PubMed Health⌕ Search

Biomedical subjects

Hee-Tae Jung

Publications and source records attributed to Hee-Tae Jung.

12 recordsLinked to original sources

Photoluminescence properties of a perfluorinated supramolecular columnar liquid crystal with a pyrene core: effects of the ordering and orientation of the columns.

We investigated the effects of the alignment and ordering of pi-conjugated perfluorinated dendrimers containing pyrene moieties in their cores on their photoluminescence (PL) properties. The pyrene molecules are stacked in columns surrounded by aromatic and semifluorinated tails, which can be conjugated and act as chromophores. Polarized light microscopy (PLM), cross-sectional scanning electron microscopy (SEM), and atomic force microscopy (AFM) results show that variation of the cooling rate of the dendrimers produces variation in their orientation and ordering: Slow cooling (approximately <0.5 degrees C/min) of the isotropic melt in a sandwich glass cell results in a high degree of ordering and the vertical alignment of the columns on the substrate, in which the stacked pyrene molecules are oriented parallel to the surface over large areas. In contrast, rapid cooling (approximately >10 degrees C/min) leads to the planar alignment of the columns with significant disorder on the same substrate. UV-vis, PL, SEM, and AFM results show that the quenched columns with a planar orientation produce a broad emission band and a second weak shoulder, which indicates the presence of isolated molecules. However, the high degree of ordering of the columns with a vertical alignment produces a red-shift in the PL spectrum, with very few isolated molecules. By comparing two films with different alignments but similar ordering, we show that the ordering of this material has a greater influence on the PL spectrum than the alignment. This effect of the ordering of the columns was further verified by comparing the optical properties of the isolated dendrimers with those of small pi-conjugated molecules in solution and solid films.

Journal Article↗

Patterned arrays of au rings for localized surface plasmon resonance.

In this paper, we examined the characteristic behavior of localized surface plasmon resonances (LSPR) of Au dot and ring arrays in response to the selective binding of biomolecules. To do this, patterned arrays of Au rings and dots with various feature scales were fabricated over large areas by an imprint lithography technique. Our results showed that the LSPR spectra of the Au nanorings exhibited a blue shift with increase in the ring widths and asymptotically converged to those for Au nanodots. This clearly implies that the LSPR spectra can be tuned over an extended wavelength range by varying the ring width. For an illustrative purpose, the patterned Au structures were used to detect the binding of streptavidin to biotin. In doing this, the Au patterns were chemically modified with G4 dendrimers of amine terminated poly(amidoamine), which facilitated the tethering of biotin onto the Au pattern. Exposure of the biotinylated Au nanorings to aqueous streptavidin solution induced both red-shifts of the LSPR spectra and changes in the peak intensities. The sensitivity of the LSPR spectra to the binding of the biomolecules was enhanced as the ring width of Au rings was decreased.

Biotin↗

Synthesis and characterization of ultrahigh crystalline TiO2 nanotubes.

Ultrahigh crystalline TiO2 nanotubes were synthesized by hydrogen peroxide treatment of very low crystalline titania nanotubes (TiNT-as prepared), which were prepared with synthesized TiO2 nanoparticles by hydrothermal methods in an aqueous NaOH solution. Thus, prepared ultrahigh crystalline TiO2 nanotubes (TiNT-H2O2) showed comparable crystallinity with high crystalline TiO2 nanoparticles. The details of nanotubular structures were elucidated by high resolution-transmission electron microscopy (HR-TEM), field emission-scanning electron microscopy (FE-SEM), energy-dispersive X-ray analysis in transmission electron microscopy (TEM-EDX), X-ray diffraction (XRD), photoluminescence (PL), and BET surface area. TiNT-H2O2 was found to be a multiwalled anatase phase only with an average outer diameter of approximately 8 nm and an inner diameter of approximately 5 nm and grown along the [001] direction to 500-700 nm long with an interlayer fringe distance of ca. 0.78 nm. The photocatalytic activity of TiNT-H2O2 was about 2-fold higher than those of TiNT-as prepared, synthesized TiO2 nanoparticles, and TiO2-P25 (Degussa) in the photocatalytic oxidation of trimethylamine gas under UV irradiation.

Catalysis↗

Patterning of single-wall carbon nanotubes via a combined technique (chemical anchoring and photolithography) on patterned substrates.

Single-walled carbon nanotubes (SWNTs) have been chemically attached with high density onto a patterned substrate. To form the SWNT pattern, the substrate was treated with acid-labile group protected amine, and an amine prepattern was formed using a photolithographic process with a novel polymeric photoacid generator (PAG). The polymeric PAG contains a triphenylsulfonium salt on its backbone and was synthesized to obtain a PAG with enhanced efficiency and ease of spin-coating onto the amine-modified glass substrate. The SWNT monolayer pattern was then formed through the amidation reaction between the carboxylic acid groups of carboxylated SWNTs (ca-SWNTs) and the prepatterned amino groups. A high-density multilayer was fabricated via further repeated reaction between the carboxylic acid groups of the ca-SWNTs and the amino groups of the linker with the aid of a condensation agent. The formation of covalent amide bonding was confirmed by X-ray photoelectron spectroscopy (XPS) analysis. Scanning electron microscopy and UV-vis-near-IR results show that the patterned SWNT films have uniform coverage with high surface density. Unlike previously reported patterned SWNT arrays, this ca-SWNT patterned layer has high surface density and excellent surface adhesion due to its direct chemical bonding to the substrate.

Amides↗

Surface ordering of a perfluorinated, self-assembled, dendrimer on a water subphase.

We have investigated the surface ordering of a synthetic, asymmetric, fan-shaped dendrimer containing a carboxyl core and perfluorinated tails which was obtained by the esterification of the intermediary. X-ray diffraction patterns and transmission electron microscopy (TEM) images show the molecules self-assemble into a hexagonal, cylindrical mesophase. Surface pressure-area isotherms and Brewster angle microscopy measurements show the molecule forms a stable monolayer at the air-water interface with a single phase transition. As a condensed monolayer, the perfluorinated tails are well-packed with hexagonal symmetry with (10) spacing of approximately 0.5 nm from molecular-scale atomic force microscopy (AFM) images. Such dense molecular-scale packing has not been observed in other dendritic molecules thus far. Compared to the case of conventional dendritic molecules with alkyl tails, these molecules occupy a much smaller molecular area due to the strong microphase separation between the carboxylic core and perfluorinated tails at the air-water interface. After monolayer collapse, the irregular islands with terrace morphology are observed in contrast with conventional alkyl-terminated self-assembled dendritic molecules where irregular islands do not appear. The interfacial and internal structure of every terrace shows planar columnar morphology from AFM and TEM imaging. From these results, we discuss the stability of perfluorinated, self-assembled dendrimers on water, as well as how to generate planar morphology on a hydrophilic surface.

Journal Article↗

Covalent attachment and hybridization of DNA oligonucleotides on patterned single-walled carbon nanotube films.

DNA oligonucleotides were covalently immobilized to prepatterned single-walled carbon nanotube (SWNT) multilayer films by amidation. SWNT multilayer films were constructed via consecutive condensation reactions creating stacks of functionalized SWNT layers linked together by 4,4'-oxydianiline. Aminated- or carboxylated-DNA oligonucleotides were covalently immobilized to the respective carboxylated or aminated SWNT multilayer films through amide bond formation using 1-ethyl-3-(3-dimethylaminopropyl)carbodiimide hydrochloride. UV-vis-NIR spectroscopic analysis indicated that the SWNT film surface density increased uniformly according to the number of reaction cycles. Scanning electron microscopy and contact angle measurements of the SWNT multilayer film revealed a uniform coverage over the substrate surface. The covalent attachment of DNA oligonucleotides to the SWNT multilayer films and their subsequent hybridization with complementary oligonucleotides were verified using X-ray photoelectron spectroscopy and fluorescence-based measurements. This is the first report demonstrating that DNA oligonucleotides can be covalently attached to immobilized SWNT multilayer films. The anchored DNA oligonucleotides were shown to exhibit excellent specificity, realizing their potential in future biosensor applications.

DNA↗

A fusion protein expression analysis using surface plasmon resonance imaging.

A surface plasmon resonance (SPR) imaging system was constructed and used to detect the affinity-tagged recombinant proteins expressed in Escherichia coli. With regards to model proteins, the hexahistidine-ubiquitin-tagged human growth hormone (His(6)-Ub-hGH), glutathione S-transferase-tagged human interleukin-6 (GST-hIL6), and maltose-binding protein-tagged human interleukin-6 (MBP-hIL6) expressed in E. coli were analyzed. The cell lysates were spotted on gold thin films coated with 11-mercaptoundecanol (MUOH)/dextran derivatized with Ni(II)-iminodiacetic acid (IDA-Ni(II)), glutathione, or cyclodextrin. After a brief washing of the gold chip, SPR imaging measurements were carried out in order to detect the bound affinity-tagged fusion proteins. Using this new approach, rapid high-throughput expression analysis of the affinity-tagged proteins were obtained. The SPR imaging protein chip system used to measure the expression of affinity-tagged proteins in a high-throughput manner is expected to be an attractive alternative to traditional laborious and time-consuming methods, such as SDS-polyacrylamide gel electrophoresis (SDS-PAGE) and Western blots.

Affinity Labels↗

Carbon nanotube conducting arrays by consecutive amidation reactions.

Carbon nanotube conducting arrays were constructed via consecutive amidation reactions with the aid of a linker molecule and a condensation agent on a patterned amine-terminated glass substrate. The electrical resistivity of the nanotube films was sensitive to the degree of coverage for the substrate, making it possible to tailor nanotube multilayers suitable for use in micro- or nanoscale electronic devices and circuits.

Journal Article↗

Gold nanolayer-encapsulated silica particles synthesized by surface seeding and shell growing method: near infrared responsive materials.

Gold nanolayer-encapsulated silica particles whose optical resonance is located in 750-900 nm spectral region were synthesized by combining Sn (tin)-surface seeding and a shell growing process. The synthesized composite particles can be potentially used in wide biological fields, due to biocompatibility and a well-known bioconjugation technique of gold layer. Sn atoms, which can act not only as a catalytic surface for reduction of gold but also as a linker between silica surface and gold nanoparticles, were chemically deposited on hydroxylated silica particles. Then, we introduced another reductant with gold chloride in order to produce a multilayer of Au shell. In the process, Au shells grew by the reduction of additional gold ions on the Sn-functionalized silica surface and resulted in the subsequent coalescence and growth of the deposited gold nanoparticles. Finally, a complete gold nanoshell was formed on the silica surface by the one-step method, without a repeated coating process. The deposition of a gold nanolayer on the silica particles was easily controlled by the concentration ratio of Sn-functionalized silica particles and gold chloride solutions. Transmission electron microscopy (TEM) images and optical extinction spectra clearly showed that gold nanolayers were successfully deposited on the silica surface by the novel method. As the gold colloids attached on the silica surface grew, their optical plasmon peak became red-shifted until complete a gold shell was formed. After the gold shell was completed, the optical plasmon resonance became blue-shifted and the extinction spectra were functions of a relative ratio of the core to shell thickness.

Journal Article↗

Self-organization of amphiphilic polymer in vesicle bilayers composed of surfactant mixtures.

Cryogenic transmission electron microscopy (cryo-TEM) and small angle neutron scattering (SANS) are used to investigate the association of amphiphilic polymers consisting of a double-chain hydrophobic tail attached onto poly(ethylene glycol) (PEG) polymer chains into two different systems of equilibrium vesicles. For cetyltrimethylammonium bromide (CTAB)/sodium perfluorohexanoate (FC(5)) vesicle bilayers, the size distribution of the vesicles slightly becomes narrow in the presence of the polymers, suggesting that the wedge-shaped polymers increase the spontaneous curvature of the vesicles. In contrast, the confinement of polymer molecules inside the CTAB/sodium perfluorooctanoate (FC(7)) vesicles that are stabilized by spontaneous curvature causes an abrupt decrease in the bilayer rigidity. By an analysis of vesicle size distribution, it is found that the membrane elasticity of CTAB/FC(7) vesicles is varied considerably from 6k(B)T to 0.3k(B)T, implying the transition of stabilization mechanism from spontaneous curvature to thermal fluctuation in the presence of polymer. The polymer incorporation mechanism into the bilayers is understood, in the comparison of the vesicle radius and size distribution before and after adding polymer, as that the polymer is anchored into the vesicle bilayer owing to hydrophobic property after the adsorption on the surface of the bilayer.

Caproates↗