PubMed Health⌕ Search

Biomedical subjects

J M Cabral

Publications and source records attributed to J M Cabral.

At least 37 records · Page 2Linked to original sources

Recovery of a monoclonal antibody from hybridoma culture supernatant by affinity precipitation with Eudragit S-100.

An IgG1 monoclonal antibody (MAB) was isolated from hybridoma culture supernatant by affinity precipitation with an Eudragit S-100-based heterobifunctional ligand. Affinity binding was performed in a homogeneous aqueous phase at pH 7.5 followed by precipitation of the bound affinity complex by lowering the pH to 4.8. After two washing steps, elution of specifically bound MAB was achieved by incubating the precipitate with 0.1 M glycine.HCl pH 2.5. The influence of elution volume and time on the recovery of active MAB and the overall purification factor were studied. The best conditions enabled the recovery of 50.2% of active MAB with a purification factor of 6.2. A further dialysis against 50 mM Tris.HCl pH 8.0 increased the activity yield and the purification factor to 68.4% and 8.3, respectively. This result showed that part of the antibody activity loss during affinity precipitation was due to a reversible inactivation process, being easily recovered after a refining dialysis step.

Antibodies, Monoclonal↗

Partial purification of penicillin acylase from Escherichia coli in poly(ethylene glycol)-sodium citrate aqueous two-phase systems.

Studies on the partition and purification of penicillin acylase from Escherichia coli osmotic shock extract were performed in poly(ethylene glycol)-sodium citrate systems. Partition coefficient behavior of the enzyme and total protein are similar to those described in other reports, increasing with pH and tie line length and decreasing with PEG molecular weight. However, some selectivity could be attained with PEG 1000 systems and long tie line at pH 6.9. Under these conditions 2.6-fold purification with 83% yield were achieved. Influence of pH on partition shows that is the composition of the system and not the net charge of the enzyme that determines the behaviour in these conditions. Addition of NaCl to PEG 3350 systems significantly increases the partition of the enzyme. Although protein partition also increased, purification conditions were possible with 1.5 M NaCl where 5.7-fold purification and 85% yield was obtained. This was possible due to the higher hydrophobicity of the enzyme compared to that of most contaminants proteins.

Chemical Phenomena↗

Hydrophobic interaction chromatography of Chromobacterium viscosum lipase on polypropylene glycol immobilised on Sepharose.

The fractionation of Chromobacterium viscosum lipase was performed using a polypropylene glycol-Sepharose gel. The influence of mobile phase composition on the adsorption of lipase on the gel was studied and it was found that the retention of lipase depends on the salt used and increased with increasing the ionic strength. The retention was not strongly affected by changing the pH value of the mobile phase. By using 20% (w/v) ammonium sulphate in phosphate buffer a total retention of lipase on the column was obtained and by simply decreasing the ionic strength of the buffer, desorption of lipase could be achieved. The chromatographic purification of Chromobacterium viscosum lipase by hydrophobic interaction chromatography on Sepharose CL-6B modified by covalent immobilisation of 1,4-butanediol diglycidyl ether, polyethylene glycol and polypropylene glycol was also compared.

Butylene Glycols↗

Cutinase: from molecular level to bioprocess development.

This review analyzes the role of cutinases in nature and their potential biotechnological applications. The cloning and expression of a fungal cutinase, Fusarium solani f. pisi, in Escherichia coli and Saccharomyces cerevisiae hosts are described. The three-dimensional structure of this cutinase is also analyzed and its function as a lipase is discussed and compared with other lipases. The biocatalytic applications of cutinase are described taking into account the preparation of different cutinase forms and the media in which the different types of reactions have been performed, namely hydrolysis, esterification, transesterification, and resolution of racemic mixtures. The stability of cutinase preparations is discussed and, in particular, the cutinase stability in anionic reversed micelles is analyzed considering the role of hexanol as a substrate, a cosurfactant, and a stabilizer. Process development, based on the operation of cutinase reactors, is also reviewed.

Bioreactors↗

Large-scale production of pharmaceutical-grade plasmid DNA for gene therapy: problems and bottlenecks.

Gene therapy is a promising process for the prevention, treatment and cure of diseases such as cancer, acquired immunodeficiency syndrome (AIDS) and cystic fibrosis. One of the methods used to administer therapeutic genes is the direct injection of naked or lipid-coated plasmid DNA, but this requires considerable amounts of plasmid DNA. There are several problems and bottlenecks associated with the design and operation of large-scale processes for the production of pharmaceutical-grade plasmid DNA for gene therapy.

Biopharmaceutics↗

Troubleshooting in gene splicing by overlap extension: a step-wise method.

A step-wise method for cloning intron-containing genes from genomic DNA is described. The two exons of the human proinsulin gene were separately amplified in two steps using, in the first step, completely homologous primers. This reduces unwanted interactions between mismatched primers and a complex DNA template such as genomic DNA. The fragments were amplified in a second step polymerase chain reaction (PCR) using mismatched primers that incorporated additional bases complementary to the other exon, and these products were spliced together in a third step PCR.

Cloning, Molecular↗

Analysis and use of endogenous nuclease activities in Escherichia coli lysates during the primary isolation of plasmids for gene therapy.

Two important issues in the downstream processing of plasmids for gene therapy are the stability of plasmids in the process streams, and the presence of contaminating host RNA. Results with a 4.8-kb plasmid harbored in a non-nuclease-deficient strain of Escherichia coli show that, in spite of the harsh conditions during alkaline lysis, a fraction of endogenous nucleases remains active, degrading both RNA and genomic and plasmid DNA. Although it is possible to minimize plasmid degradation by decreasing temperature and reducing processing times, the presence of endogenous nucleases can be used advantageously to purify the plasmid streams. The kinetics of nucleic acid degradation showed that, by controlling the incubation at 37 degrees C, it was possible to degrade RNA selectively, while maintaining plasmid integrity. A reduction of 40% in RNA content was obtained, corresponding to a 1.5-fold increase in plasmid purity using high-performance liquid chromatography (HPLC). This strategy is simple and straightforward, and the increase in processing time and the associated plasmid loss (9%) are fully justified by the purity increase. Furthermore, the use of endogenous RNase activity is clearly advantageous over alternative procedures, such as the addition of external RNase, in terms of cost, validation, and compliance with guidelines from regulatory agencies.

Biotechnology↗

Variation of penicillin acylase partition coefficient with phase volume ratio in poly(ethylene glycol)-sodium citrate aqueous two-phase systems.

The influence of phase volume ratio on partition and purification of penicillin acylase from Escherichia coli on poly(ethylene glycol)-sodium citrate aqueous two-phase systems was studied. In PEG 1000 systems both partition coefficients of the enzyme and total protein increased with decreasing phase volume ratio. However, in PEG 3350 containing NaCl, penicillin acylase follows a reverse trend, while total protein behaves in the same way. Implications for protein purification designs are discussed.

Chemistry Techniques, Analytical↗

Effect of electrolytes and surfactants on the thermoseparation of an ethylene oxide-propylene oxide random copolymer in aqueous solution.

The thermnoseparation of aqueous solutions of Breox 50 A 1000, an ethylene oxide-propylene oxide 50:50 (w/w) random copolymer, was studied. The cloud-point diagram for Breox in water solution and the effects of electrolytes and surfactants on the cloud-point temperature (CPT) were determined. The Breox concentration in both phases after the thermoseparation was followed with a reversed-phase HPLC method. The effects of separation temperature and additives on phase composition were evaluated.

Chromatography↗

Preliminary study on hydrophobic interaction chromatography of Chromobacterium viscosum lipase on polypropylene glycol immobilized on Sepharose.

The purification of Chromobacterium viscosum lipase was performed using a polypropylene glycol-Sepharose gel. The influence of the mobile phase composition on the chromatographic behaviour of Chromobacterium viscosum lipase was studied and it was found that the retention of lipase depends on the salt used and increased with ionic strength. Using 20% (w/v) ammonium sulphate in the eluent, a total retention of lipase on the column was obtained.

Bacterial Proteins↗

Preliminary studies on the purification of a monoclonal antibody by affinity precipitation with Eudragit S-100.

A simple procedure for the purification of an IgG-type monoclonal antibody by affinity precipitation using Eudragit S-100 is presented. The ligand, a microbial lipase previously used as antigen, was coupled to the polymer at a concentration of 40 mg lipase/g Eudragit. This macroligand was reversibly precipitated by manipulating the pH at values higher and lower than 4.8. The effects of polymer concentration and dilution of hybridoma culture supernatant on the overall precipitation process were evaluated. The best purification factor was achieved with a polymer concentration of 0.1% (w/v) and a supernatant dilution of 1:3. The preliminary studies reported here enabled the purification of a monoclonal antibody in one step with an activity yield (by ELISA) of 50%-55% and a purification factor of ca 6.

Affinity Labels↗

Purification of supercoiled plasmid DNA using chromatographic processes.

The interest in purifying injectable-grade plasmid DNA has increased with the development of gene therapy and DNA vaccination technologies. In this paper we develop a method for purifying a 4.8 kb plasmid based on chromatographic processes. An NaCl gradient was optimized on a Q Sepharose column and plasmid was eluted at 800-820 mM NaCl in a broad peak. Supercoiled plasmid was isolated after a final Sepharcryl S1000 SF gel filtration step. Final plasmid preparation was depleted of proteins and RNA, as revealed by the BCA assay and 1% agarose gel electrophoresis.

Acrylic Resins↗

Preliminary studies on continuous recovery and purification of the penicillin acylase under pseudo-affinity conditions using phenyl-Sepharose gel.

A continuous system for the recovery and purification of the penicillin acylase from crude extracts by recycling phenyl-Sepharose gel through three agitated vessels with disc filters of stainless steel is presented. The penicillin acylase present in the crude extract was absorbed into the phenyl-Sepharose gel under pseudo-affinity conditions (16% w/v of ammonium sulphate). After gel washing under the same conditions in the second vessel, enzyme desorption was performed using the same salt but at a lower concentration (6% w/v) in the third vessel. The preliminary studies reported here occurred without experimental difficulties, even at a gel concentration as high as 40% (v/v). The recovery of the penicillin acylase was achieved with high yield (74%), but a low purification factor of 2.4 was obtained owing to the use of a crude extract with low specific activity.

Affinity Labels↗

African histoplasmosis: therapeutic efficacy of itraconazole.

A patient with African form of histoplasmosis was treated for 7 years with ketoconazole, with no response; after a 9-month daily treatment with 100 mg of itraconazole the patient was successfully cured. No evidence of relapse was observed during the 3-year follow-up period.

Antifungal Agents↗

Biotransformation in organic media by enzymes and whole cells.

Biotransformation of poorly water soluble compounds in organic media by immobilized enzyme and whole cells is illustrated in this paper taking the following examples from the author's laboratory: (1) controlled hydrolysis of triglycerides and synthesis reactions by a recombinant lipolytic enzyme (cutinase); (2) enzymatic synthesis of dipeptides; (3) continuous production of isovaleraldehyde by Gluconobacter oxydans in isooctane; and (4) sitosterol side chain cleavage by Mycobacterium sp. The role of water and organic solvent are evaluated, namely the increase in the volumetric productivity of the reaction system and the shift of the reaction equilibrium in favour of product synthesis. High product yields have been obtained due to the reduction of substrate/product inhibition. Biocatalyst stability in the presence of the organic phase was also performed.

Adsorption↗

Thermal unfolding of proteins at high pH range studied by UV absorbance.

This work describes a methodology to monitor protein unfolding by using the well known changes in tyrosine absorbance with the ionization of the side chain phenol group. It can be applied to proteins that are functionally active at pH values higher than 9.0 where the current UV differential spectroscopy technique can not be used. The simplicity and facility of the proposed methodology (only two absorbance measurements have to be acquired) can make it very useful namely for technological applications. Thermal unfolding of cutinase and alpha-chymotrypsin were followed using this methodology and the thermodynamic stability data were obtained assuming a two-state mechanism. The transition from the folded to the unfolded state was further confirmed by fluorescence maxima for both proteins proving the validity of the methodology based on UV measurements.

Animals↗

Immobilization of a recombinant cutinase by entrapment and by covalent binding. Kinetic and stability studies.

Fusarium solani pisi recombinant cutinase, immobilized by entrapment in calcium alginate and by covalent binding on porous silica, was used to catalyze the hydrolysis of tricaprylin. The influence of relevant parameters on the catalytic activity such as pH, temperature, and the substrate concentration were studied. Cutinase immobilized by entrapment presented a Michaelis-Menten kinetics for tricaprylin concentrations up to 200 mM. At higher concentrations of substrate, inhibition was observed. For covalent binding immobilization, diffusional limitations were observed at low substrate concentrations and substrate inhibition occurred for concentrations higher than 150 mM. The stability of immobilized cutinase was also evaluated. The enzyme immobilized by entrapment showed a high stability, in contrast to the immobilization on porous silica.

Caprylates↗

Freeze/thawing and sonication of Escherichia coli TB1 cells for cytochrome b5 recovery.

The influence of sonication power, suspension volume and cell concentration on the kinectics of cytochrome b5 and intracellular protein release by sonication of Escherichia coli TB1 cells was studied. The influence of freezing and thawing of the cell suspension was also evaluated. Freezing and thawing increased the recovery yield of cytochrome b5. The sonication efficiency increased with the increase of sonication power and with the decrease of the suspension volume and cell concentration.

Animals↗