Biomedical subjects

Jan Thoen

Publications and source records attributed to Jan Thoen.

7 recordsLinked to original sources

PubMed2006

Task-specific ionic liquid for solubilizing metal oxides.

Protonated betaine bis(trifluoromethylsulfonyl)imide is an ionic liquid with the ability to dissolve large quantities of metal oxides. This metal-solubilizing power is selective. Soluble are oxides of the trivalent rare earths, uranium(VI) oxide, zinc(II) oxide, cadmium(II) oxide, mercury(II) oxide, nickel(II) oxide, copper(II) oxide, palladium(II) oxide, lead(II) oxide, manganese(II) oxide, and silver(I) oxide. Insoluble or very poorly soluble are iron(III), manganese(IV), and cobalt oxides, as well as aluminum oxide and silicon dioxide. The metals can be stripped from the ionic liquid by treatment of the ionic liquid with an acidic aqueous solution. After transfer of the metal ions to the aqueous phase, the ionic liquid can be recycled for reuse. Betainium bis(trifluoromethylsulfonyl)imide forms one phase with water at high temperatures, whereas phase separation occurs below 55.5 degrees C (temperature switch behavior). The mixtures of the ionic liquid with water also show a pH-dependent phase behavior: two phases occur at low pH, whereas one phase is present under neutral or alkaline conditions. The structures, the energetics, and the charge distribution of the betaine cation and the bis(trifluoromethylsulfonyl)imide anion, as well as the cation-anion pairs, were studied by density functional theory calculations.

Conservation of Natural Resources↗

PubMed2006

Effect of nonmesogenic impurities on the order of the nematic to smectic-A phase transition in liquid crystals.

By means of adiabatic scanning calorimetry, we have studied the effect of the nonmesogenic solutes cyclohexane (CH) and biphenyl (BP) on the nematic-smectic-A phase transition in the liquid crystal octylcyanobiphenyl (8CB). For all concentrations of BP studied, the transition remains second-order. For 8CB+CH, however, crossover from second-order to first-order is observed at a tricritical point of the mole fraction x of CH around 0.0460. The difference between the two systems and the crossover is explained in terms of a mean-field free energy density expression including coupling terms of x with the nematic and smectic-A order parameters.

Biphenyl Compounds↗

PubMed2002

Phase transitions in the starch-water system studied by adiabatic scanning calorimetry.

We report high-precision measurements of phase transitions in the starch-water system by using for the first time adiabatic scanning calorimetry (ASC). Potato starch and nixtamalized corn flours were studied by this technique as a function of the moisture content. We calculated the percentage of gelatinized starch granules, as a function of the temperature, for both flours. For bi-phasic behavior in potato starch, at intermediate water contents, we propose an explanation based on previous hypotheses and on the experimental behavior as deduced from ASC measurements. ASC results suggest, in the case of nixtamalized corn flour, that uniform moisture is present in corn starch granules for all the considered moistures. A shift to higher temperatures of the peak temperature is observed when comparing the c(p)(T) curves with the classical DSC endotherms as measured for this flour. For both flours we estimated from the ASC results the melting temperatures of the starch granules, at zero moisture content, by using Flory's equation.

Calorimetry, Differential Scanning↗

PubMed2002

Two-dimensional ultrasonic strain rate measurement of the human heart in vivo.

A study is presented in which the feasibility of two-dimensional strain rate estimation of the human heart in vivo has been demonstrated. To do this, ultrasonic B-mode data were captured at a high temporal resolution of 3.8 ms and processed off-line. The motion of the RF signal patterns within the two-dimensional sector image was tracked and used as the basis for strain rate estimation. Both axial and lateral motion and strain rate estimates showed a good agreement with the results obtained by more established, one-dimensional techniques.

Adult↗

PubMed2002

Echocardiographic strain and strain-rate imaging: a new tool to study regional myocardial function.

Ultrasonic imaging is the noninvasive clinical imaging modality of choice for diagnosing heart disease. At present, two-dimensional ultrasonic grayscale images provide a relatively cheap, fast, bedside method to study the morphology of the heart. Several methods have been proposed to assess myocardial function. These have been based on either grayscale or motion (velocity) information measured in real-time. However, the quantitative assessment of regional myocardial function remains an important goal in clinical cardiology. To do this, ultrasonic strain and strain-rate imaging have been introduced. In the clinical setting, these techniques currently only allow one component of the true three-dimensional deformation to be measured. Clinical, multidimensional strain (rate) information can currently thus only be obtained by combining data acquired using different transducer positions. Nevertheless, given the appropriate postprocessing, the clinical value of these techniques has already been shown. Moreover, multidimensional strain and strain-rate estimation of the heart in vivo by means of a single ultrasound acquisition has been shown to be feasible. In this paper, the new techniques of ultrasonic strain rate and strain imaging of the heart are reviewed in terms of definitions, data acquisition, strain-rate estimation, postprocessing, and parameter extraction. Their clinical validation and relevance will be discussed using clinical examples on relevant cardiac pathology. Based on these examples, suggestions are made for future developments of these techniques.

Echocardiography↗

PubMed2002

Experimental investigation of leaky lamb modes by an optically induced grating.

By removing the symmetry of a free plate configuration, fluid loading significantly modifies the nature of acoustic waves travelling along a plate, and it even gives existence to new acoustic modes. We present theoretical predictions for the existence, dispersive behavior, and spatial distribution of leaky Lamb waves in a fluid-loaded film. Although Lamb modes are often investigated by studying the radiated fluid waves resulting from their leakage, here their properties are assessed by detecting the wave displacements directly using laser beam deflection. By using crossed laser beam excitation, the detection and analysis of the different modes is done at a fixed wavelength, allowing one to verify the existence, the velocity, and the damping of each predicted mode in a simple and unambiguous way. Our theoretical predictions for the nature of the modes in a water-loaded Plexiglas film, including parts of looping modes, are experimentally confirmed.

Journal Article↗

PubMed2002

Nonlinearity of acoustic waves at solid-liquid interfaces.

The small-amplitude and finite-amplitude propagation characteristics of laser line source excited and laser detected Scholte waves are investigated. Acoustic waves with Mach numbers up to 0.054 are observed at the interface between water and glass. In our case of a hard solid-liquid interface, the Scholte wave propagates very much like a bulk wave, for which the simple-wave equation holds. The experimental results are well fitted with this model, extended with an attenuation term. An anomalously large (compared with low amplitude viscous effects) attenuation reveals possible leakage of energy from the Scholte wave to bulk waves, through a mechanism of nonlinear mixing between the different wave modes and viscosity induced turbulence.

Acoustics↗