PubMed Health⌕ Search

Biomedical subjects

Herbert W Roesky

Publications and source records attributed to Herbert W Roesky.

At least 19 recordsLinked to original sources
PubMed2006

A well-defined hydrocarbon-soluble calcium hydroxide: synthesis, structure, and reactivity.

Controlled hydrolysis of a (beta-diketiminate)calcium-amide gave a heteroleptic (beta-diketiminate)calcium-hydroxide complex that is remarkably stable against ligand exchange and formation of Ca(OH)2. The structure of this dimeric complex shows OH- units that symmetrically bridge the Ca2+ ions. This hydrocarbon-soluble calcium hydroxide reacted rapidly with CO2 to produce a gel from which amorphous CaCO3 slowly separated. This reaction behavior allows for sol-gel coating with CaCO3 from an organic solvent. Reaction with benzophenone did not lead to nucleophilic attack of OH- to the carbonyl but gave a red benzophenone adduct instead.

Journal Article↗
PubMed2006

Soluble molecular compounds with the Mg-O-Al structural motif: a model approach for the fixation of organometallics on a MgO surface.

We report a facile route to the molecular compounds with the Mg-O-Al structural motif. The reaction of Mg[N(SiMe3)2]2 (1) with a stoichiometric amount of LAlOH(Me) (2) [L = CH{(CMe)(2,6-iPr2C6H3N)}2] in THF/n-hexane at 0 degrees C results in the formation of the heterobimetallic compound (Me3Si)2NMg(THF)2-O-Al(Me)L (3) in high yield. The similar reaction of 1 equiv of Mg[N(SiMe3)2]2 and 2 equiv of LAlOH(Me) results in the formation of trimetallic compound L(Me)Al-O-Mg(THF)2-O-Al(Me)L (4). Structural analyses of 3 and 4 have been carried out, revealing the presence of the Mg-O-Al motif. A tentative assignment of the Mg-O-Al vibrations has been made and was supported by calculations.

Journal Article↗
PubMed2006

A supramolecular hexameric ring from alumazene and methylsulfonate.

A dealkylsilylation reaction of alumazene [2,6-(i-Pr)2C6H3NAlMe]3 (1) with trimethylsilyl methylsulfonate in a 1:2 molar ratio in toluene afforded a supramolecular cyclic hexamer {Me[2,6-(i-Pr)2C6H3NAl]3(O3SMe)2}6 (2) composed of six intact alumazene rings and possessing two types of bridging sulfonate groups. Changing the reagent molar ratio to 1:3 caused the third sulfonate to partially substitute the last alumazene methyl group in an eta2 fashion and introduced a disorder in the crystal lattice.

Journal Article↗
PubMed2006

Unusual In2N4 cores in complexes containing triazole-based chalcogen-phosphoranyl ligands.

The 4,5-bis(diphenylphosphoranyl)-1,2,3-triazole [4,5-(P(E)Ph2)2tz] derivatives of indium {kappa3-N,N',E-[4,5-(P(E)Ph2)2(mu-tz)]InMe2}2 (E = O2, S3, Se4) were prepared in good yield. In addition, compound 5 (E = O, E' = Se) was obtained from 4 through the replacement of a selenium atom in the P-Se(In) moiety by an oxygen atom, giving the mixed-chalcogen complex. The crystal structures of 2 and 5 exhibit a central C4In2N6O2P4core with an almost planar arrangement (mean deviation = 0.019 and 0.042 A for 2 and 0.100 A for 5), while the C4In2N6S2P4 core in 3 is nonplanar (mean deviation = 0.223 A).

Journal Article↗
PubMed2006

Aluminacyclopropene: syntheses, characterization, and reactivity toward terminal alkynes.

Reactions of LAl with ethyne, mono- and disubstituted alkynes, and diyne to aluminacyclopropene LAl[eta2-C2(R1)(R2)] ((L = HC[(CMe)(NAr)]2, Ar = 2,6-iPr2C6H3); R1 = R2 = H, (1); R1 = H, R2 = Ph, (2); R1 = R2 = Me, (3); R1 = SiMe3, R2 = C[triple bond]CSiMe3, (4)) are reported. Compounds 1 and 2 were obtained in equimolar quantities of the starting materials at low temperature. The amount of C2H2 was controlled by removing an excess of C2H2 in the range from -78 to -50 degrees C. Compound 4 can be alternatively prepared by the substitution reaction of LAl[eta2-C2(SiMe3)2] with Me3SiC[triple bond]CC[triple bond]CSiMe3 or by the reductive coupling reaction of LAlI2 with potassium in the presence of Me3SiC[triple bond]CC[triple bond]CSiMe3. The reaction of LAl with excess C2H2 and PhC[triple bond]CH (<1:2) afforded the respective alkenylalkynylaluminum compounds LAl(CH=CH2)(C[triple bond]CH) (5) and LAl(CH=CHPh)(C[triple bond]CPh) (6). The reaction of LAl(eta2-C2Ph2) with C2H2 and PhC[triple bond]CH yielded LAl(CPh=CHPh)(C[triple bond]CH) (7) and LAl(CPh=CHPh)(C[triple bond]CPh) (8), respectively. Rationally, the formation of 5 (or 6) may proceed through the corresponding precursor 1 (or 2). The theoretical studies based on DFT calculations show that an interaction between the Al(I) center and the C[triple bond]C unit needs almost no activation energy. Within the AlC2 ring the computational Al-C bond order of ca. 1 suggests an Al-C sigma bond and therefore less pi electron delocalization over the AlC2 ring. The computed Al-eta2-C2 bond dissociation energies (155-82.6 kJ/mol) indicate a remarkable reactivity of aluminacyclopropene species. Finally, the 1H NMR spectroscopy monitored reaction of LAl(eta2-C2Ph2) and PhC[triple bond]CH in toluene-d8 may reveal an acetylenic hydrogen migration process.

Journal Article↗
PubMed2006

Synthesis and characterization of aluminum-containing tin(IV) heterobimetallic sulfides.

Three novel aluminum-containing tin(IV) heterobimetallic sulfides are reported. The reaction of [LAl(SLi)2(THF)2]2 (1) [L = HC(CMeNAr)2, Ar = 2,6-iPr2C6H3] with Ph2SnCl2, Me2SnCl2, and SnCl4 in THF respectively afforded LAl(mu-S)2SnPh2 (2), LAl(mu-S)2SnMe2 (3), and LAl(mu-S)2Sn(mu-S)2AlL (4) in moderate yields. Compounds 2, 3, and 4 were characterized by elemental analysis, NMR, electron-impact mass spectrometry, and single-crystal X-ray structural analysis.

Journal Article↗
PubMed2006

C-H-Activated aluminum hydroxide via molecular oxygen.

The reaction of LAl[eta2-(C2(SiMe3)2)] (1; L = HC[(CMe)(NDipp)]2, Dipp = 2,6-iPr2C6H3) with dioxygen leads to the elimination of bis(trimethylsilyl)acetylene and the formation of the corresponding aluminum monohydroxide via the oxidation of one of the CHMe2 groups on the Dipp ring.

Journal Article↗
PubMed2006

Synthesis, characterization, and hydrolysis of aluminum(III) compounds bearing the C6F5-substituted beta-diketiminate HC[(CMe)(NC6F5)]2 (L) ligand.

A series of Al(III) compounds containing the C6F5-substituted beta-diketiminate ligands LAlMeCl (2), LAlMe2 (3), LAlMeI (4), and LAlBr2 (5) (L = HC[(CMe)(NC6F5)]2) were synthesized and characterized. The hydrolysis of 2 and 4 in the presence of 1,3-diisopropyl-4,5-dimethylimidazol-2-ylidene as the hydrogen halide acceptor both lead to (LAlMe)2(mu-O) (6), a methylalumoxane derivative, which is the first hydrolysis product with the general formula of (RAlMe)(n)O. A comparison of the hydrolysis products of 2 and 4 with that of L'AlMeCl (L' = HC[(CMe)(NAr)]2, Ar = 2,6-iPr2C6H3) shows that with the C6F5-substituted beta-diketiminate ligand, it was not possible to generate LAlMe(OH). This is obviously due to the stronger Brönsted acidity of the proton and the smaller size of the C6F5 group in this compound compared to that of the corresponding 2,6-iPr2C6H3 derivative.

Journal Article↗
PubMed2006

Syntheses, characterization, and X-ray crystal structures of beta-diketiminate group 13 hydrides, chlorides, and fluorides.

A series of organometallic compounds of group 13 metals supported by the sterically encumbered beta-diketiminate ligand containing hydrides, fluorides, chlorides, and bromide have been synthesized and structurally characterized. The synthetic strategy applied utilizes halide metathesis and reduction of metal chlorides to the corresponding hydrides. Thus, the reaction of LLi.OEt2 with MeMCl2 affords LM(Me)Cl (M = Al (1), Ga (2), In (3)) and LGaBr2 (4) with GaBr3. Reduction of LGa(Me)Cl with LiH.BEt3 leads to the formation of LGa(Me)H (10). Synthesis of LGaH(2) (12) has been accomplished by reacting LGaI2 (8) with LiH.BEt3. LAl(Me)Cl (1) and LAlH2 (6) have been converted to LAl(Me)F (5) and LAlF2 (7), respectively. The former was obtained in a reaction of LAl(Me)Cl with Me3SnF while the latter was isolated in a reaction of LAlH2 with BF3.OEt2. Similarly reaction of LGaI2 (8) with Me3SnF affords LGaF2 (9). Compounds reported herein have been characterized by elemental analyses, IR, NMR, EI-MS, and single-crystal X-ray diffraction techniques.

Journal Article↗
PubMed2006

Synthesis, characterization, and X-ray crystal structure of a gallium monohydroxide and a hetero-bimetallic gallium zirconium oxide.

A monomeric hydroxide of gallium, LGa(Me)OH, containing terminal hydroxide and methyl groups was prepared by the hydrolysis of LGa(Me)Cl in the presence of N-heterocyclic carbene and water [L = HC{(CMe)(2,6-i-Pr2C6H3N)}2] in high yield and in a pure form. LGa(Me)OH was used as a synthon to assemble the first hetero-bimetallic compound with a Ga-O-Zr core, [(LGaMe)(Cp2ZrMe)](mu-O).

Crystallography, X-Ray↗
PubMed2006

Low-valent low-coordinated manganese(I) ion dimer: a temperature dependent W-band EPR study.

W-Band EPR spectra of [[HC(CMeNAr)(2)]Mn](2) (Ar = 2,6-(i)Pr(2)C(6)H(3)) have been measured at different temperatures. The spectra show a behavior which is typical for an antiferromagnetically coupled dimer with excited states populating upon increasing temperature. By following the intensity variation of the different features of the spectra with temperature, we attributed different groups of resonances to the S = 1, 2, and 3 states of the dimer. Their corresponding spin Hamiltonian parameters were derived from simulations. The zero-field-splitting parameters measured in this way were D(S=1) = 1.57 cm(-1) and E(S=1) = 0.064 cm(-1), D(S=2) = 0.266 cm(-1) and E(S=2) = 0.0045 cm(-1), and D(S=3) = 0.075 cm(-1) and E(S=3) = 0. On the basis of the molecular structure of the system, we could estimate that zero-field splitting (ZFS) is the result of anisotropic exchange and single-ion anisotropic contributions of similar magnitude (|D| approximately 0.2 cm(-1)). These results allow a deeper insight into the electronic structure of the Mn(I) centers in low-coordination environments, further supporting the electronic structure of Mn(I) to be 4s(1)3d(5), as previously indicated by DFT calculations.

Journal Article↗
PubMed2005

New synthetic approach to yttrium hydroxoacetates, structural characterization, and use as a precursor for coated conductors.

A novel synthetic approach is given for the preparation of a metal-organic lanthanide sol-gel precursor solution and its application for the production of coated conductors. Besides all other problems concerning the technical process itself, the key to a successful deposition of oxide layers is the choice of the precursor solution and the understanding of the mechanism of deposition. Moreover, the isolation and characterization of the species involved in the reaction is very important. Regarding the complex process occurring during the formation of the surface layer, it is obvious that the best choice should have a compound already containing the final composition of the layer. Two compounds of composition [Y(OAc)3(H2O)2]2 and [Y(OAc)3]2(H2O) were isolated from their precursor solution and characterized by X-ray structural analysis. A short outlook will give an insight into the possible bonding mechanisms of the surface layer. These experiments were made with the mixed metal-oxide system yttrium-stabilized zirconium oxide, which is widely used as a substrate for superconducting oxides. A study of the structure of hydrated yttrium acetates, by single-crystal X-ray diffraction, infrared spectra, and elemental analysis demonstrates that there are two separate structures for hydrated yttrium acetates, which play a role as an intermediate in the building of ceramic oxide layers for coated conductors.

Journal Article↗