Biomedical subjects

Hiie Hinrikus

Publications and source records attributed to Hiie Hinrikus.

3 recordsLinked to original sources

PubMed2005

Study of effects of low level microwave field by method of face masking.

The aim of this study was to examine experimentally effects of low level, modulated microwaves on human central nervous system function utilizing the phenomenon of visual masking. Ten healthy volunteers, four males and six females, were exposed to electromagnetic field (450 MHz, 0.16 mW/cm2) with 7 Hz modulation frequency. Two photo series (visual stimuli) of unfamiliar, young male faces were presented to the subjects, one picture after another. All the photos were frontal views of unfamiliar faces, which could be recognized only by their unique combinations of features. The task was to identify the pictures from a group of six photos and to decide which order they were presented in. The phenomenon of visual masking is revealed as anamorphosis in subject's perception of two instantaneous visual stimuli presented within a short time interval. When both stimuli were to be recognized correctly and put in the right order, there was a statistically significant difference (P < 0.05) between the identification of the stimulus with microwave electromagnetic field and sham exposure. Recognition of both stimuli in a pair was better under the sham exposure conditions but the actual difference was only 5%. It was concluded that early stages of visual information processing are overwhelmingly robust and routine (and adaptively significant) activities, so that the low level 7 Hz modulated electromagnetic field effects exerted upon it are extremely weak.

Adult↗

PubMed2004

Changes in human EEG caused by low level modulated microwave stimulation.

This study focuses on the effect of low level microwave radiation on human EEG alpha and theta rhythms. During the experiment, 20 healthy volunteers were exposed to a 450 MHz microwaves with 7 Hz on-off modulation. The field power density at the scalp was 0.16 mW/cm2. Signals from the following EEG channels were used: FP1, FP2, P3, P4, T3, T4, O1, and O2. The experimental protocol consisted of one cycle of short term photic and ten cycles of the repetitive microwave stimulation. The changes caused by photic as well as microwave stimulation were more regular on the alpha rhythm. In the majority of cases, photic stimulation caused changes in the EEG energy level in the occipital and microwave stimulation in the frontal region. Our experimental results demonstrated that microwave stimulation effects became apparent, starting from the third stimulation cycle. Changes varied strongly from subject to subject. Therefore, photic and microwave exposure did not cause statistically significant changes in the EEG activity level for the whole group. For some subjects, clear tendencies of changes in microwave on-off cycles were noticeable.

Action Potentials↗

PubMed2003

Self-mixing in a diode laser as a method for cardiovascular diagnostics.

Our aim is the development of a simple optical method for pulse wave profile, pulse wave delay time, and blood flow measurement. The method is based on recording the Doppler frequency shift related to a moving target--blood vessel walls or small particles. The Doppler signal is detected using the self-mixing that occurs in the diode laser cavity when radiation scatters back from the moving target into the laser and interferes with the field inside. Two different ways can be simultaneously used for the self-mixing signal extraction: a photodiode accommodated in the rear facet of the diode laser package and a resistor from the laser pump current. An experimental device with a pigtail laser diode is developed that is able to detect the pulsation of major arteries with potentially useful information, including the pulse wave profile and the pulse wave delay time. The pulse wave delay time in different regions of the human body is measured relative to the electrocardiogram (ECG) signal. Also the flow velocity of a liquid suspension containing particles the size of erythrocytes (equivalent to blood flow) is measured. Registered signals are stored after digitalization and preprocessed using LabView for a Windows environment. The described device has the application of the self-mixing method and highlights significant advantages of simplicity, compactness, and robustness as well as the self-aligning and self-detecting abilities of such method, compared with the use of conventional interferometric method.

Blood Flow Velocity↗