Biomedical subjects

Jean Michel Bouler

Publications and source records attributed to Jean Michel Bouler.

3 recordsLinked to original sources

PubMed2007

Calcium-deficient apatite synthesized by ammonia hydrolysis of dicalcium phosphate dihydrate: influence of temperature, time, and pressure.

In this work, calcium-deficient apatites (CDA) were synthesized by ammonia hydrolysis reaction of dicalcium phosphate dihydrate (DCPD; CaHPO4 x 2 H2O) to obtain biphasic calcium phosphates (BCP) without any extraionic substitution. The influence of three parameters was studied: temperature of the reaction (70 and 100 degrees C), time of the reaction (4 and 18 h), and the pressure (open and closed system). Experiments were made according to a factorial design method (FDM) allowing optimization of the number of samples as well as statistical analysis of results. Moreover, the influence of temperature (until 200 degrees C) was investigated. The crystal size of CDA was determined according to the Scherrer's formula and from Rietveld refinements taking the CDA anisotropy into account. The last method seems to be a reliable method to determine crystallite sizes of CDA, since crystallite sizes of CDA along <00l> and directions were accessible. The results describe the hydroxyapatite % (HA%) in BCP by a first-order polynomial equation in the experimental area studied and the HA content was found to increase by raising time and temperature of the reaction. Moreover, the type of reaction system (open/closed vessel) appeared to have little influence on HA%.

Ammonia↗

PubMed2006

Physico-chemical-mechanical and in vitro biological properties of calcium phosphate cements with doped amorphous calcium phosphates.

Calcium phosphate cements (CPCs) are successfully used as bone substitutes in dentistry and orthopaedic applications. This study investigated the physico-chemical-mechanical properties of and in vitro biological properties (cell response) of CPCs prepared with amorphous calcium carbonate phosphate (ACCP) doped with magnesium (ACCP-Mg), zinc (ACCp-Zn) or fluoride (ACCP-F) ions. The experimental CPC consisted of alpha-TCP, doped ACCP, and MPCM powders as matrix and biphasic calcium phosphate (BCP) granules. X-ray diffraction analysis showed that the matrix converted to apatite with poor crystallinity (reflecting small crystal size) after setting for 24 h, while BCP remained apparently unchanged. Cements with ACCP-F (F-CPC) had shorter setting times and greater compressive strength compared to cements with ACCP-Mg (Mg-CPC) or ACCP-Zn (Zn-CPC). Scanning electron microscopy (SEM) showed that crystals set on Mg-CPC and Zn-CPC were smaller compared to those on F-CPC. The total porosity of Mg-CPC was greater compared to Zn-CPC or F-CPC. Osteoblast-like cells, MC3T3-E1, remained viable and maintained their ability to express alkaline phosphatase in contact with the CPCs with doped ACCPs.

3T3 Cells↗

PubMed2006

Quantitative and reliable in vitro method combining scanning electron microscopy and image analysis for the screening of osteotropic modulators.

The increased generation and up-regulated activity of bone resorbing cells (osteoclasts) play a part in the impairment of bone remodeling in many bone diseases. Numerous drugs (bisphosphonates, calcitonin, selective estrogen receptor modulators) have been proposed to inhibit this increased osteoclastic activity. In this report, we describe a pit resorption assay quantified by scanning electron microscopy coupled with image analysis. Total rabbit bone cells with large numbers of osteoclasts were cultured on dentin slices. The whole surface of the dentin slice was scanned and both the number of resorption pits and the total resorbed surface area were measured. Resorption pits appeared at 48 h and increased gradually up to 96 h. Despite the observation of a strong correlation between the total resorption area and the number of pits, we suggest that area measurement is the most relevant marker for osteoclastic activity. Osteotropic factors stimulating or inhibiting osteoclastic activity were used to test the variations in resorption activity as measured with our method. This reproducible and sensitive quantitative method is a valuable tool for screening for osteoclastic inhibitors and, more generally, for investigating bone modulators.

Animals↗