Biomedical subjects
Publications and source records attributed to Jiangbo Yu.
The single-crystalline Sb2Te3 nanobelts were successfully synthesized by a novel and convenient surfactant-assisted hydrothermal approach. The ionic surfactant AOT acted as the shape controller in the synthetic process. We believe that this synthetic route could be applied to obtain other low-dimensional semiconducting telluride nanostructures.
A facile soft chemical approach using cetyltrimethylammonium bromide (CTAB) as template is successfully designed for synthesis of neodymium hydroxide nanotubes. These nanotubes have an average outer diameter around 20 nm, inner diameter around 2 nm, and length ranging from 100 to 120 nm, high BET surface area of 495.71 m(2) g(-1). We also find that neodymium hydroxide nanorods would be obtained when CTAB absented in reaction system. The Nd(OH)3 nanorods might act as precursors that are converted into Nd2O3 nanorods through dehydration at 550 degrees C. The nanorods could exhibit upconversion emission characteristic under excitation of 591 nm at room temperature.
A novel mesoporous SBA-15 type of hybrid material (phen-SBA-15) covalently bonded with 1,10-phenanthroline (phen) ligand was synthesized by co-condensation of tetraethoxysilane (TEOS) and the chelate ligand 5-[N,N-bis-3-(triethoxysilyl)propyl]ureyl-1,10-phenanthroline (phen-Si) in the presence of Pluronic P123 surfactant as a template. The preservation of the chelate ligand structure during the hydrothermal synthesis and the surfactant extraction process was confirmed by Fourier transform infrared (FTIR) and (29)Si MAS NMR spectroscopies. SBA-15 consisting of the highly luminescent ternary complex Eu(TTA)(3)phen (TTA = 2-thenoyltrifluoroacetone) covalently bonded to a silica-based network, which was designated as Eu(TTA)(3)phen-SBA-15, was obtained by introducing the Eu(TTA)(3).2H(2)O complex into the hybrid materials via a ligand exchange reaction. XRD, TEM, and N(2) adsorption measurements were employed to characterize the mesostructure of Eu(TTA)(3)phen-SBA-15. For comparison, SBA-15 doped with Eu(TTA)(3).2H(2)O and Eu(TTA)(3)phen complexes and SBA-15 covalently bonded with a binary europium complex with phen ligand were also synthesized, and were named SBA-15/Eu(TTA)(3), SBA-15/Eu(TTA)(3)phen, and Eu-phen-SBA-15, respectively. The detailed luminescence studies on all the materials showed that, compared with the doping sample SBA-15/Eu(TTA)(3)phen and binary europium complex functionalized sample Eu-phen-SBA-15, the Eu(TTA)(3)phen-SBA-15 mesoporous hybrid material exhibited higher luminescence intensity and emission quantum efficiency. Thermogravimetric analysis on Eu(TTA)(3)phen-SBA-15 demonstrated that the thermal stability of the lanthanide complex was evidently improved as it was covalently bonded to the mesoporous SBA-15 matrix.
The syntheses, structures, and electroluminescent properties are described for two new lanthanide complexes Ln(HFNH)3phen [HFNH = 4,4,5,5,6,6,6-heptafluoro-1-(2-naphthyl)hexane-1,3-dione; phen = 1,10-phenanthroline; Ln = Eu3+ (1), Sm3+ (2)]. Both complexes exhibit bright photoluminescence at room temperature (RT) due to the characteristic emission of Eu3+ and Sm3+ ion. Several devices using the two complexes as emitters were fabricated. The performances of these devices are among the best reported for devices using europium complex and samarium complex as emitters. The device based on 1 with the structure ITO/TPD (50 nm)/1:CBP (10%, 40 nm)/BCP (20 nm)/AlQ (30 nm)/LiF (1 nm)/Al (200 nm) exhibits the maximum brightness of 957 cd/m2, current efficiency of 4.14 cd/A, and power efficiency of 2.28 lm/W with a pure red Eu3+ ion emission. Especially, at the high brightness of 200 cd/m2, the device of 1 still has a high current efficiency of 2.15 cd/A. The device of 2 with a three-layer structure of ITO/TPD (50 nm)/2 (50 nm)/BCP (20 nm)/LiF (1 nm)/Al (200 nm) gives the maximum brightness of 42 cd/m2, current efficiency of 0.18 cd/A. By the comparison of the electroluminescent properties of devices based on Eu(TTA3phen (TTA = 2-thenoyltrifluoroacteonate) and 1, we conclude that the polyfluoration on the alkyl group of the ligand and the introduction of the long conjugate naphthyl group into the ligand improve the efficiency of 1-doped devices, especially at high current densities.
Explore the source record for details and available documents.