PubMed Health⌕ Search

Biomedical subjects

Jiamin Wan

Publications and source records attributed to Jiamin Wan.

9 recordsLinked to original sources

Uranium reduction in sediments under diffusion-limited transport of organic carbon.

Costly disposal of uranium (U) contaminated sediments is motivating research on in situ U(VI) reduction to insoluble U(IV) via directly or indirectly microbially mediated pathways. Delivery of organic carbon (OC) into sediments for stimulating U bioreduction is diffusion-limited in less permeable regions of the subsurface. To study OC-based U reduction in diffusion-limited regions, one slightly acidic and another calcareous sediment were treated with uranyl nitrate, packed into columns, then hydrostatically contacted with tryptic soy broth solutions. Redox potentials, U oxidation state, and microbial communities were well correlated. At average supply rates of 0.9 micromol OC (g sediment)(-1) day(-1), the U reduction zone extended to only about35-45 mm into sediments. The underlying unreduced U(VI) zone persisted over 600 days because the supply of OC was diffusion-limited and metabolized within a short distance. These results also suggestthat low U concentrations in groundwater samples from OC-treated sediments are not necessarily indicative of pervasive U reduction because interior and exterior regions of such sediment blocks can contain primarily U(VI) and U(IV), respectively.

Biodegradation, Environmental↗

Reoxidation of bioreduced uranium under reducing conditions.

Nuclear weapons and fuel production have left many soils and sediments contaminated with toxic levels of uranium (U). Although previous short-term experiments on microbially mediated U(VI) reduction have supported the prospect of immobilizing the toxic metal through formation of insoluble U(IV) minerals, our longer-term (17 months) laboratory study showed that microbial reduction of U can be transient, even under sustained reducing conditions. Uranium was reduced during the first 80 days, but later (100-500 days) reoxidized and solubilized, even though a microbial community capable of reducing U(VI) was sustained. Microbial respiration caused increases in (bi)-carbonate concentrations and formation of very stable uranyl carbonate complexes, thereby increasing the thermodynamic favorability of U(IV) oxidation. We propose that kinetic limitations including restricted mass transfer allowed Fe-(III) and possibly Mn(IV) to persist as terminal electron acceptors (TEAs) for U reoxidation. These results show that in-situ U remediation by organic carbon-based reductive precipitation can be problematic in sediments and groundwaters with neutral to alkaline pH, where uranyl carbonates are most stable.

Biodegradation, Environmental↗

Colloid formation at waste plume fronts.

Highly saline and caustic tank waste solutions containing radionuclides and toxic metals have leaked into sediments at U.S. Department of Energy (DOE) facilities such as the Hanford Site (Washington state). Colloid transport is frequently invoked to explain migration of radionuclides and metals in the subsurface. To understand colloid formation during interactions between highly reactive fluids and sediments and its impact on contaminant transport, we simulated tank waste solution (TWS) leakage processes in laboratory columns at ambient and elevated (70 degrees C) temperatures. We found that maximum formation of mobile colloids occurred at the plume fronts (hundreds to thousands times higher than within the plume bodies or during later leaching). Concentrations of suspended solids were as high as 3 mass %, and their particle sizes ranged from tens of nanometers to a few micrometers. Calcium carbonate is always one of the dominant phases of the plume front colloids, while the other phases varied with solution pH and temperature. During infiltration of the leaked high-Na+ waste solution, rapid and completed Na+ replacement of exchangeable Ca2+ and Mg2+ from the sediment caused accumulation of these divalent cations at the moving plume front. Precipitation of supersaturated Ca2+/Mg2+-bearing minerals caused dramatic pH reduction atthe plume front. In turn, the reduced pH caused precipitation of other minerals. This understanding can help predict the behavior of contaminant trace elements carried by the tank waste solutions and could not have been obtained through conventional batch studies.

Adsorption↗

Hexavalent uranium diffusion into soils from concentrated acidic and alkaline solutions.

Uranium contamination of soils and sediments often originates from acidic or alkaline waste sources, with diffusion being a major transport mechanism. Measurements of U(VI) diffusion from initially pH 2 and pH 11 solutions into a slightly alkaline Altamont soil and a neutral Oak Ridge soil were obtained through monitoring uptake from boundary reservoirs and from U concentration profiles within soil columns. The soils provided pH buffering, resulting in diffusion at nearly constant pH. Micro X-ray absorption near edge structure spectra confirmed that U remained in U(VI) forms in all soils. Time trends of U(VI) depletion from reservoirs and U(VI) concentration profiles within soil columns yielded Kdvalues consistent with those determined in batch tests at similar concentrations (approximately 1 mM) and much lower than values for sorption at much lower concentrations (nM to microM). These results show that U(VI) transport at high concentrations can be relatively fast at non-neutral pH, with negligible surface diffusion, because of weak sorption.

Adsorption↗

pH neutralization and zonation in alkaline-saline tank waste plumes.

At the Hanford Site in Washington State, the pH values of contaminant plumes resulting from leaking of initially highly alkaline-saline radioactive waste solutions into the subsurface are now found to be substantially neutralized. However, the nature of plume pH neutralization has not previously been understood. As a master geochemical variable, pH needs to be understood in order to predict the fate and transport of contaminants carried by the waste plumes. Through this laboratory study, we found that the plume pH values spanned a broad range from 14 (within the near-source region) down to the value of 7 (lower than the pH value of the initial soil solution) while the plume was still connected to an actively leaking source. We defined two zones within a plume: the silicate dissolution zone (SDZ, pH 14-10) and the neutralized zone (NZ, pH 10-7). Quartz dissolution at elevated temperature and precipitation of secondary silicates (including sodium metasilicate, cancrinite, and zeolites) are the key reactions responsible for the pH neutralization within the SDZ. The rapid and thorough cation exchange of Na+ replacing Ca2+/Mg2+, combined with transport, resulted in a dynamic Ca2+/Mg2+-enriched plume front. Subsequent precipitation of calcite, sodium silicate, and possibly talc led to dramatically reduced pH within the plume front and the neutralized zone. During aging (after the plume source became inactive), continued quartz dissolution and the secondary silicate precipitation drove the pH value lower, toward pH 11 at equilibrium within the SDZ, whereas the pH values in the NZ remained relatively unchanged with time. A pH profile of 11 from the plume source to pH 7 at the plume front is expected for a historical plume. This laboratory-based study provided realistic plume pH profiles (consistent with that measured from borehole samples) and identified underlying mechanisms responsible for pH evolution.

Environmental Monitoring↗

Influence of calcium carbonate on U(VI) sorption to soils.

The high stability of calcium uranyl carbonate complexes in the circumneutral pH range has a strong impact on U(VI) sorption in calcareous soils. To quantify this influence, sorption of U(VI) to soils in the presence of naturally occurring calcium carbonate was investigated by conducting batch experiments in which either U(VI) concentration or solution pH was varied. Two soils containing different calcium carbonate concentrations were selected, one from Oak Ridge, TN, and another from Altamont Pass, CA. The results show that the presence of calcium carbonate in soils strongly affects U(VI) sorption. Higher concentrations of soil calcium carbonate lead to a pronounced suppression of the pH-dependent sorption curve in the neutral pH range because of the formation of a very stable neutral complex of calcium uranyl carbonate in solution. A surface complexation model considering both strong and weak sites for ferrihydrite and ionizable hydroxyl sites for clay minerals was compared with experimental results, and U(VI) binding parameters were reasonably estimated. Fair agreement was found between the model predictions and sorption data, which span a wide range of U(VI) concentrations and pH. The results also show that appropriate solution-to-solid ratios need to be used when measuring distribution coefficients in calcareous soils to avoid complete CaCO3 dissolution and consequent dilution of calcium uranyl carbonate complexes.

Adsorption↗

Partitioning of clay colloids at air-water interfaces.

Colloid sorption onto air-water interfaces in a variety of natural environments has been previously recognized, but better quantification and understanding is still needed. Affinities of clay colloids for the air-water interface were measured using a bubble-column method and reported as partition coefficients (K). Four types of dilute clay suspensions were measured in NaCl solutions under varying pH and ionic strength conditions: kaolinite KGa-1, illite IMt-2, montmorillonite SWy-2, and bentonite. The K values of three types of polystyrene latex particles with different surface-charge properties were also measured for comparison. Kaolinite exhibited extremely high affinity to the air-water interface at pH values below 7. Illite has lower affinity to air-water interfaces than kaolinite, but has similar pH dependence. Na-montmorillonite and bentonite clay were found excluded from the air-water interface at any given pH and ionic strength. Positively and negatively charged latex particles exhibited sorption and exclusion, respectively, at the air-water interface. These results show the importance of electrostatic interactions between the air-water interface and colloids, especially the influence of pH-dependent edge charges, and influence of particle shape.

Journal Article↗

In situ reduction of chromium(VI) in heavily contaminated soils through organic carbon amendment.

Chromium has become an important soil contaminant at many sites, and facilitating in situ reduction of toxic Cr(VI) to nontoxic Cr(III) is becoming an attractive remediation strategy. Acceleration of Cr(VI) reduction in soils by addition of organic carbon was tested in columns pretreated with solutions containing 1000 and 10 000 mg L(-1) Cr(VI) to evaluate potential in situ remediation of highly contaminated soils. Solutions containing 0,800, or 4000 mg L(-1) organic carbon in the form of tryptic soy broth or lactate were diffused into the Cr(VI)-contaminated soils. Changes in Cr oxidation state were monitored through periodic micro-XANES analyses of soil columns. Effective first-order reduction rate constants ranged from 1.4 x 10(-8) to 1.5 x 10(-7) s(-1), with higher values obtained for lower levels of initial Cr(VI) and higher levels of organic carbon. Comparisons with sterile soils showed that microbially dependent processes were largely responsible for Cr(VI) reduction, except in the soils initially exposed to 10 000 mg L(-1) Cr(VI) solutions that receive little (800 mg L(-1)) or no organic carbon. However, the microbial populations (< or = 2.1 x 10(5) g(-1)) in the viable soils are probably too low for direct enzymatic Cr(VI) reduction to be important. Thus, synergistic effects sustained in whole soil systems may have accounted for most of the observed reduction. These results show that acceleration of in situ Cr(VI) reduction with addition of organic carbon is possible in even heavily contaminated soils and suggest that microbially dependent reduction pathways can be dominant.

Bacteria↗

Distribution of chromium contamination and microbial activity in soil aggregates.

Biogeochemical transformations of redox-sensitive chemicals in soils can be strongly transport-controlled and localized. This was tested through experiments on chromium diffusion and reduction in soil aggregates that were exposed to chromate solutions. Reduction of soluble Cr(VI) to insoluble Cr(II) occurred only within the surface layer of aggregates with higher available organic carbon and higher microbial respiration. Sharply terminated Cr diffusion fronts develop when the reduction rate increases rapidly with depth. The final state of such aggregates consists of a Cr-contaminated exterior, and an uncontaminated core, each having different microbial community compositions and activity. Microbial activity was significantly higher in the more reducing soils, while total microbial biomass was similar in all of the soils. The small fraction of Cr(VI) remaining unreduced resides along external surfaces of aggregates, leaving it potentially available to future transport down the soil profile. Using the Thiele modulus, Cr(VI) reduction in soil aggregates is shown to be diffusion rate- and reaction rate-limited in anaerobic and aerobic aggregates, respectively. Thus, spatially resolved chemical and microbiological measurements are necessary within anaerobic soil aggregates to characterize and predict the fate of Cr contamination. Typical methods of soil sampling and analyses that average over redox gradients within aggregates can erase important biogeochemical spatial relations necessary for understanding these environments.

Bacteria, Aerobic↗