PubMed Health⌕ Search

Biomedical subjects

J C de Lima

Publications and source records attributed to J C de Lima.

4 recordsLinked to original sources
PubMed2004

Structural study of Cu(2-x)Se alloys produced by mechanical alloying.

The crystalline structures of the superionic high-temperature copper selenides Cu(2-x)Se (0 < x < 0.25) produced using mechanical alloying were investigated using X-ray diffraction (XRD). The measured XRD patterns showed the presence of peaks corresponding to the crystalline superionic high-temperature alpha-Cu(2)Se phase in the as-milled sample, and its structural data were determined by means of a Rietveld refinement procedure. After heat treatment in argon at 473 K for 90 h, this phase transforms to the superionic high-temperature alpha-Cu(1.8)Se phase, whose structural data were also determined by Rietveld refinement. In this phase, a very low occupation of the trigonal 32(f) sites ( approximately 3%) by Cu ions is found. In order to explain the evolution of the phases in the samples, two possible mechanisms are suggested: (i). the high mobility of Cu ions in superionic phases and (ii). the important diffusive processes in the interfacial component of samples produced by mechanical alloying.

Alloys↗
PubMed2004

Reverse Monte Carlo simulations, Raman scattering, and thermal studies of an amorphous Ge30Se70 alloy produced by mechanical alloying.

The short- and intermediate-range orders of an amorphous Ge30Se70 alloy produced by mechanical alloying were studied by reverse Monte Carlo simulations of its x-ray total structure factor, Raman scattering, and differential scanning calorimetry. The simulations were used to compute the G(Ge-Ge) (RMC)(r), G(Ge-Se) (RMC)(r), and G(Se-Se) (RMC)(r) partial distribution functions and the S(Ge-Ge) (RMC)(K), S(Ge-Se) (RMC)(K), and S(Se-Se) (RMC)(K) partial structure factors. We calculated the coordination numbers and interatomic distances for the first and second neighbors and the bond-angle distribution functions Theta(ijl)(cos theta). The data obtained indicate that the structure of the alloy has important differences when compared to alloys prepared by other techniques. There are a high number of Se-Se pairs in the first shell, and some of the tetrahedral units formed seemed to be connected by Se-Se bridges.

Journal Article↗
PubMedDate not supplied

[Inefficacy of bothropic antivenin in the neutralization of the coagulation activity of Lachesis muta muta venom. Report of a case and experimental confirmation].

In the State of Amazonas and in areas nearby Manaus, the snakes responsible for the majority of accidents are Bothrops atrox and Lachesis muta muta, with a percentage of confirmed species of 76% and 17%, respectively. Frequently, in the absence of the laquetic and bothropic-laquetic antivenoms, the Instituto de Medicina Tropical de Manaus (IMTM) has been using bothropic antivenom in the treatment of laquetic accident. In this paper is related a case of accident caused by L. muta muta; the patient was treated with bothropic antivenom, and after received twenty ampoules of this antivenom, maintained blood incoagulability until the 13th day after the accident. Experiments to obtain the potency of the bothropic antivenom for the coagulant and hemorrhagic activities has been done, using Bothrops atrox venom as control. The results showed that the potency of the antivenom for the hemorrhagic activity was similar, and the potency for the coagulant activity for the L. m. muta venom was 9.2 times minor than that for B. atrox. The antibodies titles from three different lots of bothropic antivenom varied for the L. m. muta venom, and were constant for the B. atrox venom. Due to the inefficiency of the bothropic antivenom on the neutralization of the coagulant activity for the L. m. muta venom, the use of bothropic antivenom is not recommended in the treatment of Lachesis muta muta accidents.

Adult↗