PubMed Health⌕ Search

Biomedical subjects

Hiroyuki Kono

Publications and source records attributed to Hiroyuki Kono.

9 recordsLinked to original sources
PubMed2006

Solid-state 13C NMR study of indomethacin polymorphism.

The purpose of this study was to analyze the difference in the molecular conformation packed in the crystal lattice between the meta-stable alpha-form and stable gamma-form of indomethacin on the basis of solid-state (13)C NMR spectral patterns. The chemical shifts of each resonance of the alpha-form were distinctly different from the gamma-form. Each carbon nucleus of the gamma-form showed a single signal with no splitting. In contrast, carbon nuclei of the alpha-form showed a complicated set of resonances for each carbon. For some carbons of the alpha-form, four signals assigned to one carbon were observed at 203 K. Two of these four signals were merged between the temperature range from 203 to 343 K without a transformation in the crystal structure. It was found that solid-state (13)C NMR can be a powerful tool to estimate the number of molecular conformations as well as configurational differences in the packing of molecules in a unit cell.

Anti-Inflammatory Agents, Non-Steroidal↗
PubMed2006

Two-dimensional 13C-1H heteronuclear correlation NMR spectroscopic studies for the inclusion complex of cyclomaltoheptaose (beta-cyclodextrin) with a new Helicobacter pylori eradicating agent (TG44) in the amorphous state.

The interaction of a newly developed Helicobacter pylori eradicating agent (TG44, 4-methylbenzyl-4'-[trans-4-(guanidinomethyl)cyclohexylcarbonyloxy]-biphenyl-4-carboxlylate monohydrochloride) with cyclomaltoheptaose (beta-cyclodextrin, beta-CyD) in the solid state was studied by high-speed frequency-switched Lee-Goldburg (FSLG) (13)C-(1)H heteronuclear correlation (HETCOR) NMR experiments. The TG44/beta-CyD solid complex in a 1:1 stoichiometry was prepared by the grinding method. Powder X-ray diffractometry confirmed that the complex is in an amorphous state. The solid-state (13)C signals of TG44 and beta-CyD were significantly broadened by the complexation. As the temperature increased, the (13)C signals of the aromatic moieties of TG44 were insignificantly influenced, whereas those of the cyclohexyl moiety became sharper. The T1(rho) H values of the aromatic moieties of TG44 were almost the same as those of the beta-CyD carbons, whereas those of other TG44 carbons gave much smaller values. The (13)C-(1)H HETCOR spectra gave the intermolecular correlation peaks between the aromatic carbons of TG44 and the beta-CyD protons or between the biphenyl protons of TG44 and the beta-CyD carbons, when measured using longer contact times (500 and 1500mus). On the basis of these solid NMR spectroscopic data together with aqueous NMR data, we assume that beta-CyD includes predominantly the biphenyl moiety of TG44 in the solid state. (13)C-(1)H HETCOR spectroscopy is particularly useful for the determination of inclusion modes of the complexes that occurring in an amorphous form.

Anti-Bacterial Agents↗
PubMed2005

Shear bond strength of resin composite to magnetic Fe-Pt alloy.

STATEMENT OF PROBLEM: It is important to obtain strong adhesion between resin composite material and magnetic Fe-Pt alloy for fabrication of an indirect veneered crown. However, little is known about the bond strength between these materials. PURPOSE: This study evaluated the bond strength of resin composite to magnetic Fe-Pt alloy, using 4 adhesive metal primers. MATERIAL AND METHODS: Seventy disk-shaped patterns (7.5 mm in diameter, 2.0 mm thick) were cast from a custom-made Fe-Pt ingot using a high-frequency centrifugal casting machine. After the bonding surfaces were airborne-particle abraded with 50 microm Al2O3, specimens were divided into groups (n=7) and primed with either Metal Primer II (MP), Meta Fast Bonding Liner (BL), New Meta Color INFIS Opaque Primer (IN), or Epricord Opaque Primer (EP). Nonprimed specimens served as controls (n=7). A resin composite (New Meta Color INFIS) was then applied to all specimens and polymerized. After the specimens were immersed in 37 degrees C water for 24 hours or thermal cycled at 4 degrees C to 60 degrees C with a 1-minute dwell time of up to 10,000 cycles, the shear bond strengths (MPa) were measured using a universal testing machine at a crosshead speed of 0.5 mm/min. The data were statistically analyzed by a 2-way analysis of variance and the Scheffe test (alpha=.05). RESULTS: Although IN had the lowest strength, there were no significant differences in bond strengths of the other 3 primers (MP, BL, and EP) before thermal cycling. The bond strengths of MP and EP were slightly altered by thermal cycling (P >.05); however, BL and IN underwent a significant decrease (P <.05). CONCLUSION: The results of this in vitro study indicate that MP and EP provide superior long-term shear strength when bonding the resin composite evaluated to Fe-Pt alloy.

Composite Resins↗
PubMed2004

Two-dimensional magic angle spinning NMR investigation of naturally occurring chitins: precise 1H and 13C resonance assignment of alpha- and beta-chitin.

13C homonuclear through-bond correlations of alpha- and beta-chitin were determined by using two-dimensional (2D) INADEQUATE spectra of these allomorphs purified from crab shell and squid pen, respectively. The 2D (13)C-(13)C correlation spectra where two directly bonded carbons share a common double-quantum frequency (DQ) enabled us to precisely assign all (13)C resonances of the chitin allomorphs for the first time. Following the complete (13)C assignment, (1)H chemical shifts of protons attached to each carbon nuclei were assigned by 2D frequency-switched Lee-Goldberg (FSLG) (1)H-(13)C heteronuclear correlation (HETCOR) spectra of the chitin allomorphs, recorded with a short mixing time (60 micros) to provide isotropic (1)H-(13)C chemical shift correlations between bonded pairs proton and carbon nuclei. From the (13)C and (1)H chemical shifts of chitin allomorphs, all 2-deoxy-2-acetamide-D-glucose (N-acetyl-D-glucosamine) monomer units in each allomorph were revealed to be an identical (13)C-(13)C backbone conformation and magnetically equivalent. In addition, it was strongly suggested that there are two different hydrogen-bonding patterns at the hydroxyl groups of alpha-chitin by comparing (1)H chemical shifts at the C6 site of alpha-chitin with those at the same site of beta-chitin.

Animals↗
PubMed2003

Cross-polarization/magic-angle spinning 13C nuclear magnetic resonance study of cellulose I-ethylenediamine complex.

Complete assignments of the cross-polarization/magic-angle spinning (CP/MAS) 13C nuclear magnetic resonance (NMR) spectrum of the cellulose I-ethylenediamine (EDA) complex, which is the intermediate of the reaction from cellulose I to cellulose III(I), were performed. In this paper, we used the 13C-enriched cellulose that was biosynthesized by Acetobacter xylinum ATCC10245 strain from culture medium containing D-(2-13C), D-(3-13C), or D-(5-13C)glucose as a carbon source. After conversion into cellulose I-EDA complex by sufficient EDA treatment, the CP/MAS 13C NMR spectra of the 13C-enriched cellulose I-EDA complexes were measured. As a result, 13C resonance lines of each carbon of the cellulose moiety in the complex appeared as a singlet, suggesting that all glucose residues of the complex are magnetically equivalent. The difference in chemical shifts for each carbon between cellulose I-EDA and cellulose I(alpha), I(beta), and III(I), respectively, suggests that the conformation of the cellulose chains for cellulose I-EDA differs from that for cellulose I(alpha), I(beta), and III(I). In addition, fitting analysis of the 13C spectrum of Valonia cellulose I-EDA complex revealed that the complex contains one EDA molecule per two glucose residues in the cellulose chain.

Journal Article↗
PubMed2002

CP/MAS (13)C NMR study of cellulose and cellulose derivatives. 1. Complete assignment of the CP/MAS (13)C NMR spectrum of the native cellulose.

The precise assignments of cross polarization/magic angle spinning (CP/MAS) (13)C NMR spectra of cellulose I(alpha) and I(beta) were performed by using (13)C labeled cellulose biosynthesized by Acetobacter xylinum (A. xylinum) ATCC10245 strain from culture medium containing D-[1,3-(13)C]glycerol or D-[2-(13)C]glucose as a carbon source. On the CP/MAS (13)C NMR spectrum of cellulose from D-[1,3-(13)C]glycerol, the introduced (13)C labeling were observed at C1, C3, C4, and C6 of the biosynthesized cellulose. In the case of cellulose biosynthesized from D-[2-(13)C]glucose, the transitions of (13)C labeling to C1, C3, and C5 from C2 were observed. With the quantitative analysis of the (13)C transition ratio and comparing the CP/MAS (13)C NMR spectrum of the Cladophora cellulose with those of the (13)C labeled celluloses, the assignments of the cluster of resonances which belong to C2, C3, and C5 of cellulose, which have not been assigned before, were performed. As a result, all carbons of cellulose I(alpha) and I(beta) except for C1 and C6 of cellulose I(alpha) and C2 of cellulose I(beta) were shown in equal intensity of doublet in the CP/MAS spectrum of the native cellulose, which suggests that two inequivalent glucopyranose residues were contained in the unit cells of both cellulose I(alpha) and I(beta) allomorphs.

Acetobacter↗
PubMed2002

CP/MAS (13)C NMR study of cellulose and cellulose derivatives. 2. Complete assignment of the (13)C resonance for the ring carbons of cellulose triacetate polymorphs.

Complex ring (13)C resonance lines of the cross-polarization/magic angle spinning (CP/MAS) (13)C NMR spectra of cellulose triacetate (CTA) I and CTA II were completely assigned, for the first time, by (13)C-enriched CTA allomorphs. The (13)C-enriched CTA I was prepared by heterogeneous acetylation of bacterial cellulose which was biosynthesized by Acetobacter xylinum (A. xylinum) ATCC10245 from culture medium containing D-(2-(13)C)-, D-(3-(13)C)-, or D-(5-(13)C)glucose as a carbon source, while CTA II samples were obtained by solution acetylation of the (13)C-enriched bacterial celluloses. From comparison of the spectra of normal CTA prepared from ramie with those of the enriched CTA samples, it was revealed that all carbons composed of CTA I appeared as a singlet, while those of CTA II except for C1 were shown as equal-intensity doublets in the CP/MAS (13)C NMR spectrum. This finding suggests that CTA I is made up of one kind of glucopyranose residue while there are two magnetically inequivalent sites in the unit cell of CTA II in the same population.

Acetobacter↗
PubMed2002

Effects of endogenous endo-beta-1,4-glucanase on cellulose biosynthesis in Acetobacter xylinum ATCC23769.

Endo-beta-1,4-glucanase (CMCax; EC 3.2.1.4) from Acetobacter xylinum ATCC23769 was expressed as a 6 x His-tagged fusion protein in Escherichia coli. The optimal temperature, pH, K(m) and V(max) of the purified His-tagged CMCax toward carboxymethyl cellulose were 50 degrees C, 4.5, 20 mg/ml and 37.2 microM/min, respectively. The number of recognition residues of cello-oligosaccharide by this enzyme were five (cellopentaose) or longer, and the stereochemical course of hydrolysis was of the inverting type. Addition of a small amount (1.5 mg/l) of His-tagged CMCax into a culture medium enhanced cellulose production 1.2-fold. CMCax overproduction in A. xylinum also enhanced the yield of cellulose production. Transmission electron microscopic analysis revealed that the cellulose ribbons secreted from the CMCax overproducing strain were dispersed compared with those from the wild type strain in the same manner as by carboxymethyl cellulose addition. These results could suggest that CMCax from A. xylinum influences in cellulose ribbon assembly, which is considered to be a rate-determined process in cellulose synthesis.

Journal Article↗