Biomedical subjects

Hu-Jun Qian

Publications and source records attributed to Hu-Jun Qian.

5 recordsLinked to original sources

PubMed2006

An automatic coarse-graining and fine-graining simulation method: application on polyethylene.

Multiscale modeling of a polymeric system is a challenging task in polymer physics. Here we introduce a bottom-up and then top-down scheme for the simulation of polyethylene (PE). The coarse-grained numerical potential for PE is derived through an automatic updating program by mapping its radial distribution function (RDF) from the Lowe-Andersen temperature controlling (LA) simulation onto the one from detailed molecular dynamics (MD) simulation. This coarse-grained numerical potential can be applied in larger systems under the same thermodynamic conditions. We have tested the reliability of the derived potential in two ways. First, the blends of different linear low-density polyethylene (LLDPE) with high-density polyethylene (HDPE) have been simulated in LA with the coarse-grained numerical potentials and reasonable results are obtained. Moreover, Rouse scaling behavior is reproduced for monodispersed polymeric systems with different chain lengths. The atomistic details of the beads can be reintroduced into the coarse-grained HDPE and LLDPE/HDPE models, followed by a few MD runs to alleviate the local tension induced by this fine-graining procedure. The equilibrated large atomistic system can then be used for further studies.

Journal Article↗

PubMed2006

Dissipative particle dynamics study on the morphology changes of diblock copolymer lamellar microdomains due to steady shear.

The morphology changes of linear diblock copolymer lamellar microdomains under uniform simple shear are studied via the dissipative particle dynamics technique. The parallel and perpendicular reorientations of the lamellae are observed in the simulations, and two different reorientation mechanisms, under small and large shear rates respectively, are proposed. The parallel-to-perpendicular transition is also observed and the kinetics is discussed. Sinusoidal and chevron instabilities due to the shear are found. After relaxation the peculiar "bidirectionally undulating" instability is obtained.

Journal Article↗

PubMed2006

The dependence of nanostructures on the molecule rigidity of A2(B4)2-type miktoarm block copolymer.

Using the dissipative particle dynamics simulation technique, we have studied the influence of the molecule rigidity on the nanostructures of the A2(B4)2-type miktoarm block copolymers. A typical spherical micellar ordered structure is obtained for a coil-coil miktoarm block copolymer in melt. By introducing a bond angle potential in our model to enhance the molecule rigidity systematically, we find, respectively, a hexagonal cylindrical structure and a parallel ellipsoid in lamellae structure which is discovered for the first time.

Journal Article↗

PubMed2005

Dissipative particle dynamics study on the interfaces in incompatible A/B homopolymer blends and with their block copolymers.

Dissipative particle dynamics, a simulation technique appropriate at mesoscopic scales, has been applied to investigate the interfaces in immiscible binary A/B homopolymer blends and in the ternary systems with their block copolymers. For the binary blends, the interfacial tension increases and the interface thickness decreases with increasing Flory-Huggins interaction parameter chi while the homopolymer chain length is fixed. However, when the chi parameter and one of the homopolymer chain length is fixed, increasing another homopolymer chain length will induce only a small increase on interfacial tension and slight decrease on interface thickness. For the ternary blends, adding the A-b-B block copolymer will reduce the interfacial tension. When the mole number of the block copolymer is fixed, longer block chains have higher efficiency on reducing the interfacial tension than the shorter ones. But for the block copolymers with fixed volume fraction, shorter chains will be more efficient than the longer ones on reducing the interfacial tension. Increasing the block copolymer concentration reduces interfacial tension. This effect is more prominent for shorter block copolymer chains.

Journal Article↗

PubMed2005

The effects of Lowe-Andersen temperature controlling method on the polymer properties in mesoscopic simulations.

Lowe-Andersen (LA) temperature controlling method [C. P. Lowe, Europhys. Lett. 47, 145 (1999)] is applied in a series of mesoscopic polymer simulations to test its validity and efficiency. The method is an alternative for dissipative particle dynamics simulation (DPD) technique which is also Galilean invariant. It shows excellent temperature control and gives correct radial distribution function as that from DPD simulation. The efficiency of LA method is compared with other typical DPD integration schemes and is proved to be moderately efficient. Moreover, we apply this approach to diblock copolymer microphase separation simulations. With LA method, we are able to reproduce all the results from the conventional DPD simulations. The calculated structure factors of the microphases are consistent with the experiments. We also study the microphase evolution dynamics with increasing chiN and find that the bath collision frequency Gamma does not affect the order of appearing phases. Although the thermostat does not affect the surface tension, the order-disorder transition (ODT) is somewhat sensitive to the values of Gamma, i.e., the ODT is nonmonotonic with increasing Gamma. The dynamic scaling law is also tested, showing that the relation obeys the Rouse theory with various Gamma.

Journal Article↗