Biomedical subjects

J Gateño

Publications and source records attributed to J Gateño.

2 recordsLinked to original sources

PubMed2000

Computer planning for distraction osteogenesis.

Distraction osteogenesis of the mandible has found an application in the treatment of patients with a variety of different mandibular deformities. Compared with the relatively simple unidirectional distraction of long bones as described by Ilizarov, the three-dimensional distraction of the mandible is extremely complex. Whereas experience with orthognathic surgery clearly demonstrates that careful presurgical planning is necessary to achieve predictable outcomes, there are few reported methods for the planning of mandibular distraction. The authors have developed a method for planning distraction osteogenesis of the mandible that involves the use of three-dimensional modeling and animation to simulate distraction osteogenesis in virtual reality. The first step in the authors' treatment planning process is to obtain a three-dimensional computerized scan of the facial skeleton. From this scan, a three-dimensional wire-mesh model is built using animation software. With the same software, a virtual distractor is built and installed on the wire-mesh model. The osteotomies and the distraction process are then simulated. Finally, a recipe for sequencing the linear and angular changes of the distractor is calculated. The authors have used this planning process in seven patients (age range, 4 to 10 years): four with unilateral mandibular deformities and three with bilateral. The planning process has yielded predictable and reproducible results.

Child↗

PubMed2000

Distraction osteogenesis: a new surgical technique for use with the multiplanar mandibular distractor.

If distraction osteogenesis is to reach its full potential and achieve the level of accuracy that is possible with orthognathic surgery, its outcomes need to be as predictable. To this end, the authors developed a planning process for distraction osteogenesis similar to that used in orthognathic surgery. However, the success of the planning process depends on the authors' ability to execute the plan at the time of surgery. As a result, the authors needed to develop a surgical technique that would enable them to precisely install the distractor as indicated in the presurgical plan. The surgical technique presented in this article was developed for this purpose. The authors used this technique in seven patients (four boys and three girls; age range, 4 to 10 years). Four patients presented with unilateral deformities, and three patients presented with bilateral deformities. The follow-up period in this group of patients ranged from 12 to 33 months. The purpose of the technique is to replicate the position of the distractor on the mandible as determined by the presurgical plan. To this purpose, a custom drill guide and a surgical template have been developed. Both of these are used following the principles of triangulation to establish the pin position and orientation of the distractor. In the authors' hands, the use of this surgical technique has resulted in outcomes close to those predicted by the planning process.

Child↗