Biomedical subjects

Jian Wen

Publications and source records attributed to Jian Wen.

3 recordsLinked to original sources

PubMed2006

DNA extraction using a tetramethyl orthosilicate-grafted photopolymerized monolithic solid phase.

A novel high-capacity, high-efficiency DNA extraction method is described using a photopolymerized silica-based monolithic column in a fused-silica capillary. Development involved investigation of the composition of the sol-gel monomer, fabrication conditions, and surface modifications in order to optimize the binding capacity. Extraction capacity and efficiency with the 3-(trimethoxysilyl)propyl methacrylate (TMSPM) monolith formulations fabricated in capillaries were investigated using a simple three-step procedure consisting of sample loading, washing of the solid phase, and elution of the DNA using a low ionic strength Tris buffer at pH 8. Once the TMSPM monomer concentration was optimized to yield a monolith with maximum test stability (robustness) and minimum back pressure, the monolith surface was modified by the grafting of tetramethyl orthosilicate (TMOS) for increased DNA binding capacity. After the examination of a variety of TMOS concentrations, 85% v/v TMOS was found to be optimal for DNA extraction without any obvious changes to the monolith structure. The reduction of time allowed for TMSPM hydrolysis prior to UV polymerization from 20 to 5 min led to a lower back pressure of the monolith, enabling better TMOS derivatization and therefore higher binding capacity. Minimal buffer volume (as low as 1 muL) was required to elute DNA from the solid phase, providing a DNA concentrating effect potentially important for downstream processes. While experimentation employed monolithic columns that were 12 cm in length, reduction of the length to 2 cm still allowed for a DNA binding capacity of at least 100 ng of prepurified human genomic DNA and extraction efficiencies greater than 85%. Extraction of low sample volumes (submicroliter) of human whole blood were successfully performed, with extraction efficiencies from the 2-cm monolithic column higher than those obtained from a commercial DNA extraction kit. These results position this novel matrix as an attractive alternative for solid-phase extraction of DNA and other biologically active molecules in microscale devices.

Blood↗

PubMed2003

Interaction between calcium-free calmodulin and IQ motif of neurogranin studied by nuclear magnetic resonance spectroscopy.

The interaction of Ca(2+)-free calmodulin (apoCaM) with the IQ motif corresponding to the calmodulin-binding domain of neurogranin has been studied by nuclear magnetic resonance (NMR) methods. The NMR spectra of uncomplexed apoCaM and apoCaM in complex with the IQ motif recorded at 750 MHz were studied and the backbone assignments of the protein in both forms were obtained by triple-resonance multidimensional NMR experiments. Chemical shift perturbations were used to map the binding surfaces. Only a single set of resonances was observed throughout the titration, indicating that the binding interaction is under fast exchange. Analysis of chemical shift changes indicates that (a) the main interaction and conformational changes occur in the C-terminal domain of calmodulin and (b) linker-1 (residues 40-44) between EF-1 and EF-2, linker-3 (residues 112-117) between EF-3 and EF-4, and the end of the alpha-helix H (residues 145-148) may be involved in the binding process. The dissociation constant (K(d)), estimated by fitting the chemical shift changes against the IQ peptide concentration, ranged from about 1.2 x 10(-5) to 8.8 x 10(-5) M. This result demonstrates that the interaction falls into the weak binding regime.

Amino Acid Motifs↗

PubMed2002

[A simple and convenient method for construction of gene site-directed mutagenesis].

OBJECTIVE: To introduce a new technique for rapid construction of gene site-directed mutagenesis. METHODS: Three primers are synthesized. One is a primer with the needed mutation; the other two containing appropriate enzyme sites for construction of the PCR fragment into a suitable plasmid are located at the flanks of the mutation primer. After the amplification of the PCR fragment using the mutation primer and the reverse flanking primer, another PCR is performed using the previous PCR mutation segment as primer and the other flanking primer. The final PCR segment can be cloned into an appropriate plasmid by using the enzyme sites in the primers. RESULTS: Two site-directed mutagenesis have been successfully constructed in the Parkin gene by this method. CONCLUSION: The method is effective and simple for construction of gene site-directed mutagenesis.

Base Sequence↗