Biomedical subjects

J Laven

Publications and source records attributed to J Laven.

7 recordsLinked to original sources

PubMed2004

The outermost atomic layer of thin films of fluorinated polymethacrylates.

In this paper, we investigate the surface properties of a series of copolymers of perfluoroalkyl methacrylate (CH2 = C(CH3)COOCH2CnF(2n + 1), n = 1, 6, or 10) and methyl methacrylate (MMA) and of blends of perfluorooctyl-end-capped poly(methyl methacrylate) (PMMA) and pure PMMA. The introduction of perfluoroalkyl groups significantly lowers the polymer surface energy as determined by the acid-base approach. X-ray photoelectron spectroscopy (XPS) confirms a higher fluorine concentration in the surface region (the outer 3.8 nm) as compared to in the bulk. The fluorine density in the outermost atomic layer is quantitatively determined by low-energy ion scattering (LEIS). A linear relationship is found between the fluorine density in the outermost atomic layer and the surface energy of the partially fluorinated polymethacrylates, irrespective of the length of the perfluoroalkyl chain. This linearity confirms Langmuir's "principle of independent surface action". Deviation from this linear relationship exists for both highly and sparsely fluorinated polymethacrylates and can be ascribed to the local (surface) ordering of the fluorinated tails and MMA units, respectively. This study may offer one further step toward a deeper understanding of the correlations between macroscopic surface properties and microscopic surface chemical composition.

Journal Article↗

PubMed2004

Quantification of fluorine density in the outermost atomic layer.

The outermost atomic layer of perfluorinated thiol monolayers on gold and poly(tetrafluoroethylene) (PTFE) is analyzed by low-energy ion scattering. Absolute quantification of fluorine density in this layer was achieved after calibrating the fluorine signal with a freshly cleaved LiF(100) single crystal. The fluorine density of monolayers of a C8F17-thiol on gold was 1.48 x 10(15) F atoms/cm2, whereas for PTFE a value of 1.24 x 1015 F atoms/cm2 was observed. This difference was explained by the different tilt angles of the thiol on gold and PTFE chains with respect to the surface normal. Both a configurational and a molecular interpretation on the perfluorinated thiol monolayer on gold are given.

Crystallization↗

PubMed2003

Advances in the Raman depth profiling of polymer laminates.

The use of Raman microspectroscopy to depth profile multi-layered polymer laminates is becoming increasingly popular. However, the results are generally degraded by aberrations introduced by the change in refractive index at the air/sample interface. Recent research has suggested that the use of an immersion oil and suitable objective can reduce this effect. This study evaluates this proposal by comparing depth profiling results on a multi-layer poly(styrene)/poly(methylmethacrylate) (PS/PMMA) laminate polymer from both dry metallurgical objectives and immersion objectives (used in combination with an oil of suitable refractive index). The immersion technique enabled successful depth profiling to the full working distance of the objective (100 microm), showing clear and distinct variations in 11 different layers within the laminate; a dry metallurgical objective used for comparison achieved poor resolution of only two layers. This is the first demonstration of depth profiling within a polymer laminate to this depth. The depth profiling results are compared to results obtained by sectioning the PS/PMMA sample after setting it in resin.

Journal Article↗

PubMed2001

Steady shear rate rheology of suspensions, as described by the giant floc model.

The break-down of a particle network by shear is described as the development of shear planes: a region able to withstand low shear stresses may break down under a larger stress; thus with increasing shear stress and shear rate, the mutual distance (A) between successive shear planes decreases until, at very high shear rates, A approaches the particle diameter. The shear planes are idealised as flat planes. Energy dissipation during shear is predominantly due to the energy dissipated through the movement of the particles; the energy dissipation due to breakage and renewed formation of bonds between particles is relatively small. A consideration of the energy dissipated during the encounters of particles during shear, including that dissipated by entrained particles, then leads to a relation between this energy dissipation and the average fraction L, over which a moving particle entrains a neighbour. L includes the effect of parts of the network which are rotating under the influence of the shear. In the limit of large shear rates, L is found to depend only to a small extent on whether the suspension is coagulated or not.

Models, Chemical↗

PubMed2001

Age-related differences in features associated with polycystic ovary syndrome in normogonadotrophic oligo-amenorrhoeic infertile women of reproductive years.

OBJECTIVE: To assess the effect of age on clinical, endocrine and sonographic features associated with polycystic ovary syndrome (PCOS) in normogonadotrophic anovulatory infertile women of reproductive years. DESIGN: Cross-sectional study. METHODS: Four hundred and seventy-two oligo-amenorrhoeic infertile patients, presenting with normal FSH and oestradiol concentrations, aged 17-42 years underwent a standardised initial evaluation including: cycle history, body mass index, waist-to-hip ratio and transvaginal ultrasound scanning of ovaries. Fasting blood samples were obtained for extensive endocrine evaluation. Cycle duration, serum levels of gonadotrophins, androgens, oestradiol, insulin, glucose, inhibin B as well as mean number of follicles, ovarian volume and ovarian stroma echogenicity were assessed. RESULTS: Older women had significantly lower LH and androgen and inhibin B serum levels. Similarly, older women presented with a reduced number of ovarian follicles. Age was inversely correlated with cycle duration (r=-0.112, P=0.02), LH (r=-0.154, P=0.001), testosterone (r=-0.194, P=0.001), androstenedione (r=-0.170, P=0.001), dehydroepiandrosterone (r=-0.157, P=0.001), insulin (r=-0.126, P=0.02), inhibin B (r=-0.118, P=0.03) serum levels and mean follicle number (r=-0.100, P=0.03). A positive correlation was observed between age and glucose to insulin ratio (r=0.138, P=0.009). CONCLUSIONS: Advanced age in normogonadotrophic anovulatory infertile women is associated with lower LH and androgen levels and with a decreased number of ovarian follicles. Although during reproductive years observed differences are relatively small, these age-related changes may affect the observed incidence of PCOS.

Adolescent↗

PubMed2000

Hydrodynamic aspects of slurry packing processes in microcolumn liquid chromatography.

A Stokesian dynamics computer simulation based method is presented for the estimation of the bed porosity of slurry-packed capillary liquid chromatography (LC) columns. A colloidally well-described reversed-phase stationary phase-slurry liquid suspension was used as a model system. The applied simulation method takes into account the velocity of the slurry and colloidal interaction forces, as well as inter-particle hydrodynamic interactions. The predicted bed porosities suggest that a lower slurry velocity leads to a denser packing structure due to the increased effect of colloidal repulsion effects. The results of the simulations were compared with the external porosity and chromatographic performance of capillary LC columns that were packed at different filtration and compaction pressures. However, the trends that were observed in the experimental results suggest that hydrodynamic packing parameters have no or little effect on the chromatographic performance of capillary LC columns. Within the experimental parameter window, the chromatographic performance and the column porosity were not influenced by the filtration and compaction pressure, nor by the duration of the compaction process.

Chromatography, Liquid↗

PubMed1999

The bacteriological changes after re-using a vaginal continence guard.

BACKGROUND: Involuntary loss of urine is a major health care problem, especially in women. The Conveen Continence Guard is a non-surgical treatment of stress incontinence. A possible risk of vaginal devices is introduction of changes in bacteriological flora of the vagina, especially after re-use of the guard. Moreover, vaginal devices can induce magnesium ion deficiency and thereby facilitate growth of Staphylococcus Aureus. This can lead to the production of toxin-1, eventually resulting in toxic shock syndrome. METHODS: The first aim of this study was to investigate the capacity to absorp magnesium ions in an in-vitro study. Secondly, 14 patients with stress incontinence were examined for bacteriological changes in the vagina after re-using the continence guard for four days. After completing this study the patients were asked whether re-using the continence guard was as convenient as single use. RESULTS: The continence guard had no absorption capacity for magnesium ions. The vaginal bacteriological changes after re-use showed in 11% changes in bacterial growth and in 20% increased bacterial growth. Only one patient developed a vaginal colonization with Staphylococcus Aureus but had no symptoms of disease. The continence guard showed itself to be less effective in preventing stress incontinence after re-use. CONCLUSIONS: Although re-use of the continence guard is feasable from a bacteriological point of view, re-use renders the device less effective.

Absorption↗