Biomedical subjects

J A Delettrez

Publications and source records attributed to J A Delettrez.

11 recordsLinked to original sources

PubMed2005

Observation of self-similar behavior of the 3D, nonlinear Rayleigh-Taylor instability.

The Rayleigh-Taylor unstable growth of laser-seeded, 3D broadband perturbations was experimentally measured in the laser-accelerated, planar plastic foils. The first experimental observation showing the self-similar behavior of the bubble size and amplitude distributions under ablative conditions is presented. In the nonlinear regime, the modulation sigma(rms) grows as alpha(sigma)gt(2), where g is the foil acceleration, t is the time, and alpha(sigma) is constant. The number of bubbles evolves as N(t) alpha(omegat sq.rt(9) + C)(-4) and the average size evolves as (t) alpha omega(2)gt(2), where C is a constant and omega = 0.83 +/- 0.1 is the measured scaled bubble-merging rate.

Journal Article↗

PubMed2005

Fourier-space nonlinear Rayleigh-Taylor growth measurements of 3D laser-imprinted modulations in planar targets.

Nonlinear growth of 3D broadband nonuniformities was measured near saturation levels using x-ray radiography in planar foils accelerated by laser light. The initial target modulations were seeded by laser nonuniformities and later amplified during acceleration by Rayleigh-Taylor instability. The nonlinear saturation velocities are measured for the first time and are found to be in excellent agreement with Haan predictions. The measured growth of long-wavelength modes is consistent with enhanced, nonlinear, long-wavelength generation in ablatively driven targets.

Journal Article↗

PubMed2004

Effects of nonuniform illumination on implosion asymmetry in direct-drive inertial confinement fusion.

Target areal density (rhoR) asymmetries in OMEGA direct-drive spherical implosions are studied. The rms variation / for low-mode-number structure is approximately proportional to the rms variation of on-target laser intensity / with an amplification factor of approximately 1/2(C(r)-1), where C(r) is the capsule convergence ratio. This result has critical implications for future work on the National Ignition Facility as well as OMEGA.

Journal Article↗

PubMed2004

Dependence of shell mix on feedthrough in direct drive inertial confinement fusion.

The mixing of cold, high-density shell plasma with the low-density, hot spot plasma by the Rayleigh-Taylor instability in inertial confinement fusion is experimentally shown to correlate with the calculated perturbation feedthrough from the ablation surface to the inner shell surface. A fourfold decrease in the density of shell material in the mix region of direct drive implosions of gas filled spherical plastic shells having predicted convergence ratios approximately 15 was observed when laser imprint levels were reduced and the initial shell was thicker, corresponding to a reduction in the feedthrough rms level by a factor of 6. Shell mix is also shown to limit the spherical compression of the implosion.

Journal Article↗

PubMed2003

Time-dependent electron thermal flux inhibition in direct-drive laser implosions.

We simulate direct-drive CH target implosions with square laser pulses by a one-dimensional Fokker-Planck solver combined with a hydrodynamic code, and compare the results with those simulated by the flux-limited Spitzer-Härm model. We find that the electron thermal flux inhibition is time dependent, resulting in longer density scale length, larger laser absorption, and smaller growth of Rayleigh-Taylor instability. The time of peak neutron production calculated from Fokker-Planck simulations agrees with experiments for both 1-ns and 400-ps pulses.

Journal Article↗

PubMed2003

Multibeam effects on fast-electron generation from two-plasmon-decay instability.

Experiments with multiple laser beams have been carried out in both spherical and planar geometry to study two-plasmon-decay instability, the predominant source of suprathermal electrons in direct-drive inertial confinement fusion experiments. These electrons are observed using the hard x rays generated through electron-target interactions. The experiments show for the first time that the total overlapped intensity governs the scaling of the suprathermal-electron generation regardless of the number of overlapped beams, in contrast to conventional theories that are based on the single-beam approximation.

Journal Article↗

PubMed2003

Time-resolved areal-density measurements with proton spectroscopy in spherical implosions.

The temporal history of the target areal-density near peak compression of direct-drive spherical target implosions has been inferred with 14.7-MeV deuterium-helium-3 D3He proton spectroscopy of the 60-beam, 30-kJ UV OMEGA laser system. The target areal-density grows by a factor of approximately 8 during the time of neutron-production ( approximately 400 ps) before reaching 123+/-16 mg/cm(2) at peak compression in the implosion of a 950-micrometer-diam, 20-micrometer-thick plastic CH capsule filled with 4 atm of D3He fuel.

Journal Article↗

PubMed2002

Effects of fuel-shell mix upon direct-drive, spherical implosions on OMEGA.

Fuel-shell mix and implosion performance are studied for many capsule types in direct-drive experiments at OMEGA. The amount of mixing and the size of the mix region are inferred from charged-particle spectrometry data and confirmed with an experimentally constrained model. Measured yields and convergence ratios CR fall short of one-dimensional predictions, especially for low capsule fill pressures. CR is approximately 11 for pressures from 3 to 15 atm, in contrast to predictions of approximately 25 for 3 atm and approximately 12 for 15 atm. The performance shortfalls are likely to be caused by fuel-shell mix.

Journal Article↗

PubMed2002

Shell mix in the compressed core of spherical implosions.

The Rayleigh-Taylor instability in its highly nonlinear, turbulent stage causes atomic-scale mixing of the shell material with the fuel in the compressed core of inertial-confinement fusion targets. The density of shell material mixed into the outer core of direct-drive plastic-shell spherical-target implosions on the 60-beam, OMEGA laser system is estimated to be 3.4(+/-1.2) g/cm(3) from time-resolved x-ray spectroscopy, charged-particle spectroscopy, and core x-ray images. The estimated fuel density, 3.6(+/-1) g/cm(3), accounts for only approximately 50% of the neutron-burn-averaged electron density, n(e)=2.2(+/-0.4)x10(24) cm(-3).

Journal Article↗

PubMed2001

Evolution of shell nonuniformities near peak compression of a spherical implosion.

The evolution of shell modulations near peak compression of direct-drive spherical-target implosions has been measured using the 60-beam, 30-kJ UV OMEGA laser system. The spatial size and amplitude of shell-areal-density modulations decrease during the target compression, then increase during its decompression as expected. The shell uniformity at peak compression has been increased by reducing single-beam, laser-drive nonuniformity.

Journal Article↗

PubMed2001

Effect of shock heating on the stability of laser-driven targets.

The shock heating of a laser-driven, direct-drive target can determine its stability by affecting Rayleigh-Taylor growth rates through target decompression and ablative stabilization. Measurements indicate that pulses that rise rapidly to 10(14) W/cm(2) produce shock-induced temperatures of approximately 25 eV, whereas more slowly rising pulses show less heating. Analysis of the observed target behavior produced by these two pulses demonstrates that shock heating improves hydrodynamic stability because ablative stabilization increases when the targets are preheated by shocks.

Journal Article↗