionalised microspheres could be required for the delivering of therapeutic agents according to their recognition to specific cells.

Amphotericin B↗