PubMed Health⌕ Search

Biomedical subjects

Jeffrey L Collett

Publications and source records attributed to Jeffrey L Collett.

7 recordsLinked to original sources

Analysis of anions in ambient aerosols by microchip capillary electrophoresis.

We describe a microchip capillary electrophoresis method for the analysis of nitrate and sulfate in ambient aerosols. Investigating the chemical composition of ambient aerosol particles is essential for understanding their sources and effects. Significant progress has been made towards developing mass spectrometry-based instrumentation for rapid qualitative analysis of aerosols. Alternative methods for rapid quantification of selected high abundance compounds are needed to augment the capacity for widespread routine analysis. Such methods could provide much higher temporal and spatial resolution than can be achieved currently. Inorganic anions comprise a large percentage of particulate mass, with nitrate and sulfate among the most abundant species. While ion chromatography has proven very useful for analyzing extracts of time-integrated ambient aerosol samples collected on filters and for semi-continuous, on-line particle composition measurements, there is a growing need for development of new compact, inexpensive approaches to routine on-line aerosol ion analysis for deployment in spatially dense, atmospheric measurement networks. Microchip capillary electrophoresis provides the necessary speed and portability to address this need. In this report, on-column contact conductivity detection is used with hydrodynamic injection to create a simple microchip instrument for analysis of nitrate and sulfate. On-column contact conductivity detection was achieved using a Pd decoupler placed upstream from the working electrodes. Microchips containing two Au or Pd working electrodes showed a good linear range (5-500 microM) and low limits-of-detection for sulfate and nitrate, with Au providing the lowest detection limits (1 microM) for both ions. The completed microchip system was used to analyze ambient aerosol filter samples. Nitrate and sulfate concentrations measured by the microchip matched the concentrations measured by ion chromatography.

Journal Article↗

Particle size distributions of organic aerosol constituents during the 2002 Yosemite Aerosol Characterization Study.

The Yosemite Aerosol Characterization Study (YACS) was conducted in the summer of 2002 to investigate sources of regional haze in Yosemite National Park. Organic carbon and molecular source marker species size distributions were investigated during hazy and clear periods. More than 75% of the organic carbon mass was associated with submicron aerosol particles. Most molecular marker species for wood smoke, an important source of particulate matter during the study, were contained in submicron particles, although on some fire influenced days, levoglucosan shifted toward larger sizes. Various wood smoke marker species exhibited slightly different size distributions in the samples, suggesting different, size dependent emission or atmospheric processing rates of these species. Secondary biogenic compounds including pinic and pinonic acids were associated with smaller particles. Pinonaldehyde, however, exhibited a broader distribution, likely due to its higher volatility. Dicarboxylic acids were associated mainly with submicron particles. Hopanes, molecular markers for vehicle emissions, were mostly contained in smaller particles but exhibited some tailing into larger size classes.

Acids↗

Wood smoke contribution to winter aerosol in Fresno, CA.

In an effort to better quantify wintertime particulate matter (PM) and the contribution of wood smoke to air pollution events in Fresno, CA, a field campaign was conducted in winter 2003-2004. Coarse and fine daily PM samples were collected at five locations in Fresno, including residential, urban, and industrial areas. Measurements of collected samples included gravimetric mass determination, organic and elemental carbon analysis, and trace organic compound analysis by gas chromatograph mass spectrometry (GC/MS). The wood smoke tracer levoglucosan was also measured in aqueous aerosol extracts using high-performance anion exchange chromatography coupled with pulsed amperometric detection. Sample preparation and analysis by this technique is much simpler and less expensive than derivatized levoglucosan analysis by GC/MS, permitting analysis of daily PM samples from all five of the measurement locations. Analyses revealed low spatial variability and similar temporal patterns of PM2.5 mass, organic carbon (OC), and levoglucosan. Daily mass concentrations appear to have been strongly influenced by meteorological conditions, including precipitation, wind, and fog events. Fine PM (PM2.5) concentrations are uncommonly low during the study period, reflecting frequent precipitation events. During the first portion of the study, levoglucosan had a strong relationship to the concentrations of PM2.5 and OC. In the later portion of the study, there was a significant reduction in levoglucosan relative to PM2.5 and OC. This may indicate a change in particle removal processes, perhaps because of fog events, which were more common in the latter period. Combined, the emissions from wood smoke, meat cooking, and motor vehicles appear to contribute approximately 65-80% to measured OC, with wood smoke, on average, accounting for approximately 41% of OC and approximately 18% of PM2.5 mass. Two residential sites exhibit somewhat higher contributions of wood smoke to OC than other locations.

Aerosols↗

Determination of levoglucosan from smoke samples using microchip capillary electrophoresis with pulsed amperometric detection.

Separation and detection of native anhydrous carbohydrates derived from the combustion of biomass using an electrophoretic microchip with pulsed amperometric detection (PAD) is described. Levoglucosan represents the largest single component of the water extractable organics in smoke particles and can be used to trace forest fires or discriminate urban air pollution sources. Detection of levoglucosan and other sugar anhydrides in both source and ambient aerosol samples is typically performed by gas chromatographic (GC) separation with mass spectrometric (MS) detection. This method is cost, time, and labor intensive, typically involving a multistep solvent extraction, chemical derivatization, and finally analysis by GC/MS. However, it provides a rich wealth of chemical information as the result of the combination of a separation method and MS and exhibits good sensitivity. In contrast, microchip capillary electrophoresis offers the possibility of performing simpler, less expensive, and faster analysis. In addition, integrated devices can be fabricated and incorporated with an aerosol collection system to perform semicontinuous, onsite analysis. In the present report, the effect of the separation potential, buffer pH and composition, injection time, and pulsed amperometric detection parameters were studied in an effort to optimize both the separation and detection of anhydrous sugars. Using the optimized conditions, the analysis can be performed in less than a minute, with detection limits ranging from 22 fmol (16.7 microM) for levoglucosan to 336 fmol (258.7 microM) for galactosan. To demonstrate the capabilities of the device, a comparison was made between GC/MS and microchip electrophoresis using an aerosol source sample generated in a wood-burning chamber. A second example utilizing an ambient aerosol sample illustrates a matrix interference necessitating additional method development for application to samples not dominated by wood smoke.

Aerosols↗

Particulate nitrate measurement using nylon filters.

Nylon filters are a popular medium to collect atmospheric fine particles in different aerosol monitoring networks, including those operated by the U.S. Environmental Protection Agency and the Interagency Monitoring of Protected Visual Environments (IMPROVE) program. Extraction of the filters by deionized water or by a basic aqueous solution (typically a mixture of sodium carbonate and sodium bicarbonate) is often performed to permit measurement of the inorganic ion content of the collected particles. Whereas previous studies have demonstrated the importance of using a basic solution to efficiently extract gaseous nitric acid collected using nylon filters, there has been a recent movement to the use of deionized water for extraction of particles collected on nylon filters to eliminate interference from sodium ion (Na+) during ion chromatographic analysis of inorganic aerosol cations. Results are reported here from a study designed to investigate the efficiency of deionized water extraction of aerosol nitrate (NO3-) and sulfate from nylon filters. Data were obtained through the conduct of five field experiments at selected IMPROVE sites. Results indicate that the nylon filters provide superior retention of collected fine particle NO3-, relative to Teflon filters, and that deionized water extraction (with ultrasonication) of collected NO3- and sulfate is as efficient, for the situations studied, as extraction using a basic solution of 1.7 mM sodium bicarbonate and 1.8 mM sodium carbonate.

Aerosols↗

Aerosol ion characteristics during the Big Bend Regional Aerosol and Visibility Observational study.

The ionic compositions of particulate matter with aerodynamic diameter < or = 2.5 microm (PM2.5) and size-resolved aerosol particles were measured in Big Bend National Park, Texas, during the 1999 Big Bend Regional Aerosol and Visibility Observational study. The ionic composition of PM2.5 aerosol was dominated by sulfate (SO4(2-)) and ammonium (NH4+). Daily average SO4(2-) and NH4+ concentrations were strongly correlated (R2 = 0.94). The molar ratio of NH4+ to SO4(2-) averaged 1.54, consistent with concurrent measurements of aerosol acidity. The aerosol was observed to be comprised of a submicron fine mode consisting primarily of ammoniated SO4(2-) and a coarse particle mode containing nitrate (NO3-). The NO3- appears to be primarily associated with sea salt particles where chloride has been replaced by NO3-, although formation of calcium nitrate (Ca(NO3)2) is important, too, on several days. Size-resolved aerosol composition results reveal that a size cut in particulate matter with aerodynamic diameter < or = 1 microm would have provided a much better separation of fine and coarse aerosol modes than the standard PM2.5 size cut utilized for the study. Although considerable nitric acid exists in the gas phase at Big Bend, the aerosol is sufficiently acidic and temperatures sufficiently high that even significant future reductions in PM2.5 SO4(2-) are unlikely to be offset by formation of particulate ammonium nitrate in summer or fall.

Aerosols↗

Organic matter in central California radiation fogs.

Organic matter was studied in radiation fogs in the San Joaquin Valley of California during the California Regional Particulate Air Quality Study (CRPAQS). Total organic carbon (TOC) concentrations ranged from 2 to 40 ppm of C. While most organic carbon was found in solution as dissolved organic carbon (DOC), 23% on average was not dissolved inside the fog drops. We observe a clear variation of organic matter concentration with droplet size. TOC concentrations in small fog drops (<17 microm) were a factor of 3, on average, higher than TOC concentrations in larger drops. As much as half of the dissolved organic matter was determined to have a molecular weight higher than 500 Da. Deposition fluxes of organic matter in fog drops were high (0.5-4.3 microg of C m(-2) min(-1)), indicating the importance of fog processing as a vector for removal of organic matter from the atmosphere. Deposition velocities of organic matter, however, were usually found to be lower than deposition velocities for fogwater, consistent with the enrichment of the organic matter in smaller fog drops with lower terminal settling velocities.

Air Movements↗