PubMed Health⌕ Search

Biomedical subjects

Jin-feng Peng

Publications and source records attributed to Jin-feng Peng.

4 recordsLinked to original sources

Equilibrium sampling of freely dissolved alkylphenols into a thin film of 1-octanol supported on a hollow fiber membrane.

A new negligible depletion extraction procedure was proposed for equilibrium sampling of 4-tert-octylphenol (OP) and 4-nonylphenol (NP) into a thin film of 1-octanol supported on a hollow fiber membrane. This thin liquid film extraction technique was directed at the determination of (1) freely dissolved concentrations, (2) distribution coefficients to 1-octanol (D(ow)), and (3) binding to dissolved organic matter (DDOC). The sampling device was prepared by dipping pieces of polypropylene microporous hollow fiber membrane (10-mm length, 30-microm wall thickness, 240-microm inner diameter) into 1-octanol for a few seconds to impregnate the pores of the hollow fiber wall. After stirring in 100 mL of sample solution for 24 h, the sampling device was harvested and desorbed with 30 microL of methanol, of which 20 microL was injected for HPLC analysis. With the measured D(ow) of a chemical and its equilibrium concentration in the 1-octanol sampling phase (C(octanol)), the freely dissolved concentration (Cfree) was calibrated based on Cfree = C(octanol)/D(ow). Measured log Dow values of OP (4.32 +/- 0.06) and NP (4.79 +/- 0.02) were independent of the chemical concentration, only minimally affected by the environmentally relevant pH, buffering capacity, and salinity of samples, and agreed well with reported values. Log DDOC values of OP (4.89 +/- 0.43) and NP (5.14 +/- 0.37), determined in Aldrich humic acid solution, agreed with reported partition coefficients to organic carbon (log Koc) for particles in river water and effluent wastewater. Short equilibration times and high enrichment factors were obtained for both analytes due to the high surface to volume ratio of the new sampler. The technique was successfully applied to determine Cfree of OP and NP in real water samples and to study their association with humic acids and bovine albumin.

Journal Article↗

Evaluating the impacts of some environmentally relevant factors on the availability of bisphenol A with negligible-depletion SPME.

The effect of some environmentally relevant factors including salinity, pH, and humic acids on the availability of bisphenol A (BPA) was evaluated by using the negligible-depletion solid-phase microextraction (nd-SPME) biomimetic method. With the variation of salinity (0-500 mM NaCl) and pH (5.0-8.5) of aqueous solutions, the partition coefficients of BPA between the nd-SPME fiber and the aqueous solution varied in the range of logD=3.55-3.86, which indicates that the salinity and pH can influence the availability of BPA. By using Acros humic acid as model dissolved organic matter (DOM), it was also demonstrated that the environmental factors such as salinity and pH could affect the partitioning of BPA between DOM and aqueous solutions. The determined partition coefficients of BPA between dissolved organic carbon (DOC) and aqueous solutions were in the range of logD(DOC)=4.03-5.60 for Acros humic acid solutions with 1-50 mg l(-1) DOC. The influence of salinity and pH on logD(DOC) was more significant at low concentration (0-5 mg l(-1)) of DOC.

Benzhydryl Compounds↗

Ionic liquid for high temperature headspace liquid-phase microextraction of chlorinated anilines in environmental water samples.

Based on the non-volatility of room temperature ionic liquids (IL), 1-butyl-3-methylimidazolium hexafluorophosphate ([C4MIM][PF6]) IL was employed as an advantageous extraction solvent for high temperature headspace liquid-phase microextraction (LPME) of chloroanilines in environmental water samples. At high temperature of 90 degrees C, 4-chloroaniline, 2-chloroaniline, 3,4-dichloroaniline, and 2,4-dichloroaniline were extracted into a 10 microl drop of [C4MIM][PF6] suspended on the needle of a high-performance liquid chromatography (HPLC) microsyringe held at the headspace of the samples. Then, the IL was injected directly into the HPLC system for determination. Parameters related to LPME were optimized, and high selectivity and low detection limits of the four chlorinated anilines were obtained because the extraction was performed at high temperature in headspace mode and the very high affinity between IL and chlorinated anilines. The proposed procedure was applied for the analysis of the real samples including tap water, river water and wastewater samples from a petrochemical plant and a printworks, and only 3,4-dichloroaniline was detected in the printworks wastewater at 88.2 microg l(-1) level. The recoveries for the four chlorinated anilines in the four samples were all in the range of 81.9-99.6% at 25 microg l(-1) spiked level.

Aniline Compounds↗

Ionic liquid-based liquid-phase microextraction, a new sample enrichment procedure for liquid chromatography.

Room temperature ionic liquids (RTILs) were used as extraction solvent in liquid-phase microextraction (LPME) coupled with liquid chromatography. Using 1-hexyl-3-methylimidazolium hexafluorophosphate ([C6MIM][PF6]) as extraction solvent, some parameters related to LPME of 4-nonylphenol (4-NP) and 4-tert-octylphenol (4-t-OP) were optimized. Although [C6MIM][PF6] can suspend a much larger volume of drop on the needle of the microsyringe than the conventional solvents such as 1-octanol and carbon tetrachloride, the method sensitivity was analyte dependent because of the different partition coefficients and the relatively large viscosity of [C6MIM][PF6]. The proposed procedure has a detection limit and enrichment factor of 0.3 microg l(-1) and 163 for 4-NP, and 0.7 microg l(-1) and 130 for 4-t-OP, respectively. Aqueous samples including tap water, river water, and effluent from sewage treatment plant were analyzed by the proposed method and the recoveries at 10 microg l(-1) spiked level were in the range of 90-113%.

Chromatography, High Pressure Liquid↗