Biomedical subjects

Hitoshi Fukushima

Publications and source records attributed to Hitoshi Fukushima.

5 recordsLinked to original sources

PubMed2006

Soft-UV photolithography using self-assembled monolayers.

We report thiol-on-gold self-assembled monolayers (SAMs) that can be photodeprotected using soft UV irradiation (lambda = 365 nm) to yield CO(2)H functionalized surfaces complementing those reported previously, which yielded NH(2) functionalized surfaces. The photolysis of these SAMs were monitored using a combination of surface sensitive techniques. In the SAM environment the photodeprotection yields are lower than those obtained for equivalent reactions in dilute solution. The protected carboxylic acids SAMs are shown to have a low yield approximately 50% due to competing photoreduction reactions of the nitro group. The results from infrared studies show that, as the photolysis progresses, the long chain protected residues reorganize and shield the functional COOH groups, thereby reducing the hydrophilic character of the surface.

Journal Article↗

PubMed2006

Dynamic helical CT mammography of breast cancer.

PURPOSE: The purpose of this study was to determine whether dynamic helical computed tomography (CT)-mammography could assist in selecting the most appropriate surgical method in women with breast cancer. MATERIALS AND METHODS: Preoperative contrast-enhanced helical CT scanning of the breast was performed on 133 female patients with suspicion of breast cancer at the same time as clinical, mammographic, and/or ultrasonographic examinations. The patients were scanned in the prone position with a specially designed CT-compatible device. A helical scan was made with rapid intravenous bolus injection (3 ml/s) of 100 ml of iodine contrast material. Three-dimensional maximum intensity projection (MIP) images were reconstructed, and CT findings were correlated with surgical and histopathological findings. RESULTS: Histopathological analysis revealed 84 malignant lesions and seven benign lesions. The sensitivity, specificity, and accuracy levels of the CT scanning were 94.6%, 58.6%, and 78.9%. Helical scanning alone revealed additional contralateral carcinomas in three of four patients and additional ipsilateral carcinomas in three of five patients. However, the technique gave false-positive readings in 24 patients. The preoperative CT-mammogram altered the surgical method in six patients. CONCLUSION: Dynamic helical CT-mammography in the prone position may be one of the choices of adjunct imaging in patients with suspected breast cancer scheduled for surgery.

Adult↗

PubMed2005

Novel cyanoterphenyl self-assembly monolayers on Au(111) studied by ellipsometry, x-ray photoelectron spectroscopy, and vibrational spectroscopies.

The self-assembled monolayers (SAMs) of two asymmetric disulfides derivatives (namely, LC1 and LC2) were prepared on Au(111). The disulfides contain a pure alkyl chain and an alkyl chain terminated by a cyanoterphenyl group. LC1 and LC2 differ by the way the cyanoterphenyl group is attached onto the alkyl chain: it is expected to be aligned with the alkyl chain in the case of LC1 and perpendicular to it in the case of LC2 (T shape). The consequences in terms of surface coverage, chemical composition, and molecular conformation of the two SAMs are studied using ellipsometry, x-ray photoelectron spectroscopy (XPS), reflection absorption infrared spectroscopy (RAIRS), and broadband femtosecond sum-frequency generation (SFG). A model of coverage and tilt angle based on ellipsometry and XPS results shows that the SAM "manages" the large size of the terphenyl group by lowering the terphenyl containing chain coverage and by increasing the tilt. In the case of LC2, the disulfide breaks during molecular assembly, less terphenyl chains adsorb than pure alkyl chains, and the overall chain coverage is smaller than for LC1. RAIRS and SFG results show that these differences in surface coverage correspond to a drastically different orientation of the terphenyl axis, which lies nearly parallel to the surface for LC2, while it is tilted by approximately 28 degrees for LC1. This shows that the terphenyl group takes much more space on the surface in the case of LC2 and explains why the terphenyl coverage is found smaller for LC2. The anomalous SFG relative intensities observed in the region of CH stretch between CH2 and CH3 modes, and symmetric and antisymmetric modes, show that the chains are not in the fully stretched, all-trans conformation, LC2 being probably more distorted than LC1. These distorsions allow the molecules to occupy the space available below the large terphenyl group. The relative intensities of symmetric and antisymmetric modes are discussed qualitatively for some typical molecular conformations and orientations of the alkyl chain.

Journal Article↗

PubMed2005

A mild photoactivated hydrophilic/hydrophobic switch.

Surface modification using light is one of the most powerful methods for controlling the physical and chemical properties offunctionalized surfaces. In this paper, we report on systems where soft UV irradiation (lambda = 365 nm) converts a "low" activity fluorocarbon to a "high" activity amine-functionalized surface. An amine-functionalized SAM (self-assembled monolayer) is first masked using a tertiary amine catalyzed reaction with an N-hydroxysuccinimidyl carbonyl reagent. This mild, room-temperature reaction introduces a hydrophobic photocleavable nitrobenzyl "protecting group" terminated with a fluorocarbon end-chain. UV irradiation (lambda = 365 nm) of this hydrophobic/fluorocarbon surface cleaves the nitrobenzyl residue, returning the surface to the original hydrophilic/amine-functionalized state. This provides a mild, generic method of producing surfaces with hydrophilic/hydrophobic patterns or patterned with amine functional residues. Two different protecting groups, one terminated with a single and the other with three fluorocarbon end chains, are compared. In the case of the more bulky protecting group, only a small proportion of the amine residues react, but the surface is equally hydrophobic and the amine residues equally well shielded from further reaction. Surfaces are characterized by X-ray photoelectron spectroscopy, ellipsometry, surface potential, and contact angle measurements. Images of the photopatterned SAMs were obtained using scanning electron microscopy.

Journal Article↗

PubMed2005

[Candida adherence and biofilm formation on oral surfaces].

Candida albicans is the most common fungal opportunistic pathogen in humans. The AIDS epidemic, improved life-sustaining therapy, and aggressive anticancer therapy have contributed to a rise in the number of severely immunocompromised patients. This has led to an increase in oral and systemic fungal infection. Several factors, such as adherence, persistence, dimorphism, germ tube formation, and/or contact sensing, phenotypic switching, interference with the host defense system, synergism with bacteria, and the production of hydrolases or other metabolites, have been proposed to be virulence factors of this fungus. Among these virulence factors, adherence and persistence are thought to be the most important, since the colonization and subsequent biofilm formation of oral surfaces may serve as a reservoir for disseminated infections, such as aspiration pneumonia and gastrointestinal infection. In the review, we summarized the factors involved in the Candida albicans biofilm formation.

Biofilms↗