Biomedical subjects

Jessen Gurung

Publications and source records attributed to Jessen Gurung.

6 recordsLinked to original sources

PubMed2006

Facilitating coronary artery evaluation in MDCT using a 3D automatic vessel segmentation tool.

The purpose of this study was to investigate a 3D coronary artery segmentation algorithm using 16-row MDCT data sets. Fifty patients underwent cardiac CT (Sensation 16, Siemens) and coronary angiography. Automatic and manual detection of coronary artery stenosis was performed. A 3D coronary artery segmentation algorithm (Fraunhofer Institute for Computer Graphics, Darmstadt) was used for automatic evaluation. All significant stenoses (>50%) in vessels >1.5 mm in diameter were protocoled. Each detection tool was used by one reader who was blinded to the results of the other detection method and the results of coronary angiography. Sensitivity and specificity were determined for automatic and manual detection as well as was the time for both CT-based evaluation methods. The overall sensitivity and specificity of the automatic and manual approach were 93.1 vs. 95.83% and 86.1 vs. 81.9%. The time required for automatic evaluation was significantly shorter than with the manual approach, i.e., 246.04+/-43.17 s for the automatic approach and 526.88+/-45.71 s for the manual approach (P<0.0001). In 94% of the coronary artery branches, automatic detection required less time than the manual approach. Automatic coronary vessel evaluation is feasible. It reduces the time required for cardiac CT evaluation with similar sensitivity and specificity as well as facilitates the evaluation of MDCT coronary angiography in a standardized fashion.

Aged↗

PubMed2006

Navigation-based needle puncture of a cadaver using a hybrid tracking navigational system.

PURPOSE: The purpose of this study was to determine the puncture accuracy of a navigational system, Medarpa, in a soft tissue environment using augmented overlay imaging. MATERIALS AND METHODS: Medarpa is an optical electromagnetic tracking system, which allows tracking of instruments, the radiologist's head position, and the transparent display. The display superimposes a computed tomography scan of a cadaver chest on a human cadaver in real time. In group A, needle puncture was performed using the Medarpa system. Three targets located inside the cadaver chest were selected. In group B, the same targets were used to perform standard computed tomography-guided puncture using a single-slice technique. A total of 42 punctures were performed in each group. Postpuncture computed tomography scans were made to verify needle tip positions. RESULTS: Mean deviation from targets was 8.42 mm +/- 1.78 mm for group A and 8.90 mm +/- 1.71 mm for group B. No significant difference was found between group A and B in any target (P > 0.05). No significant difference was found between the targets of the same group (P > 0.05). Procedural time for 42 punctures was 160 minutes in group A versus 289 minutes in group B (P < 0.05). CONCLUSION: Needle puncture in a soft tissue environment using the navigational system Medarpa can be reliably performed and matches the accuracy achieved by a computed tomography-guided puncture technique.

Biopsy, Needle↗

PubMed2006

Combined MRI and MR spectroscopy of the prostate before radical prostatectomy.

OBJECTIVE: The purpose of this study was to evaluate a routine protocol for combined MR and spectroscopic imaging of the prostate for staging accuracy. SUBJECTS AND METHODS: Fifty patients with biopsy-proven prostate carcinoma were examined with our sequence protocol, which consisted of T2-weighted fast spin-echo sequences and a pelvic T1-weighted spin-echo sequence. For spectroscopy, we used a 3D chemical shift imaging (CSI) spin-echo sequence. Image interpretation was performed by two radiologists. The total number of tumor voxels and tumor voxels per slice were counted to estimate the tumor volume in every patient. The potential of MR spectroscopy to differentiate between T2 and T3 tumors, based on the estimated tumor volumes, was compared with the staging performance of MRI. RESULTS: The MR measurement time was 19.01 minutes, and the total procedure time averaged 35 minutes. Seventy-six percent of the spectroscopic examinations were successful. Statistically significant differences in the number of tumor voxels per slice and tumor volumes were found between T2 and T3 tumors. The descriptive parameters of MRI and MR spectroscopy did not differ significantly; sensitivity and specificity were 75% and 87%, respectively, for MRI and 88% and 70%, respectively, for MR spectroscopy. The combination of both methods resulted in only a slight improvement in staging performance and was not statistically significant. CONCLUSION: Combined MRI and MR spectroscopy of the prostate has no diagnostic advantage in staging performance over MRI alone. The mean tumor volumes, estimated by MR spectroscopy, differ statistically significantly between T2 and T3 tumors.

Aged↗

PubMed2005

Quantitative cartilage volume measurement using MRI: comparison of different evaluation techniques.

This study was aimed to investigate the accuracy and time saving of MRI Argus application in the assessment of cartilage volume in osteoarthritic knees. Twelve knees of patients suffering from osteoarthritis were scanned with a 1.5 T MRI using a 3D gradient echo sequence with selective water excitation. Cartilage volume of the tibial and patellar compartment was determined with a validated multiprocessing computer system (Octane Duo, Silicon Graphics, Mountain View, Calif., USA). The calculated cartilage volumes were compared to the results acquired by the Argus (Siemens Inc., Erlangen, Germany) application software using the MRI data sets. Compared to the multiprocessing computer system a time saving of at least 30 min for cartilage volume determination was achieved. The mean differences of Argus versus the multiprocessing computer system were 4.26+/-0.84 and 7.80+/-0.87% for the medial and lateral tibial plateau and 5.94+/-0.59% for the patella (no statistical significant difference; P>0.05). The applied Argus software can be used for fast and accurate determination of cartilage volume in the knee joint.

Aged↗

PubMed2005

Multislice CT of the pelvis: dose reduction with regard to image quality using 16-row CT.

To optimize examination protocols of 16-row multi-detector CT (MDCT) of pelvis for dose reduction with regard to image quality. MDCT of pelvis was performed on 12 cadaver specimens with stepwise reduction of tube current from 160 mA (113, 80, 56, 40, 28) to 20 mA at 120 kV. Scan parameters were 16 x 1.5 mm collimation. Reconstructions of axial and coronal images were used for evaluation of cortex, trabeculum, image quality, image noise, acetabulum and iliosacral (ISJ) joints. After data were blinded, evaluation of images was done by three radiologists according to 5-point Likert scale. Accuracy of the observers in sorting films according to dose reduction was determined with kappa coefficient. Mean values of image evaluation were determined. Pronounced deterioration of image quality for all criteria was observed between 80 and 28 mA. Adequate image quality was obtained at 40 mA [effective dose (E): 2.2 mSv, CTDI(w): 2.8 mGy] for criterion detailed definition of acetabulum and ISJ and at 80 mA (E: 4.4 mSv, CTDI(w): 5.6 mGy) for remaining criteria. Moderate agreement was observed between the three observers (kappa coefficient: 0.31). All observers were excellent in arranging images according to decreasing dose. Using 16-row MDCT image quality of pelvis is acceptable at 80 mA and 120 kV. This translates into a dose reduction of 33% of average value of the nationwide survey of the German Roentgen Society (1999) for this type of examination.

Acetabulum↗

PubMed2005

Accuracy of biopsy needle navigation using the Medarpa system--computed tomography reality superimposed on the site of intervention.

The aim of this work was to determine the accuracy of a new navigational system, Medarpa, with a transparent display superimposing computed tomography (CT) reality on the site of intervention. Medarpa uses an optical and an electromagnetic tracking system which allows tracking of instruments, the radiologist and the transparent display. The display superimposes a CT view of a phantom chest on a phantom chest model, in real time. In group A, needle positioning was performed using the Medarpa system. Three targets (diameter 1.5 mm) located inside the phantom were punctured. In group B, the same targets were used to perform standard CT-guided puncturing using the single-slice technique. The same needles were used in both groups (15 G, 15 cm). A total of 42 punctures were performed in each group. Post puncture, CT scans were made to verify needle tip positions. The mean deviation from the needle tip to the targets was 6.65+/-1.61 mm for group A (range 3.54-9.51 mm) and 7.05+/-1.33 mm for group B (range 4.10-9.45 mm). No significant difference was found between group A and group B for any target (p>0.05). No significant difference was found between the targets of the same group (p>0.05). The accuracy in needle puncturing using the augmented reality system, Medarpa, matches the accuracy achieved by CT-guided puncturing technique.

Biopsy, Needle↗