Biomedical subjects

Jens Rieger

Publications and source records attributed to Jens Rieger.

6 recordsLinked to original sources

PubMed2006

Non-affine structural evolution of soft colloidal crystalline latex films under stretching as observed via synchrotron X-ray scattering.

A polymer dispersion consisting of soft latex spheres with a diameter of 135 nm was used to produce a crystalline film with face-centered cubic (fcc) packing of the spheres. Different from conventional small-molecule and hard-sphere colloidal crystals, the crystalline latex film in the present case is soft (i.e., easily deformable). The structural evolution of this soft colloidal latex film under stretching was investigated by in-situ synchrotron ultra-small-angle X-ray scattering. The film exhibits polycrystalline scattering behavior corresponding to fcc structure. Stretching results not only in a large deformation of the crystallographic structure but also in considerable nonaffine deformation at high draw ratios. The unexpected nonaffine deformation was attributed to slippage between rows of particles and crystalline grain boundaries. The crystalline structure remains intact even at high deformation, suggesting that directional anisotropic colloidal crystallites can be easily produced.

Journal Article↗

PubMed2005

Structural changes and chain radius of gyration in cold-drawn polyethylene after annealing: small- and wide-angle X-ray scattering and small-angle neutron scattering studies.

Samples made from linear polyethylene were drawn at room temperature and subsequently annealed at high temperatures below the melting point. The structural changes of the crystalline lamellae and lamellar superstructures as well as the single chain radius of gyration were studied by means of combined small- and wide-angle X-ray scattering and small-angle neutron scattering (SANS). After drawing, the polymeric chain segments in the crystalline phase are preferentially oriented along the drawing direction with a high degree of orientation whereas the lamellae in the samples are found to be slightly sheared exhibiting oblique surfaces as evidenced by X-ray scattering. SANS indicates that the chains are highly elongated along the drawing direction. Annealing the deformed samples at temperatures where the mechanical alpha-process of polyethylene is active leads to a thickening of both crystalline lamellae and amorphous layers. The chains in the crystalline phase retain their high degree of orientation after annealing while the lamellae are sheared to a larger extent. In addition, there is also lateral growth of the crystalline lamellae during high-temperature annealing. Despite the structural changes of the crystalline and amorphous regions, there is no evidence for global chain relaxation. The global anisotropic shape of the chains is preserved even after prolonged annealing at high temperatures. The results indicate that the mobility of polyethylene chains-as seen, e.g., by 13C NMR-is a local phenomenon. The results also yield new insight into mechanical properties of drawn PE, especially regarding stress relaxation and creep mechanisms.

Journal Article↗

PubMed2005

"Like-charge attraction" between anionic polyelectrolytes: molecular dynamics simulations.

"Like-charge attraction" is a phenomenon found in many biological systems containing DNA or proteins, as well as in polyelectrolyte systems of industrial importance. "Like-charge attraction" between polyanions is observed in the presence of mobile multivalent cations. At a certain limiting concentration of cations, the negatively charged macroions cease to repel each other and even an attractive force between the anions is found. With classical molecular dynamics simulations it is possible to elucidate the processes that govern the attractive behavior with atomistic resolution. As an industrially relevant example we study the interaction of negatively charged carboxylate groups of sodium polyacrylate molecules with divalent cationic Ca2+ counterions. Here we show that Ca2+ ions initially associate with single chains of polyacrylates and strongly influence sodium ion distribution; shielded polyanions approach each other and eventually "stick" together (precipitate), contrary to the assumption that precipitation is initially induced by intermolecular Ca2+ bridging.

Journal Article↗

PubMed2004

Complexation of polyacrylates by Ca2+ ions. Time-resolved studies using attenuated total reflectance Fourier transform infrared dialysis spectroscopy.

The attenuated total reflectance Fourier transform infrared dialysis technique is introduced for the time-resolved investigation of the binding processes of Ca2+ to polyacrylates dissolved in water. We observed transient formation of intermediates in water with various types of coordination of the carboxylate group to Ca2+ throughout the complexation steps. Time-resolved changes in the spectra were analyzed with principal component analysis, from which the spectral species were obtained as well as their formation kinetics. We propose a model for the mechanisms of Ca2+ coordination to polyacrylates. The polymer chain length plays an important role in Ca2+ binding.

Acrylates↗

PubMed2003

Role of the entangled amorphous network in tensile deformation of semicrystalline polymers.

Being composed of crystalline lamellae and entangled amorphous polymeric chains in between, semicrystalline polymers always show a complicated deformation behavior under tensile deformation. In recent years, the process of tensile deformation was found to exhibit several regimes: intralamellar slipping of crystalline blocks occurs at small deformation whereas a stress-induced crystalline block disaggregation-recrystallization process occurs at a strain larger than the yield strain. The strain at this transition point is related to the interplay between the amorphous entanglement density and the stability of crystal blocks. We report experimental evidence from true stress-strain experiments that support this argument. It is emphasized that tie molecules, which connect adjacent lamellae, are of lesser importance with respect to the deformational behavior.

Journal Article↗

PubMed2001

Organic Nanoparticles in the Aqueous Phase-Theory, Experiment, and Use.

Many active organic compounds and organic effect materials are poorly soluble in water, or even insoluble. Aqueous forms of application thus require special formulation techniques to utilize or optimize the physiological (pharmaceuticals, cosmetics, plant protection, nutrition) or technical (varnishes, printing inks, toners) action. The most interesting properties of nanodispersions of active organic compounds and effect materials include the impressive increase in solubility, the improvement in biological resorption, and the modification of optical, electrooptical, and other physical properties which are achievable only with particle sizes in the middle or lower nanometer range (50-500 nm). Hence in addition to economic and ecological constraints there are also technical demands which appear to urgently require the development of new processes for the production of organic nanoparticles as alternatives to the established mechanical milling processes. In this context attention is drawn to the recent increase in research activities which have as their objective the continuous, automatic preparation of nanodispersed systems by precipitation from molecular solution. In this review the current state of knowledge of the fundamentals of particle formation from homogeneous solution and the effect of solvent and polymer additives on the morphology and supramolecular structure of the nanoparticle will be discussed. The practical implementation of this new formulation technology will be explored in detail for the carotenoids, a class of compounds of both physiological and technical interest.

Journal Article↗