Biomedical subjects

J P Aguer

Publications and source records attributed to J P Aguer.

6 recordsLinked to original sources

PubMed2004

Key role of the low molecular size fraction of soil humic acids for fluorescence and photoinductive activity.

The IHSS soil humic acid (HA) standard and two HAs from soils of very different origin (Chernozem and Ranker) were fractionated by tandem size-exclusion chromatography-polyacrylamide gel electrophoresis. From each HA, three fractions with different molecular sizes (MSs) and electrophoretic mobilities were obtained and investigated for their fluorescence properties and abilityto photoinduce the transformation of 2,4,6-trimethylphenol and herbicide fenuron. Regardless of the source of the HA, the two high MS fractions were found to be very weakly fluorescent. They photoinduced the degradations of fenuron and 2,4,6-trimethylphenol less efficiently than the bulk HA (10-50-fold and 1.4-5.3-fold, respectively). In contrast, the low MS fraction was proved to be fluorescent and to photoinduce the transformation of probes as least as efficiently than the bulk HA. These results show that (i) most of fluorophores and a great part of photoinductive chromophores are located in the low MS fractions of soil HAs and (ii) this distribution of photochemically active constituents may be characteristic across broad soil types.

Chromatography, Gel↗

PubMed2002

Photoinductive efficiency of soil extracted humic and fulvic acids.

Humic and fulvic acids extracted from soils of different genesis were investigated for their ability to photoinduce the transformation of fenuron (2 x 10(-4) mol(-1)) at 365 nm. The ratio of the initial rate of fenuron consumption over the rate of light absorption by humic substances was found to be higher for fulvic acids (range 2.0 x 10(-3) to 9.0 x 10(-5)) than for humic acids (range 1.7 x 10(-4) to - 3.6 x 10(-5)). Within the FAs population, this ratio decreased as the specific absorption coefficient at 365 nm increased. It seems therefore that most of 365-nm absorbing components have no photoinductive activity and even reduce that of photoinductive chromophores.

Benzopyrans↗

PubMed2001

Organoclays for controlled release of the herbicide fenuron.

Organoclays were assayed as matrices in which to associate herbicides, with the aim of decreasing product losses that could give rise to water contamination from agricultural activities. Fenuron was selected as model of a very mobile and highly water-soluble herbicide. Two different organoclays of high (A-HDT) and low (H-C18) reversible fenuron sorption were selected. Herbicide-organoclay complexes were prepared from the two organoclays and with two different fenuron contents (20 and 40 g AI kg-1) and two different mixing times, so as to form a series of weak and strong complexes. The release of fenuron from those complexes into water and water/soil suspensions gave values of T50 (time to release 50% of the fenuron content) ranging from 0.3 min to 2400 h. The total fenuron released in these closed systems ranged from 48 to 80% of the fenuron in the complex. The organoclay type (high or low sorptivity) had the greatest influence on fenuron release, followed by the strong or weak complex, suggesting that herbicide-organoclay interactions are the main factors controlling release. Soil column leaching experiments showed fenuron-organoclay complexes to be effective in reducing the peak herbicide concentration in the leachate to a half (6 microns) or a quarter (3 microns) of that obtained from the free technical compound (12 microns). Herbicide lost through leaching was reduced from 78% for the free technical fenuron to 50-30%, depending on the organoclay used as carrier and the strength of the complex. Bioassay with ryegrass showed that the weak fenuron/H-C18 complex (40 g AI kg-1) gave the same herbicidal activity as technical fenuron. The potential suitability of low-sorptive organoclays for conferring slow-release properties on the fenuron complex has been demonstrated.

Adsorption↗

PubMed2001

Photoinductive properties of soil humic acids and their fractions obtained by tandem size exclusion chromatography-polyacrylamide gel electrophoresis.

Humic acids (HAs) from three soils of different origin (Chernozem, Ferralsol and Ranker) have been fractionated by coupling size exclusion chromatography (SEC) and polyacrylamide gel electrophoresis (PAGE) on three fractions (fractions A, B, C + D) with different molecular sizes (MSs) and exactly defined electrophoretic mobility (EM). Fractions identically marked had similar EM and MS, independently of HA sources. The photoinductive properties of the whole HAs and their fractions were compared by studying the photoinduced transformation of fenuron at 365 nm. High MS fractions A and B appeared to exhibit poor photoinductive activities compared to the whole HAs, whereas low MS fraction C + D in Chernozem and Ranker were more efficient than the whole HAs. A fourth intermediary fraction containing a mixture of fractions B and C + D with small amount of D was shown to photoinduce poorly the transformation of fenuron. It was therefore concluded that the molecules capable of photoinducing the transformation of fenuron were mainly contained in fraction D. Fluorescence properties of Chernozem HA and its fractions have been tested. Fraction C + D exhibited a very similar fluorescence emission spectrum in comparison with the whole HA and in contrast, the fractions A and B emitted very weakly.

Chromatography↗

PubMed2000

Fenuron sorption on homoionic natural and modified smectites.

The adsorption isotherms of fenuron (1,1-dimethyl-3-phenylurea) on three smectites (SWy and SAz montmorillonites and SH hectorite) differing in their layer charge (SH<SWy<SAz) and saturated with several inorganic and organic cations were determined. The isotherms and sorption parameters from Freundlich equation indicate low adsorptivity on inorganic clays, but medium sorption in organoclays (OCls). Fenuron adsorption on homoionic smectites increases with decreasing layer charge and hydratation power of the inorganic exchangeable cation (except Fe3+), indicating that fenuron adsorbs as neutral molecule on uncharged siloxane surface by hydrophobic bonding, with some contribution of polar bond (fenuron C=O group and water associated to exchangeable cation). In the case of Fe3+-saturated smectite fenuron protonation, provided by the interlayer acidic environment, promotes further sorption of fenuron as cationic form. The sorption on organoclays is enhanced via hydrophobic interaction with organocations, which is favoured for high layer charge and basal spacing and organocation saturation close to CEC. Quaternary alkylamonium is more efficient in high layer charge smectite, whereas primary alkylammonium is more efficient in medium charge smectite. The low values of the maximum sorption obtained with homoionic inorganic and organic smectites (100 and 5000 micromol/Kg) represent one fenuron molecule for each 2000-200 exchange sites and indicate that fenuron sorption is mainly associated to the outer exchange sites. This low adsorptivity of fenuron, as consequence of its high water affinity (high water solubility) would suggest high mobility of fenuron in natural soil and water systems.

Absorption↗

PubMed2000

Sorption and photolysis studies in soil and sediment of the herbicide napropamide.

The influence of soil and sediment composition on sorption and photodegradation of the herbicide napropamide [N,N-diethyl-2-(1-naphthyloxy)propionamide] was investigated. Five soils and one sediment were selected for this study and the clay fractions were obtained by sedimentation. Sorption-desorption was studied by batch equilibration technique and photolysis in a photoreactor emitting within 300-450 nm wavelength with a maximum at 365 nm. Sorption increased with clay content and was not related to organic matter content. High irreversibility of sorption was related to the greater montmorillonite content. The presence of soil or sediment reduced photolysis rate due to screen effect and this process did not depend on solid composition but on particle size distribution.

Adsorption↗