PubMed Health⌕ Search

Biomedical subjects

J Baschnagel

Publications and source records attributed to J Baschnagel.

9 recordsLinked to original sources
PubMed2004

Long range bond-bond correlations in dense polymer solutions.

The scaling of the bond-bond correlation function P1(s) along linear polymer chains is investigated with respect to the curvilinear distance s along the flexible chain and the monomer density rho via Monte Carlo and molecular dynamics simulations. Surprisingly, the correlations in dense three-dimensional solutions are found to decay with a power law P1(s) approximately s(-omega) with omega=3/2 and the exponential behavior commonly assumed is clearly ruled out for long chains. In semidilute solutions, the density dependent scaling of P1(s) approximately g(-omega(0))(s/g)(-omega) with omega(0)=2-2nu=0.824 (nu=0.588 being Flory's exponent) is set by the number of monomers g(rho) in an excluded volume blob. Our computational findings compare well with simple scaling arguments and perturbation calculation. The power-law behavior is due to self-interactions of chains caused by the chain connectivity and the incompressibility of the melt.

Journal Article↗
PubMed2004

Static properties of end-tethered polymers in good solution: a comparison between different models.

We present a comparison between results, obtained from different simulation models, for the static properties of end-tethered polymer layers in good solvent. Our analysis includes data from two previous studies--the bond fluctuation model of Wittmer et al. [J. Chem. Phys. 101, 4379 (1994)] and the off-lattice bead-spring model of Grest and Murat [Macromolecules 26, 3108 (1993)]. Additionally, we explore the properties of a similar off-lattice model simulated close to the Theta temperature. We show that the data for the bond fluctuation and the Grest-Murat model can be analyzed in terms of scaling theory because chains are swollen inside the Pincus blob. In the vicinity of the Theta point the structure of the chains is essentially Gaussian in the Pincus blob. Therefore, the data for the second off-lattice model can be compared quantitatively to the self-consistent field theory. Different ways to determine the parameters of the self-consistent field theory are discussed.

Journal Article↗
PubMed2003

Dynamical properties of the slithering-snake algorithm: a numerical test of the activated-reptation hypothesis.

Correlations in the motion of reptating polymers in a melt are investigated by means of Monte Carlo simulations of the three-dimensional slithering-snake version of the bond-fluctuation model. Surprisingly, the slithering-snake dynamics becomes inconsistent with classical reptation predictions at high chain overlap (created either by chain length N or by the volume fraction phi of occupied lattice sites), where the relaxation times increase much faster than expected. This is due to the anomalous curvilinear diffusion in a finite time window whose upper bound tau+(N) is set by the density of chain ends phi/N. Density fluctuations created by passing chain ends allow a reference polymer to break out of the local cage of immobile obstacles created by neighboring chains. The dynamics of dense solutions of "snakes" at t<<tau+ is identical to that of a benchmark system where all chains but one are frozen. We demonstrate that the subdiffusive dynamical regime is caused by the slow creeping of a chain out of its correlation hole. Our results are in good qualitative agreement with the activated-reptation scheme proposed recently by Semenov and Rubinstein (Eur. Phys. J. B, 1 (1998) 87). Additionally, we briefly comment on the relevance of local relaxation pathways within a slithering-snake scheme. Our preliminary results suggest that a judicious choice of the ratio of local to slithering-snake moves is crucial to equilibrate a melt of long chains efficiently.

Journal Article↗
PubMed2003

Structure formation of supercooled polymers in confined geometries--a molecular-dynamics simulation study.

Molecular-dynamics simulations of thin polymer films are performed with a recently introduced coarse-grained model. This model reproduces many features of polymer crystallization from the melt. In this work, we show how confining walls influence the structure formation depending on the degree of supercooling. Already in the melt at high temperature a preorder is induced near the walls. On lowering the temperature, crystalline order nucleates at the walls, from which it propagates into the film. We show how this growth can be influenced by prestructuring the wall.

Journal Article↗
PubMed2003

Confinement effects on the slow dynamics of a supercooled polymer melt: Rouse modes and the incoherent scattering function.

Results of large-scale molecular-dynamics simulations of a supercooled polymer film are presented (F. Varnik, J. Baschnagel, K. Binder, J. Phys. IV 10, 239 (2000)). The dynamic and static properties of the system are studied for a wide range of film thicknesses (from 3 to about 55 times the bulk radius of gyration) and temperatures (from the normal liquid state to the supercooled region). The system is confined between two completely smooth and purely repulsive walls. Motivated by the previous results on the enhancement of the local relaxation dynamics due to the confinement (F. Varnik, J. Baschnagel, K. Binder, Eur. Phys. J. E 8, 175 (2002); Phys. Rev. E. 65, 021507 (2002)), we now study the effect of the walls on the dynamics of the Rouse modes. It has been reported from Monte Carlo studies of the Bond Fluctuation Model (BFM) that, contrary to the enhancement of the "cage dynamics" (exemplified by a faster relaxation of the incoherent scattering function in the film), Rouse modes exhibit a slower relaxation in the confined system (C. Mischler, J. Baschnagel, K. Binder, Adv. Colloid Interface Sci. 94, 197 (2001)). However, we do not observe such a discrepancy for our continuum model: At a given temperature, the relaxation of a given Rouse mode is faster in the film than in the bulk in accordance with the acceleration of the dynamics around the cage.

Computer Simulation↗
PubMed2002

Reduction of the glass transition temperature in polymer films: a molecular-dynamics study.

We present results of molecular-dynamics simulations for a nonentangled polymer melt confined between two completely smooth and repulsive walls, interacting with inner particles via the potential U(wall)=(sigma/z)(9), where z=/z(particle)-z(wall) and sigma is (roughly) the monomer diameter. The influence of this confinement on the dynamic behavior of the melt is studied for various film thicknesses (wall-to-wall separations) D, ranging from about 3 to about 14 times the bulk radius of gyration. A comparison of the mean-square displacements in the film and in the bulk shows an acceleration of the dynamics due to the presence of the walls. This leads to a reduction of the critical temperature T(c) of the mode coupling theory with decreasing film thickness. Analyzing the same data by the Vogel-Fulcher-Tammann (VFT) equation, we also estimate the VFT temperature T0(D). The ratio T0(D)/T(bulk)(0) decreases for smaller D similarly to T(c)(D)/T(bulk)(c). These results are in qualitative agreement with that of the glass transition temperature observed in some experiments on supported polymer films.

Journal Article↗
PubMed2002

Static and dynamic properties of supercooled thin polymer films.

The dynamic and static properties of a supercooled (non-entangled) polymer melt are investigated via molecular-dynamics (MD) simulations. The system is confined between two completely smooth and purely repulsive walls. The wall-to-wall separation (film thickness), D, is varied from about 3 to about 14 times the bulk radius of gyration. Despite the geometric confinement, the supercooled films exhibit many qualitative features which were also observed in the bulk and could be analyzed in terms of mode-coupling theory (MCT). Examples are the two-step relaxation of the incoherent intermediate scattering function, the time-temperature superposition property of the late time alpha-process and the space-time factorization of the scattering function on the intermediate time scale of the MCT beta-process. An analysis of the temperature dependence of the alpha-relaxation time suggests that the critical temperature, T(c), of MCT decreases with D. If the confinement is not too strong ( D>or=10monomer diameter), the static structure factor of the film coincides with that of the bulk when compared for the same distance, T - T(c)( D), to the critical temperature. This suggests that T - T(c)( D) is an important temperature scale of our model both in the bulk and in the films.

Journal Article↗