Biomedical subjects

Jan Gimsa

Publications and source records attributed to Jan Gimsa.

8 recordsLinked to original sources

PubMed2006

A new exposure system for the in vitro detection of GHz field effects on neuronal networks.

The possible effects of high-frequency electromagnetic fields (EMF) on biological systems are a subject of public concern and scientific discussion. It is generally accepted that the absorption of part of the field energy may cause a temperature rise in biological tissue. Nevertheless, our setup aims to detect possible athermal effects on the electric activity of neuronal in vitro networks. Such networks were formed by primary neurons derived from the murine frontal cortex and cultivated on micro-sensor chips. The action potentials of the neurons were detected in real time by an integrated, electrically passive microelectrode array. For EMF exposure, the chips were introduced into a rectangular wave-guide that could be operated in the propagating or standing wave modes. The drive signals were either continuous waves (1.9-2.2 GHz) or a generic mobile phone signal (UMTS-standard) of up to approximately 8 W. An on-chip sensor allowed the temperature progression to be recorded. In addition, ISFETs and Clark-like electrodes were integrated for the on-chip detection of pH and O(2), respectively.

Animals↗

PubMed2006

On the temperature dependence of the dielectric membrane properties of human red blood cells.

Electrorotation (ER) spectra of human red blood cells (HRBCs) have been recorded in the frequency range from 10 kHz to 250 MHz in a 4-electrode microchip chamber. The cells were suspended at conductivities in the range from 0.02 to 3.00 S/m (corresponding to an ionic strength range from 1.6 to 343 mM) at temperatures between 10 degrees C and 35 degrees C. Generally, the characteristic frequencies as well as the rotation speeds of the first (membrane-dispersion) and second ER peaks increased with temperature. The rotation speed increase was largely correlated to the temperature dependence of the medium viscosity. Standard temperature dependencies were assumed for the conductivities and permittivities of cytoplasm, membrane, and external solution to explain the frequency shifts, starting from the cell parameters of Gimsa et al. [Gimsa et al., 1996, Biophys. J. 71: 495-506.]. The membrane capacitance was assumed to be temperature independent, based on the permittivity of alkyl-chains. Under these assumptions, the spectra could be well fitted only in a narrow temperature range around 20 degrees C. The temperature dependence of the first characteristic frequency was much stronger than predicted. In addition, around 15 degrees C, an anomalously high rotation speed was observed for the first peak at low external conductivities. Interestingly, this finding corresponds to the change in the chloride transport rate described by Brahm [Brahm, 1977, J. Gen. Physiol. 70: 283-306.].

Electrodes↗

PubMed2006

The influence of the molecular structure of lipid membranes on the electric field distribution and energy absorption.

We consider the influence of the molecular structure of phospholipid membranes on their dielectric properties in the radio frequency range. Membranes have a stratified dielectric structure on the submolecular level, with the lipid chains forming a central hydrophobic layer enclosed by the polar headgroups (HGs) and bound water layers. In our numerical model, isotropic permittivities of 2.2 and 48.8 were assigned to the lipid chain and bound water layers, respectively. The HG region was assumed to possess an anisotropic static permittivity with 142.2 and 30.2 in the tangential and normal directions, respectively. The permittivities of the HG and bound water regions have been assumed to disperse at frequencies around 51 and 345 MHz to become 2.2 and 1.8, respectively, in both the normal and tangential directions. Electric field distribution and absorption were calculated for phospholipid vesicles with 75 nm radius as an example. Significant absorption has been obtained in the HG and bound water regions. Averaging the membrane absorption over the layers resulted in a decreased absorption below 1 GHz but a more than 10-fold increase above 1 GHz, compared to a model with a homogeneous membrane of averaged properties. We propose single particle dielectric spectroscopy by AC electrokinetics at low-bulk medium conductivities for an experimental verification of our model.

Absorption↗

PubMed2005

Matching geometry and stimulation parameters of electrodes for deep brain stimulation experiments--numerical considerations.

Deep brain stimulation, the electric stimulation of basal ganglia nuclei, is a treatment for movement disorders such as Parkinson's disease. The underlying mechanisms are studied in animals, e.g. rodents. Designs and materials of commercially available microelectrodes, as well as experimentally applied driving signals vary tremendously. We used finite integration modeling to compare the electric field and current density distributions induced by various electrodes. Current density or field strength "hot spots", which are located particularly at sites of high curvature and material interfaces coincided with corrosion and erosion at poles and insulation, respectively, as shown by scanning electron microscopy of stainless steel electrodes. Cell constants, i.e. geometry factors relating the electrode impedance to the specific medium conductivity, were calculated to determine the electrode voltage for a given stimulation current. Nevertheless, for electrodes of the same cell constant but of different geometry, current and field distributions may be very dissimilar. We found geometry-dependent limiting values of the stimulation current, above which electric tissue damage may occur. These values limit the reach of the stimulation signal for a given electrode geometry. Also, electrode geometries determine the shape of the stimulated tissue volume. This study provides tools for choosing the most appropriate geometry for targeting different-sized brain areas.

Animals↗

PubMed2005

Choosing electrodes for deep brain stimulation experiments--electrochemical considerations.

Deep brain stimulation (DBS) is a therapy of movement disorders including Parkinson's disease (PD). Commercially available electrodes for animal models of Parkinson's disease vary in geometry and material. We characterized such electrodes and found a drift in their properties within minutes and up to about 60 h after immersion in cell culture medium, both with and without a stimulation signal. Electrode properties could largely be restored by proteolytic treatment for platinum/iridium electrodes but not for stainless steel ones. Short-term drift and irreversible aging could be followed by impedance measurements. Aging was accompanied by metal corrosion and erosion of the plastic insulation. For both materials, the degradation rates depended on the current density at the electrode surfaces. Fourier analysis of the DBS pulse (60 micros, repetition rate 130 Hz) revealed harmonic frequencies spanning a band of more than three decades, with significant harmonics up to the MHz range. The band is located in a window imposed by electrode processes and capacitive cell membrane bridging at the low and high frequency ends, respectively. Even though electrode processes are reduced at higher frequencies they only vanish above 1 MHz and cannot be avoided. Therefore, the use of inert electrode materials is of special importance. The neurotoxicity of iron makes avoiding stainless steel electrodes imperative. Future developments need to avoid the use of corrosive materials and current density hot spots at the electrode surface, and to reduce low frequency components in the DBS pulses in order to diminish electrode processes.

Brain↗

PubMed2005

Excluded volume driven counterion condensation inside nanotubes in a concave electrical double layer model.

The physical properties of organic nanotubes attract increasing attention due to their potential benefit in technology, biology and medicine. We study the effect of ion size on the electrical properties of cylindrical nanotubes filled with electrolyte solution within a modified Poisson-Boltzmann (PB) approach. For comparison purposes, small hollow nanospheres filled with electrolyte solution are considered. The finite size of the particles in the inner electrolyte solution is described by the excluded volume effect within a lattice statistics approach. We found that an increased ion size reduces the number of counterions near the charged inner surface of the nanotube, leading to an enlarged electrostatic surface potential. The concentration of counterions close to the inner surface saturates for higher surface charge densities and larger ions. In the case of saturation, the closest counterion packing is achieved, all lattice sites near the surface are occupied and an actual counterion condensation is observed. By contrast, the counterion concentration at the axis of the nanotube steadily increases with increasing surface charge density. This growth is more pronounced for smaller nanotube radii and larger ions. At larger nanotube radii for small ion size counterion condensation may also be observed according to the Tsao criterion, i.e. the counterion concentration at the centre is independent of the number of counterions in the system. With decreasing radius the Tsao condensation effect is shifted towards physiologically unrealistic surface charge densities.

Electricity↗

PubMed2002

Cellular absorption of electric field energy: influence of molecular properties of the cytoplasm.

Molecular dispersions may significantly alter the frequency dependence of structural polarizations. Consequently, the molecular properties cannot be neglected when the energy absorption is calculated with a subcellular resolution. Our example presents calculations that explain the absorption in single human red blood cells. The molecular properties of the cytoplasm have been derived from literature data on the impedance of Hb suspensions. The resulting cell properties were then compared to own data obtained by single cell dielectric spectroscopy.

Cytoplasm↗

PubMed2002

Estimating the subcellular absorption of electric field energy: equations for an ellipsoidal single shell model.

An oriented single shell model is used to describe the absorption of electric field energy for a cell of the general ellipsoidal shape exposed to a homogeneous AC-field. A finite element approach allowed us to derive characteristic equations describing the dependence of the field distribution on the cell geometry, the electric properties of the structural media, membrane and bulk solutions, as well as on the field frequency with a subcellular resolution. Finally, equations were derived for the absorption at certain sites of the model. The model allows for the introduction of frequency-dependent cellular media properties. Experimentally, the new cell parameters can be verified by dielectric single-cell spectroscopy.

Adsorption↗