PubMed Health⌕ Search

Biomedical subjects

Jimmy Lätt

Publications and source records attributed to Jimmy Lätt.

4 recordsLinked to original sources

Denoising of complex MRI data by wavelet-domain filtering: application to high-b-value diffusion-weighted imaging.

The Rician distribution of noise in magnitude magnetic resonance (MR) images is particularly problematic in low signal-to-noise ratio (SNR) regions. The Rician noise distribution causes a nonzero minimum signal in the image, which is often referred to as the rectified noise floor. True low signal is likely to be concealed in the noise, and quantification is severely hampered in low-SNR regions. To address this problem we performed noise reduction (or denoising) by Wiener-like filtering in the wavelet domain. The filtering was applied to complex MRI data before construction of the magnitude image. The noise-reduction algorithm was applied to simulated and experimental diffusion-weighted (DW) images. Denoising considerably reduced the signal standard deviation (SD, by up to 87% in simulated images) and decreased the background noise floor (by approximately a factor of 6 in simulated and experimental images).

Algorithms↗

Magnetic resonance imaging artifacts caused by aneurysm clips and shunt valves: dependence on field strength (1.5 and 3 T) and imaging parameters.

PURPOSE: To evaluate artifact sizes at 3 T compared to at 1.5 T, and to evaluate the influence of scanning parameters with respect to artifact size on a 3-T magnetic resonance imaging (MRI) system. MATERIALS AND METHODS: Two aneurysm clips and five shunt valves were imaged in a water phantom at 1.5 and 3 T. At 3 T the influence of bandwidth (spin echo (SE) images) and echo time (gradient echo (GRE) images) on artifact size (area and extension in two orthogonal directions) was investigated. RESULTS: Artifact sizes increased substantially (typically 5-10 mm) at 3 T, compared to at 1.5 T, for implants entirely made of metallic materials, whereas the increase was the size less prominent (0-5 mm) for implants only partly containing metal. Artifact areas could be altered by changing the bandwidth or the echo time to about the same extent as it was affected by the increased field strength. CONCLUSION: Artifact sizes increase at 3 T, compared to at 1.5 T, depending on the type and composition of the implant, but can be substantially reduced by altering the imaging parameters. Optimization of imaging protocols to minimize artifacts is therefore important at higher field strengths.

Artifacts↗

MRI with diffusion tensor imaging post-mortem at 3.0 T in a patient with frontotemporal dementia.

The formalin-fixed brain of a patient with clinically diagnosed frontotemporal dementia (FTD) was examined post-mortem using magnetic resonance imaging (MRI) with diffusion tensor imaging (DTI) at 3.0 T. Frontotemporal atrophy as well as bilateral frontal white matter abnormalities were seen. The white matter changes were slightly more extensive on DTI than on conventional MRI. Correlation with histopathology of the corresponding regions revealed typical frontal lobe degeneration of non-Alzheimer type, with mild frontotemporal degeneration in the outer cortical layers and a moderate frontal white matter gliosis with demyelination. Post-mortem MRI/DTI with histopathologic correlation will enhance our understanding of the basis of white matter changes observed in dementia patients and may improve the in vivo MRI/DTI diagnostic assessment in FTD.

Aged↗