Biomedical subjects

J Faist

Publications and source records attributed to J Faist.

16 recordsLinked to original sources

PubMed2006

Doppler-free saturated-absorption spectroscopy of CO2 at 4.3 microm by means of a distributed feedback quantum cascade laser.

We report the application of a cw distributed feedback quantum cascade laser to Lamb-dip spectroscopy of CO2 at 4.3 microm. With the laser operating in the free-running mode, we observed the sub-Doppler profile of the P(28) line of the (0,1(1),0)->(0,1(1),1) hot band by implementing a pump-probe scheme and using wavelength modulation spectroscopy for highly sensitive detection of saturated absorption signals. We investigated the main limitations to the observation of a narrow resonance, with particular attention to the effect of the laser current noise. We determined the intrinsic laser emission width, which was found to be approximately 3.4 MHz (FWHM) for an observation time of approximately 200 ms.

Journal Article↗

PubMed2006

Positive cross correlations in a normal-conducting fermionic beam splitter.

We investigate a beam-splitter experiment implemented in a normal-conducting fermionic electron gas in the quantum Hall regime. The cross correlations between the current fluctuations in the two exit leads of the three terminal device are found to be negative, zero, or even positive, depending on the scattering mechanism within the device. Reversal of the cross correlation sign occurs due to interaction between different edge states and does not reflect the statistics of the fermionic particles which "antibunch."

Journal Article↗

PubMed2005

ac Stark splitting and quantum interference with intersubband transitions in quantum wells.

Resonant optical coupling experiments have demonstrated coherent quantum interference between the Stark-split "dressed states" of a synthesized 3-level electronic system in a semiconductor quantum well. Analysis of the dephasing mechanisms reveals dipole selection rules closely analogous to those seen in atomic spectroscopy experiments. In this respect, these systems behave as "artificial atoms" for the purposes of observing a range of nonclassical coherent optical effects. The prospects for exploiting them for scalable quantum information processing applications are more promising than previous dephasing models would have predicted.

Journal Article↗

PubMed2004

Heterodyne mixing of two far-infrared quantum cascade lasers by use of a point-contact Schottky diode.

We demonstrate heterodyne mixing of two free-running, multimode, 3.3-THz quantum cascade lasers by use of a point-contact Schottky diode. By temperature tuning the emission wavelength of one laser, a difference frequency signal spanning the 2-4-GHz range is obtained, with a signal-to-noise ratio of 30 dB. The frequency of the heterodyne signal is subject to random fluctuations of a few megahertz, principally from instabilities in the temperatures of the devices. From single-shot measurements we derive an instantaneous linewidth for a single Fabry-Perot mode of 20 kHz, corresponding to an integration time of 3.6 ms.

Journal Article↗

PubMed2004

Linewidth and tuning characteristics of terahertz quantum cascade lasers.

We have measured the spectral linewidths of three continuous-wave quantum cascade lasers operating at terahertz frequencies by heterodyning the free-running quantum cascade laser with two far-infrared gas lasers. Beat notes are detected with a GaAs diode mixer and a microwave spectrum analyzer, permitting very precise frequency measurements and giving instantaneous linewidths of less than -30 kHz. Characteristics are also reported for frequency tuning as the injection current is varied.

Journal Article↗

PubMed2003

Free-running 9.1-microm distributed-feedback quantum cascade laser linewidth measurement by heterodyning with a C18O2 laser.

We report spectral linewidth measurements of a 9.1-microm distributed-feedback quantum cascade laser (QCL). The free-running QCL beam was mixed with a waveguide isotopic C18O2 laser onto a high-speed HgCdTe photomixer, and beat notes were recorded from a radio-frequency spectral analyzer. Beating was performed at two operating conditions, first near the QCL laser threshold (beating with the C18O2 R10 line) and then at a high injection current (beating with the C18O2 R8 line). Overall, beat note widths of 1.3-6.5 MHz were observed, which proves that a free-running QCL can have a short-term spectral width near 1 MHz.

Journal Article↗

PubMed2002

Chemical sensing with pulsed QC-DFB lasers operating at 15.6 micrometers.

Pulsed thermoelectrically cooled QC-DFB lasers operating at 15.6 micrometers were characterized for spectroscopic gas sensing applications. A new method for wavelength scanning based on repetition rate modulation was developed. A non-wavelength-selective pyroelectric detector was incorporated in the sensor configuration giving the advantage of room-temperature operation and low cost. Absorption lines of CO2 and H2O were observed in ambient air, providing information about the concentration of these species.

Atmosphere↗

PubMed2000

Intersubband electroluminescence from silicon-based quantum cascade structures.

The quantum cascade laser, which uses electronic transitions within a single band of a semiconductor, constitutes a possible way to integrate active optical components into silicon-based technology. This concept necessitates a transition with a narrow linewidth and an upper state with a sufficiently long lifetime. We report the observation of intersubband electroluminescence from a p-type silicon/silicon-germanium quantum cascade structure, centered at 130 millielectron volts with a width of 22 millielectron volts, with the expected polarization, and discernible up to 180 kelvin. The nonradiative lifetime is found to depend strongly on the design of the quantum well structure, and is shown to reach values comparable to that of an equivalent GaInAs/AlInAs laser structure.

Journal Article↗

PubMed2000

Mid-infrared quantum cascade lasers for flow injection analysis

A Fabry-Perot quantum cascade laser (QCL) was used as a powerful light source for mid infrared (MIR) detection in flow injection analysis. The QCL lased at several wavelengths close to each other within a few wavenumbers (990-1010 cm-1), hence fitting well to the broad absorption bands of molecules in liquid phase. As compared with that of a state-of-the-art Fourier transform spectrometer, the signal-to-noise ratio could be improved by a factor of 50. Additionally, by using a QCL as the light source, optical path lengths of more than 100 microns could be used even in aqueous matrixes which reduced the danger of cell clogging. In the example shown here phosphate was determined in Diet Coke samples. The flow injection system used allowed the measurement of the sample at two pH values (5 and 13) at which the analyte was present as H2PO4- and PO4(3-), respectively. As the analytical readout the difference in IR absorption of H2PO4- and PO4(3-) at the laser wavelengths was taken. The FIA-QCL measurements were corroborated by ion chromatography which was used as a reference method.

Journal Article↗

PubMed1998

High-power directional emission from microlasers with chaotic resonators

High-power and highly directional semiconductor microcylinder lasers based on an optical resonator with deformed cross section are reported. In the favorable directions of the far-field, a power increase of up to three orders of magnitude over the conventional circularly symmetric lasers was obtained. A "bow-tie"-shaped resonance is responsible for the improved performance of the lasers in the higher range of deformations, in contrast to "whispering-gallery"-type modes of circular and weakly deformed lasers. This resonator design, although demonstrated here in midinfrared quantum-cascade lasers, should be applicable to any laser based on semiconductors or other high-refractive index materials.

Journal Article↗

PubMed1997

High-Power Infrared (8-Micrometer Wavelength) Superlattice Lasers

A quantum-cascade long-wavelength infrared laser based on superlattice active regions has been demonstrated. In this source, electrons injected by tunneling emit photons corresponding to the energy gap (minigap) between two superlattice conduction bands (minibands). A distinctive design feature is the high oscillator strength of the optical transition. Pulsed operation at a wavelength of about 8 micrometers with peak powers ranging from approximately 0.80 watt at 80 kelvin to 0.2 watt at 200 kelvin has been demonstrated in a superlattice with 1-nanometer-thick AlInAs barriers and 4.3-nanometer-thick GaInAs quantum wells grown by molecular beam epitaxy. These results demonstrate the potential of strongly coupled superlattices as infrared laser materials for high-power sources in which the wavelength can be tailored by design.

Journal Article↗

PubMed1996