PubMed Health⌕ Search

Biomedical subjects

J Mühling

Publications and source records attributed to J Mühling.

At least 109 records · Page 6Linked to original sources
PubMed1995

Intraoperative navigation in oral and maxillofacial surgery.

Surgical procedures in the oral and maxillofacial region may be difficult in areas of complex anatomy. Up to now, surgical planning has been based almost exclusively on the surgeon's experience and on the interpretation of 2-dimensional (2D) radiologic information. Our experiences with a commercially available 3D navigation system (Viewing Wand, ISG, Mississauga, Ontario, Canada) is reported upon. The system consists of a mechanical operating arm with 6 joints and 6 degrees of freedom working as a 3D digitizer and is interfaced to a computer graphics workstation. After registration of the position of the patient's head in relation to the tip of the instrument on the navigation arm, the surgeon can observe the 3D position and direction of the instrument in use on the monitor, i.e. on the computed tomography and/or magnetic resonance tomography images of the patient taken before. In 40 interventions performed so far, the accuracy was 2 mm and better. 3 cases are presented in this paper. The system facilitates surgery especially in anatomically complicated situations without the risk of damaging neighbouring structures. Planning of surgical interventions is much easier. By using computer assisted simulation and navigation systems, we expect an improvement in quality and a reduction in surgical risks. Thus, "looking ahead" surgery has become possible. More extensive and more radical interventions are likely to be performed in the near future. Responsibility for the surgical intervention, however, remains exclusively with the surgeon.

Carcinoma, Adenoid Cystic↗
PubMed1995

Repair of human skull defects using osteoinductive bone alloimplants.

To estimate the efficacy of cranioplasty in clinical practice, autolyzed, antigen-extracted, allogenic (AAA) bone was prepared from cortical bones of human organ donors. AAA bone implants consisted of completely demineralized bone powder, completely demineralized pliable bone chips, surface-demineralized bone chips with pliable crevices, surface-demineralized rigid bone chips, or combinations thereof. 21 patients received AAA bone cranioplasties and were followed-up for between 12 and 58 months (average: 29 months). No infection or rejection of any of the AAA bone implants occurred. X-ray assessments as well as bone scintigraphies revealed osseous integration and remodelling of the AAA bone implants with minimal resorption, with the exception of completely demineralized AAA bone chips which showed partial resorption (2 cases). However, the partial resorption of completely demineralized AAA bone chips ceased after the implants had been remodelled. In 4 cases, the osteosynthesis material was removed between 10 and 18 months after the cranioplasty. In another case, a re-entry was necessary because of recurrence of an intracranial tumor. All of these five AAA bone reconstructions showed bleeding surfaces and osseous consolidations at the time of re-entry. A bone biopsy taken from one of these cranioplasties showed osteoinduction on the surface of the AAA bone implants. This first clinical review of cranial reconstructions using osteoinductive AAA bone implants emphasizes the therapeutical application of AAA bone for cranioplasty. Large AAA bone chips from human skull bones facilitate the reproduction of the skull's convexity especially when combined with preoperative stereolithography-based planning.

Adolescent↗
PubMed1994

Poly(L-lactide): a long-term degradation study in vivo. Part II: Physico-mechanical behaviour of implants.

Three different poly(L-lactide) rods (25 x 3 x 2 mm) were produced either by injection moulding or machined out of a solid as-polymerized polylactide block and were implanted for 1-116 months into the dorsal muscle of rats. After recovery, the polylactide specimens were carefully cleaned, dried, photographed and weighed. Bending strength and Young's modulus of elasticity were determined. The surfaces of the broken rods were examined by scanning electron microscopy. Block polylactide samples initially looked milky. They became friable and broke into white or brownish fragments during the implantation period, whereas total disintegration could not be observed. Electron scanning microscopy revealed a porous surface with crystalline elements persisting for the whole time. Mechanical stability fell from 127 +/- 3 MPa at implantation time to about half after 3 wk (61 +/- 4 MPa) and about a quarter (32 +/- 4 MPa) after 6 wk. Both injection-moulded polyactides (A1 and A2) were clear and transparent initially. After implantation they gradually became whitish, fragmented after about 64 wk and disintegrated 90 wk later into small parts and powder. Electron scanning microscopy at first showed a homogeneous surface. A kind of cortex developed after about 4 wk and deep cracks ran through the rod after 32 wk. Round pores of 1.5-10 microns diameter developed after 1 yr of implantation. Bending strengths were 130 +/- 8 MPa (A1) and 115 +/- 14 MPa (A2); these remained nearly stable over about 12 wk, then declined linearly. Although a higher initial mechanical strength is desirable for use in osteosynthetic devices, mechanical stability of amorphous injection-moulded polylactides over the first 12 wk and total disintegration thereafter approaches the requirements for their use as a material for osteosynthesis.

Animals↗
PubMed1994

Preoperative radiochemotherapy and radical surgery in comparison with radical surgery alone. A prospective, multicentric, randomized DOSAK study of advanced squamous cell carcinoma of the oral cavity and the oropharynx (a 3-year follow-up).

A multicentric, randomized study of squamous cell carcinoma (SCC) of the oral cavity and the oropharynx has been undertaken by DOSAK. The results after radical surgery alone have been compared with the results of combined preoperative radiochemotherapy followed by radical surgery. Patients with primary (biopsy proven) SCC of the oral cavity or the oropharynx with tumor nodes metastasis (TNM) stages T2-4, N0-3, M0 were included in the study. A total of 141 patients were treated by radical surgery alone, whereas 127 patients were treated by radical surgery preceded by preoperative radiochemotherapy. The preoperative treatment consisted of conventionally fractioned irradiation on the primary and the regional lymph nodes with a total dose of 36 Gy (5 x 2 Gy per week) and low-dose cisplatin chemotherapy with 5 x 12.5 mg cisplatin per m2 of body surface during the first week of treatment. Radical surgery according to the DOSAK definitions (DOSAK, 1982) was performed after a delay of 10-14 days. During the follow-up period, 28.2% of all patients suffered from locoregional recurrence, and 27.2% of the patients died. The percentages were higher after radical surgery alone for locoregional recurrence (31% and 15.6%) and for death (28% and 18.6%). The life-table analysis showed improved survival rates of 4.5% after 1 year and 8.3% after 2 years in the group of patients treated with combined therapy. The demonstrated improvement appeared to be significant with the Gehan-Wilcoxon test as well as with the log rank test below a P value of 5%.

Carcinoma, Squamous Cell↗
PubMed1994

The use of the 'de-epithelialized' scapular flap for soft tissue augmentation--a case report.

For the augmentation of maxillo-facial soft tissue deficiencies, microsurgical 'pure' fat transplants have proven effective. In this paper, we present the 'de-epithelialized' scapular flap and discuss its significance in comparison with other microvascular fat transfers. Consistency of transplant vessels and minimal dependence of volume on the overall nutritional condition are its specific advantages. The transplant can be securely fixed at the retained corium.

Adipose Tissue↗
PubMed1994

[Craniofacial surgical techniques for reconstruction of the facial skull].

Craniofacial operation techniques offer new possibilities for plastic reconstruction of the viscero-cranium. For this reason, existing standard techniques, as they are applied to craniostenoses, are modified. These surgical techniques produce a better visibility and thereby lower surgical risk. The correction of bony defects serves as the basis for the reconstruction of the soft tissue. In many cases an additional bone taking can be avoided. Moreover, the aesthetic results are optimized.

Adult↗
PubMed1993

Poly(L-lactide): a long-term degradation study in vivo. I. Biological results.

Three poly(L-lactides) with different molecular weights were synthesized. Small blocks (3 x 3 x 2 mm) and rods (25 x 3 x 2 mm) were produced either by injection moulding (amorphous parts, Mvis 200,000 and 120,000, respectively) or machined out of a solid aspolymerized polylactide block (crystalline parts, Mvis 429,000) and implanted into the dorsal muscle of rats. After 1 to 116 wk the rats were killed and the implants were recovered. Histological preparation was carried out using the cutting-grinding technique. All three polylactides had incorporated well, forming a collagenous fibrous layer. Crystalline block polylactide remained stable in form and structure over the whole observation period. Amorphous injection-moulded specimens developed a rough surface within weeks, then deep resorptive lacunae after ca. 1 yr and became totally degraded (Mvis 120,000) or nearly totally degraded (Mvis 200,000) after 2 yr. This velocity of biodegradation seems to meet the requirements for an absorbable material for osteosynthesis. Long-term implantation into rodents brings the problem of foreign-body tumorigenesis independent of the chemical nature of implants (the Oppenheimer effect). Observations in this study and in the literature are discussed.

Animals↗
PubMed1993

Poly(L-lactide): a long-term degradation study in vivo. Part III. Analytical characterization.

Three poly(L-lactides) with different molecular weights were synthesized as solid blocks from the melt. Two batches were ground and small specimens were produced by injection moulding. The third block was processed by machining, yielding crystalline parts. All were implanted as small rods into the dorsal muscle of rats. The implants were recovered, weight loss was determined, and the samples analysed. The samples degraded very fast, reaching the same molecular weight level after 20 wk, then degraded simultaneously. Analysis showed differences depending on the solid state of the polymer. The differences in the degradation behaviour of the amorphous and crystalline samples can be explained by assuming a simple hydrolysis as the main degradation mechanism, affecting the whole polymer, if in an amorphous state, but only the amorphous domains in a crystalline polymer.

Animals↗
PubMed1991

[Osteotomies for treating developmental disorders of the neurocranium and visceral cranium].

Craniofacial deformities are primarily caused by premature synostosis of cranial sutures. Depending on the involved sutures, typical deformities of the neuro- and visceral cranium are produced. They result in severe functional and aesthetic disturbances. Several osteotomies, which do not only make an aesthetic improvement possible but a correction of severe malfunction, are available for therapy. Preoperative planning and postoperative treatment require the combination of orthodontics and maxillofacial surgery.

Craniosynostoses↗