Biomedical subjects

Iwona B Beech

Publications and source records attributed to Iwona B Beech.

8 recordsLinked to original sources

PubMed2006

Modification of surface properties of a poly(dimethylsiloxane)-based elastomer, RTV11, upon exposure to seawater.

Atomic force microscopy (AFM) was combined with surface analytical techniques to investigate the rarely addressed issue of the effect of seawater on the surface properties of a selected fouling-release coating, silicon elastomer RTV11 (trademark of General Electric). The exposure of the RTV11 surface to seawater resulted in a modification of its morphology and mechanical properties, as confirmed by AFM and scanning electron microscopy (SEM). Surface modification was dependent on sample preparation and curing process, namely, curing agent concentration and relative humidity during curing. The RTV11 surface remained largely unaltered for samples cured under 100% relative humidity. SEM and X-ray photoelectron spectroscopy studies confirmed that the modified surface of RTV11 had the same elemental composition as the unexposed surface of the elastomer and showed excess Ca. However, the modified surface deformed plastically under load and was stiffer than the original surface. No major change was found on surfaces exposed to nanopure water during similar times of exposure as in seawater, regardless of curing conditions. The rate of increase in the aggregate formation in seawater can be described by an exponential function, with a decay constant of approximately 4.99 x 10(-)(3) min(-)(1) and a pre-exponential factor of approximately 1.77 x 10(-)(2) microm/min.

Atmosphere↗

PubMed2006

On the distributions of ion/neutral molecule clusters in electrospray and laser spray -- a cluster division model for the electrospray process.

The clustering of a medium-sized, involatile, neutral molecule, octyl beta-D-glucopyranoside (OG), with Na(+), Ca(2+), and Yb(3+) (M(z+)) ions in electrospray (ESI) was investigated using laser spray (LSI). Extensive distributions of [(M(z+))(i) (OG)(a)](n+)-clusters, extending beyond 50 kDa, were observed. The distributions were highly stable and reproducible and changed only marginally when concentrations of electrolyte or neutral compound were varied by orders of magnitude. Compared with ESI, laser spray yielded superior intensities, particularly of the larger clusters. The cluster distributions demonstrated a range of remarkable features. In particular, the Yb(3+)/OG cluster distribution was unusual. For example, no clusters with 35-52 or with 110-116 OG molecules were observed. The distribution pattern revealed that the clusters were formed as a result of cluster dissociations, such as [(Yb(3+))(3)(OG) ( approximately 110)W](9+) --> [(Yb(3+))(2)(OG)( approximately 90)W](6+) + [(Yb(3+))(1)(OG) ( approximately 20)W](3+), where W represents the water content at the time of dissociation. Based on this study, a cluster division model for electrospray of aqueous solutions of strongly solvated ions is proposed: the Rayleigh droplet disintegration process, which is well-established for the initial stages of electrospray, maintains its general character as it proceeds through a final regime of multiply charged cluster dissociations to the singly and multiply charged ions in mass spectrometry. In the dissociation of multiply charged clusters, the size of each daughter cluster is roughly proportional to the square of the cluster charge. Observed cluster distributions are consistent with a mixture of symmetric and asymmetric cluster dissociations.

Journal Article↗

PubMed2005

Ion/molecule reactions in the orifice-skimmer region of an atmospheric pressure Penning ionization mass spectrometer.

Atmospheric pressure Penning ionization mass spectra of methanol were measured as functions of Ar or He gas pressure in the first vacuum chamber, the position of the skimmer, and the voltage applied between the orifice and the skimmer. When the orifice and the skimmer were coaxial with a distance of 4 mm, the distribution of CH3OH2+(CH3OH)n clusters was only weakly dependent on both Ar pressure (in the range of 19-220 Pa) and orifice-skimmer voltage (in the range of 1-45 V). The ion/molecule reaction CH3OH2+ + CH3OH --> CH3+(CH3OH) + H2O was observed in the free jet expansion, especially at high orifice-skimmer voltage values. When the orifice and the skimmer were off-centered and the distance between them was increased to 18 mm, the formation of large CH3OH2+(CH3OH)n clusters, as well as their dissociation, were seen. The endothermic proton transfer reaction, CH3+(CH3OH) + CH3OH --> CH3OH2+ + CH3OCH3, occurred at high orifice-skimmer voltage. The collision-induced dissociation of cluster ions by He gas in the first vacuum chamber was much more efficient than by Ar. These results demonstrated that the mass spectra are highly dependent on skimmer position and on orifice-skimmer voltage and that ions observed by mass spectrometry do not necessarily reflect the abundance of ions produced in the atmospheric pressure ion source.

Journal Article↗

PubMed2005

Microbe-surface interactions in biofouling and biocorrosion processes.

The presence of microorganisms on material surfaces can have a profound effect on materials performance. Surface-associated microbial growth, i.e. a biofilm, is known to instigate biofouling. The presence of biofilms may promote interfacial physico-chemical reactions that are not favored under abiotic conditions. In the case of metallic materials, undesirable changes in material properties due to a biofilm (or a biofouling layer) are referred to as biocorrosion or microbially influenced corrosion (MIC). Biofouling and biocorrosion occur in aquatic and terrestrial habitats varying in nutrient content, temperature, pressure and pH. Interfacial chemistry in such systems reflects a wide variety of physiological activities carried out by diverse microbial populations thriving within biofilms. Biocorrosion can be viewed as a consequence of coupled biological and abiotic electron-transfer reactions, i.e. redox reactions of metals, enabled by microbial ecology. Microbially produced extracellular polymeric substances (EPS), which comprise different macromolecules, mediate initial cell adhesion to the material surface and constitute a biofilm matrix. Despite their unquestionable importance in biofilm development, the extent to which EPS contribute to biocorrosion is not well-understood. This review offers a current perspective on material/microbe interactions pertinent to biocorrosion and biofouling, with EPS as a focal point, while emphasizing the role atomic force spectroscopy and mass spectrometry techniques can play in elucidating such interactions.

Bacterial Physiological Phenomena↗

PubMed2004

A live bioprobe for studying diatom-surface interactions.

Atomic force microscopy has been employed to compare the adhesion of Navicula species I diatoms to surfaces of a hydrophobic elastomer, Intersleek, and a hydrophilic mineral, mica. This was accomplished using tipless atomic force microscopy cantilevers functionalized with live diatom cells. Both surfaces were tested with the same diatom bioprobe. Force versus distance curves generated during these experiments revealed comparable cell adhesion strengths on Intersleek and mica, indicating that Navicula diatoms secrete extracellular polymeric substances with hydrophobic and hydrophilic properties. A statistical analysis of force curves was carried out and the average values of works of detachment of a diatom from Intersleek and mica surfaces were determined.

Adhesiveness↗

PubMed2004

Biocorrosion: towards understanding interactions between biofilms and metals.

The term microbially influenced corrosion, or biocorrosion, refers to the accelerated deterioration of metals owing to the presence of biofilms on their surfaces. The detailed mechanisms of biocorrosion are still poorly understood. Recent investigations into biocorrosion have focused on the influence of biomineralization processes taking place on metallic surfaces and the impact of extracellular enzymes, active within the biofilm matrix, on electrochemical reactions at the biofilm-metal interface.

Biofilms↗

PubMed2004

Desulfovibrio alaskensis sp. nov., a sulphate-reducing bacterium from a soured oil reservoir.

A novel sulphate-reducing bacterium (Al1T) was recovered from a soured oil well in Purdu Bay, Alaska. Light and atomic force microscopy observations revealed that cells were Gram-negative, vibrio-shaped and motile by means of a single polar flagellum. The carbon and energy sources used by the isolate and the salinity, temperature and pH ranges facilitating its growth proved to be typical of a partial lactate-oxidizing, moderately halophilic, mesophilic, sulphate-reducing bacterium. Analysis of the fatty acid profile revealed that C(18 : 0), isoC(15 : 0) and isoC(17 : 1)omega7c were the predominant species. Fatty acid profile and complete 16S rRNA gene sequencing demonstrated the similarity between strain Al1T and members of the genus Desulfovibrio. The position of strain Al1T within the phylogenetic tree indicated that it clustered closely with Desulfovibrio vietnamensis DSM 10520T (98.9 % sequence similarity), a strain recovered from a similar habitat. However, whole-cell protein profiles, Fourier-transform infrared studies and DNA-DNA hybridization demonstrated that, in spite of the high level of 16S rRNA gene sequence similarity, there is sufficient dissimilarity at the DNA sequence level between D. vietnamensis DSM 10520T and strain Al1T (10.2 % similarity) to propose that strain Al1T belongs to a separate species within the genus Desulfovibrio. Based on the results obtained, the name Desulfovibrio alaskensis sp. nov. is therefore proposed, with Al1T (= NCIMB 13491T = DSM 16109T) as the type strain.

Alaska↗

PubMed2003

MASE1 and MASE2: two novel integral membrane sensory domains.

Escherichia coli proteins YegE and YaiC contain N-terminal integral membrane regions, followed by the putative diguanylate cyclase (GGDEF, DUF1) domains. The membrane domains of these proteins, named MASE1 (membrane-associated sensor) and MASE2, respectively, were found in other bacterial signaling proteins, such as histidine kinases (MASE1) and an adenylate cyclase (MASE2). Although the nature of the signals sensed by MASE1 and MASE2 is still unknown, MASE1-containing receptors appear to play important roles in bacteria, including iron and/or oxygen sensing by hemerythrine-containing proteins in the sulfate-reducing bacterium Desulfovibrio vulgaris.

Adenylyl Cyclases↗