Biomedical subjects

Jérôme Vial

Publications and source records attributed to Jérôme Vial.

4 recordsLinked to original sources

PubMed2006

Evaluation of reversed phase columns designed for polar compounds and porous graphitic carbon in "trapping" and separating neurotransmitters.

Quantification of neurotransmitters as biologically active analytes in neurological samples is of high interest for studying their effect on multiple targets. This work is part of a strategy involving two-dimensional liquid chromatography (2D LC) system with mass spectrometry (MS) detection. The concept of the on-line LC system is the coupling of reversed phase liquid chromatography (RPLC, the second separation dimension) to ion-exchange chromatography (IEC, the first dimension). Our objective in this study is to find the appropriate second dimension column, ensuring that samples of neurotransmitters are refocused and separated on it. Silica-based columns designed specifically to retain polar compounds were tested in LC conditions and compared with results obtained with a porous graphitic carbon (PGC, Hypercarb) column. These polar embedded, polar endcapped, and high-density alkyl chain columns successfully separated analytes in question using mobile phase systems with high percentage of water, or even pure water. Only Hypercarb column provided efficient retention of the most polar neurotransmitters and could be used for trapping and preconcentrating the compounds without rapid breakthrough.

Chromatography, Ion Exchange↗

PubMed2006

Feasibility study of a reference material for water chemistry: long term stability of triazine and phenylurea residues stored in vials or on polymeric sorbents.

Matrix Reference Materials (MRM) are essential tools for the validation of analytical protocols. Nowadays, there are no such materials for the determination of herbicides in water. So, a feasibility study of a MRM for the analysis of triazines and phenylureas in water was carried out. Different kinds of candidates MRM were prepared: solutions of pesticides diluted in acetonitrile and stored in sealed vials or stored at the dry state after the evaporation of the solvent to dryness, pesticides stored on two different types of polymeric solid-phase extraction (SPE) sorbents after the percolation of drinking or river waters spiked with pesticides. The stability of these candidates MRM stored at various temperatures (room temperature, 0.5 degrees C or -18 degrees C) was studied over a period of approximately 1 year. Two different levels of concentration were studied for each kind of material. During the storage, some samples of each different MRM candidate were monthly analyzed by liquid chromatography. Results showed that, among the candidate materials, some of them presented satisfactory enough stability to consider a further certification. They were either pesticides in solution in sealed vials or pesticides stored on cartridges after the percolation of spiked water samples. However, it was shown that these different MRM candidates had to be stored at a temperature lower than 0.5 degrees C.

Chromatography, High Pressure Liquid↗

PubMed2005

A study of interlaboratory influence on column evaluation.

A liquid chromatography method for the characterization of base deactivated columns was investigated in a collaborative study involving six laboratories. This work was carried out on two chromatographic supports (Xterra RP 18 and Symmetry Shield). Different cooling systems, namely water bath and air oven, were tested and it was shown that column thermoregulation did not significantly influence chromatographic data. In order to control the mobile phase composition, the latter was prepared by weight rather than volume. Thanks to the injection of a set of selected neutral compounds, extra-column effects were evaluated in each of the participating laboratories. The results showed that chromatographic supports tested in different laboratories and following the same test protocol could be effectively compared.

Chromatography, High Pressure Liquid↗

PubMed2003

Use of solid-phase microextraction coupled with gas chromatography for the determination of residual solvents in pharmaceutical products.

The aim of this work was to prove that solid-phase microextraction coupled with gas chromatography could be used for the determination and quantification of residual solvents in drugs. Four solvents were selected for the experiments: ethanol, cyclohexane, triethylamine and pyridine, together with a model powdered drug substance. Several kinds of fibers, together with the extraction mode, were evaluated to determine the most appropriate one for the simultaneous extraction of the four solvents. The most promising conditions were obtained with the Carboxen-polydimethylsiloxane fiber in the headspace of the aqueous solution that contained the dissolved powder. A concentrated phosphate buffer was added to the aqueous solution to set the pH at 9.6 in order to enable good extraction of triethylamine, and the optimum extraction time was experimentally determined. A multi-criteria optimization was also carried out by means of design of experiments to optimize remaining parameters: the extraction temperature was set at 40 degrees C, the ionic strength at 1.77 mol (l-1) and the volume of the aqueous solution at 7.2 ml. The method of standard additions was used for quantitative analysis. Its performance was evaluated and validated: the pooled RSD was around 15%, the limits of detection were all of the ppb level and the method was both accurate and linear.

Chromatography, Gas↗