Biomedical subjects

Harry L Tuller

Publications and source records attributed to Harry L Tuller.

3 recordsLinked to original sources

PubMed2006

Microsphere templating as means of enhancing surface activity and gas sensitivity of CaCu(3)Ti(4)O(12) thin films.

Chemical and physical synthesis routes were combined to prepare macroporous CaCu(3)Ti(4)O(12) thin films by pulsed laser deposition onto poly(methyl methacrylate) (PMMA) microsphere templated substrates. These films showed remarkably enhanced gas sensitivity compared with control films deposited on untreated substrates, demonstrating the virtues of combining thin film physical vapor deposition (PVD) techniques in concert with colloidal templates to produce macroporous structures of inorganic films with enhanced surface activity for applications in chemical sensors, catalysts, and fuel cells.

Calcium↗

PubMed2006

Ultrasensitive chemiresistors based on electrospun TiO2 nanofibers.

Nanostructured semiconducting metal oxides and particularly single nanowire devices offer exceptional gas sensitivity but at the expense of statistical variations and excessive noise levels. In this study TiO2/poly(vinyl acetate) composite nanofiber mats were directly electrospun onto interdigitated Pt electrode arrays, hot pressed at 120 degrees C, and calcined at 450 degrees C. This resulted in a novel multiple nanowire network composed of sheaths of 200-500 nm diameter cores filled with readily gas accessible approximately 10 nm thick single-crystal anatase fibrils. TiO2 nanofiber sensors tested for NO2, in dry air, exhibited exceptional sensitivity showing with, for example, a 833% increase in sensor resistance when exposed to 500 ppb NO2 at 300 degrees C, consistent with a detection limit estimated to be well below 1 ppb. Unusual response patterns were observed at high NO2 concentrations (> 12.5 ppm), consistent with n to p inversion of the surface-trap limited conduction facilitated by the high surface-to-volume ratio of this material.

Crystallization↗

PubMed2004

Diffusion-related implications for langasite resonator operation.

Oxygen and gallium diffusivities in langasite were experimentally determined by analysis of diffusion profiles of 18O and 71Ga tracers by SIMS analysis as functions of temperature and doping. Strontium-enhanced diffusivities and activation energies of approximately 1.2+/-0.2 eV confirm the predominant role of oxygen vacancies in controlling the electrical conductivity of langasite at elevated temperature and oxygen partial pressure. The potential impact of high levels of porosity and the use of an oxygen primary ion beam on the accuracy of some of the data is discussed. The gallium diffusivity, with activation energy of 3.13 eV, was found to be more than two orders of magnitude lower than that of oxygen. Surface exchange measurements enabled estimation of gallium loss at elevated temperatures and oxygen partial pressure; the level is not believed to be of major concern for resonator performance.

Journal Article↗