Biomedical subjects

J F Fabries

Publications and source records attributed to J F Fabries.

3 recordsLinked to original sources

PubMed2002

Development and validation of a new bitumen fume generation system which generates polycyclic aromatic hydrocarbon concentrations proportional to fume concentrations.

Bitumen fumes emitted during road paving and roofing contain polycyclic aromatic compounds (PACs) of potential health concern. Little information is available for an experimental device devoted to inhalation experiments with animals exposed to bitumen fumes, and in all studies the systems were never validated for a range of fume concentrations, which prohibited their use for toxicological concentration-effect studies. Therefore, the purpose of this study was to validate a new experimental device able to generate bitumen fumes at different total particulate matter (TPM) concentrations with a linear correlation between TPM and the concentrations of different PACs, thus allowing toxicological dose-response studies with fumes representative of those in the field. Atmosphere samples collected from an animal exposure chamber allowed the determination of TPM, toluene soluble matter, polycyclic aromatic hydrocarbons (PAHs) and semi-volatiles. The particulate size distributions were determined in order to assess the deposition pattern in the respiratory tract. The temperature of 170 degrees C was chosen by analogy with the upper range of the temperature used during paving operations. The temperature of the air passing over the fume emission area was regulated to 20 degrees C and stirring of the heated bitumen was restricted to 90 r.p.m. The data show that the objective of developing a static fume generation system that reproducibly produces fumes in the inhalation chamber for specified target concentrations (TPM) were successful. The within-day variation coefficients for TPM were between 2.5 and 6.1%. The day-to-day variations for TPM concentration were between 4.1 and 5.8%. The concentrations of the 4-5 ring PAHs and the polycyclic aromatic sulphur heterocycles were proportional to the TPM concentration. The 2 and 3 ring PAH concentrations showed a deviation from proportionality with the TPM, probably due to their re-evaporation during sampling. The mass median aerodynamic diameter of airborne particles varied from 1.4 micro m at a fume concentration of 5 mg/m(3) to 3.2 micro m at 100 mg/m(3). In conclusion, this equipment was suitable for nose-only inhalation studies in the 5-100 mg/m(3) range of TPM. Bitumen fumes were generated with a good reproducibility under well-controlled conditions. Finally, the PAH profiles from atmospheric samples were in good agreement with those measured during road paving.

Hydrocarbons↗

PubMed2001

[Specific bronchial provocation test with solid aerosols. Quantification of results].

OBJECTIVES: To determine 1) the level of specific bronchial reactivity by challenge with flour and 2) the criteria of positivity using a new method for the expression of the results. METHOD: Thirty-eight asthmatic subjects, occupationally exposed to wheat flour, performed a challenge with lactose then with flour. The instantaneous measurement of the concentration and of the inspiratory airflow were used to calculate the inhaled dose and to establish the dose-response relationships. The results were given 1) by the dose of flour provoking a 20% fall in FEV1 (PDf20), 2) by the comparison of the variation of the FEV1 during the challenge with flour to the distribution of the values observed during the challenge with lactose (inferior limit of the confidence interval at 99.7%). RESULTS: The variations of the FEV1 were not significantly related to the inhaled dose of lactose. The specific bronchial reactivity to flour was a continuous data and three groups were distinguished: 1) subjects (n = 15) with high bronchial reactivity had a fall of FEV1 of more than 20% 2) subjects (n = 13) without significant variation of the FEV1 for doses higher than 1,400 micrograms by comparison to the distribution of the values of the lactose test 3) subjects (n = 10) with a significant fall of FEV1 by comparison to the distribution of the values of the lactose test but lower than 20%. For this group with moderate reactivity, the flow of the inhaled dose may be determinant for the bronchial response. CONCLUSIONS: PDf 20 measures the specific bronchial reactivity. However, if the fall in FEV1 is lower than 20%, the specific challenge with flour may be compared to the challenge with lactose to detect the subjects with moderate reactivity. Our results confirmed the role of the inhaled dose and suggested the role of the dose rate in the outset of bronchial obstruction among asthmatic subjects.

Administration, Inhalation↗

PubMed1997

[Occupational asthma caused by buckwheat flour].

Buckwheat flour, mainly used for pancakes, may induce asthma following inhalation and anaphylactic reactions following ingestion. These allergic reactions are mediated by specific IgE and may be confirmed by skin test and radio-allergo-sorbent test. The occupational asthma of a patient working in pancake restaurant was confirmed by specific challenge test with a computerised device to generate particles. A very small amount of buckwheat flour (10 micrograms) induced an immediate fall of the FEV1 to 56% of the initial value. No bronchial reaction was observed with lactose nor with wheat flour. Specific bronchial challenge identifies the allergen responsible for asthma, measures the level of sensitization and thus can prevent the occupational exposure.

Adult↗